- 您現在的位置：買賣IC網 > PDF目錄371134 > MPC8240EC (Motorola, Inc.) Integrated Processor Hardware Specifications PDF資料下載
參數資料
| 型號： | MPC8240EC |
| 廠商： | Motorola, Inc. |
| 英文描述： | Integrated Processor Hardware Specifications |
| 中文描述： | 綜合處理器硬件規格 |
| 文件頁數： | 46/52頁 |
| 文件大?。?/td> | 1027K |
| 代理商： | MPC8240EC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁當前第46頁第47頁第48頁第49頁第50頁第51頁第52頁
46
MPC8240 Integrated Processor Hardware Specifications
For More Information On This Product,
Go to: www.freescale.com
MOTOROLA
Document Revision History
0.3
Removed “PowerPC Platform compliant” from first sentence on cover sheet.
Changed PCI 2.1—’compatible’ to ‘compliant’ in Section 1.2.
Updated Table 5 and its notes with preliminary power-consumption information.
Updated Table 6, removing 266 MHz frequency information.
Made corrections to Table 7.
Items 5a and 5b were changed to correct values for 66-MHz PCI_SYNC_IN.
OSC_IN Frequency Stability spec from 1000 to 100 ppm.
Table 9:
Changed item 12b1 from 8.0 to 7.0 ns.
Added item 12b3, Output Valid for ROM accesses.
Table 11, item 2, “KAHLUA” terminology replaced with MPC8240.
Added EPIC Serial Interrupt Timing Section with two new figures, causing cross-references to
subsequent figures to be updated.
Updated formatting of pin out in Table 17.
Modified notes section in Table 17:
Split Note 3 into new Notes 3 and 12. Notes 3, 5, and 7 cover internal pull-up resistors active only
during the reset state. Note 12 covers internal pull-up resistors enabled at all times.
Note 11 has been revised.
Added Note 10 to SDA and SCL signals for consistency with theMPC8240 User’s Manual.
Added Note 10 to SMI and TBEN; inputs that should have pull-ups and for consistency with reference
designs.
Added Note 10 to SRESET and CHKSTOP_IN for consistency with Figure 23 (COP Connector)
Added Notes 13 and 14 for output valid specifications dependent upon memory mode.
Added Note 15 for pins affected by programmable PCI output valid and hold time.
Added Notes 16 –18 relating to open drain pins.
Figure 18:
Revised 200-MHz column to reflect PCI_SYNC_IN 66-MHz upper limit.
Refs 1E and 1F not usable entries made to match others in the table.
Revised Notes 4 and 5 changing OSC_IN to PCI_SYNC_IN.
Removed 266-MHz column.
Removed Ref 0x06 for dual PLL bypass mode; added it to reserved list in Note 3.
Revised Note 4 describing PLL bypass mode.
Added missing cross-reference in Section 1.7.2 and corrected Schottky reference to the 1N5820 diodes.
Added Section 1.7.2 on power supply sizing.
Modified internal pull-up resistor list in Section 1.7.5 to be consistent with Notes of Table 17; added reset
configuration pin pull-down resistor value recommendation.
Modified Figure 23, COP connector diagram:
Reversed direction of CKSTP_IN arrow to show it going in.
Added a pull-up resistor on TRST.
Changed R-spec device’s V
DD
range from 2.5–2.625 V to 2.5–2.75 V.
Modified DLL Lock Range with DLL_EXTEND = 1 equation in Table 7 from 0
≤
(NT
clk
/2 – t
loop
– t
fix0
)
≤
7
to 0
≤
(NT
clk
– T
clk
/2 – t
loop
– t
fix0
)
≤
7.
Modified Figure 5 to only show T
loop
up to 15 ns, not practical to implement T
loop
beyond 15 ns.
Modified DL[0:31] and DH[0:31] signal names to MDL[0:31] and MDH[0:31], respectively, in Table 17 to
be consistent with the Tundra Tsi107 PowerPC host bridge data bus naming convention.
Several active low signal names in Table 17 inadvertently had the overline formatting removed during the
final edit process of the previous revision. The signals are shown correctly with overlines in this version.
Signals affected were: DEVSEL, FRAME, LOCK, PERR, SERR, STOP, TRDY, INTA, FOE, RCS0, RCS1,
SDRAS, SDCAS, WE, AS, HRST_CTRL, HRST_CPU, MCP, SMI, SRESET, CHKSTOP_IN, and MIV.
0.4
Table 19. Document Revision History (continued)
Revision
Number
Substantive Change(s)
F
Freescale Semiconductor, Inc.
n
.
相關PDF資料 |
PDF描述 |
|---|---|
| MPC8240 | 32-Bit Microprocessor(32位微處理器) |
| MPC8260ACZU | MPC826xA (HiP4) Family Hardware Specifications |
| MPC8260CZU | MPC826xA (HiP4) Family Hardware Specifications |
| MPC8264ACZU | MPC826xA (HiP4) Family Hardware Specifications |
| MPC8264AZU | MPC826xA (HiP4) Family Hardware Specifications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPC8241 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Intergrated Processor Hardware Specifications |
| MPC8241EC | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:MPC8241 Integrated Processor Hardware Specifications |
| MPC8241LVR166D | 功能描述:微處理器 - MPU INTEGRATED HOST PROC RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC8241LVR200D | 功能描述:微處理器 - MPU INTEGRATED HOST PROC RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC8241LVR266D | 功能描述:微處理器 - MPU INTEGRATED HOST PROC RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
發布緊急采購，3分鐘左右您將得到回復。