980
11028E–ATARM–22-Apr-13
SAM9G46
42.4.5
Programming a Channel
Four registers, the DMAC_DSCRx, the DMAC_CTRLAx, the DMAC_CTRLBx and
DMAC_CFGx, need to be programmed to set up whether single or multi-buffer transfers take
place, and which type of multi-buffer transfer is used. The different transfer types are shown in
The “BTSIZE, SADDR and DADDR” columns indicate where the values of DMAC_SARx,
DMAC_DARx, DMAC_CTLx, and DMAC_LLPx are obtained for the next buffer transfer when
multi-buffer DMAC transfers are enabled.
42.4.5.1
Programming Examples
42.4.5.2
Single-buffer Transfer (Row 1)
1.
Read the Channel Handler Status Register DMAC_CHSR.ENABLE Field to choose a
free (disabled) channel.
2.
Clear any pending interrupts on the channel from the previous DMAC transfer by read-
ing the interrupt status register, DMAC_EBCISR.
3.
Program the following channel registers:
a.
Write the starting source address in the DMAC_SADDRx register for channel x.
b.
Write the starting destination address in the DMAC_DADDRx register for channel
x.
c.
Program DMAC_CTRLAx, DMAC_CTRLBx and DMAC_CFGx according to Row 1
both DST_DSCR and SRC_DSCR fields set to one and AUTO field set to 0.
d.
Write the control information for the DMAC transfer in the DMAC_CTRLAx and
DMAC_CTRLBx registers for channel x. For example, in the register, you can pro-
gram the following:
– i. Set up the transfer type (memory or non-memory peripheral for source and
destination) and flow control device by programming the FC of the DMAC_CTRLBx
register.
– ii. Set up the transfer characteristics, such as:
– Transfer width for the source in the SRC_WIDTH field.
– Transfer width for the destination in the DST_WIDTH field.
– Source AHB Master interface layer in the SIF field where source resides.
– Destination AHB Master Interface layer in the DIF field where destination resides.
– Incrementing/decrementing or fixed address for source in SRC_INC field.
– Incrementing/decrementing or fixed address for destination in DST_INC field.
e.
Write the channel configuration information into the DMAC_CFGx register for chan-
nel x.
– i. Designate the handshaking interface type (hardware or software) for the source
and destination peripherals. This is not required for memory. This step requires
programming the SRC_H2SEL/DST_H2SEL bits, respectively. Writing a ‘1’ activates
the hardware handshaking interface to handle source/destination requests. Writing a
‘0’ activates the software handshaking interface to handle source/destination
requests.