- 您現在的位置：買賣IC網 > PDF目錄383644 > MT90220 (Mitel Networks Corporation) Octal IMA/UNI PHY Device(八端口 IMA/UNI 物理層設備（八端口ATM IMA和UNI處理器）) PDF資料下載
參數資料
| 型號： | MT90220 |
| 廠商： | Mitel Networks Corporation |
| 英文描述： | Octal IMA/UNI PHY Device(八端口 IMA/UNI 物理層設備（八端口ATM IMA和UNI處理器）) |
| 中文描述： | 八路IMA的/單向物理層設備（八端口IMA的/單向物理層設備（八端口自動柜員機IMA的和單向處理器）） |
| 文件頁數： | 16/118頁 |
| 文件大?。?/td> | 310K |
| 代理商： | MT90220 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁
MT90220
8
1.0 Device Architecture
The MT90220, supported by software, implements
the
ATM
Forum
Inverse
Asynchronous Transfer Mode (IMA) Specification.
This approach minimizes the impact of any changes
that might occur in the specification. Actions are
implemented by the MT90220 and decisions by the
software.
Multiplexing
for
The MT90220 supports following two major modes of
operation:
the IMA mode (as defined by the ATM Forum
IMA Specification)
the User Network Interface (UNI) mode
Up to four IMA Groups can be implemented. Any of
the eight PCM Interfaces can be assigned
dynamically to any of these IMA Groups. A different
UTOPIA PHY address is assigned to each of the IMA
Groups.
The UNI mode is used to transfer the cells from the
UTOPIA Interface to a PCM port without any
overhead. Up to 8 UTOPIA PHY addresses can be
supported in UNI mode.
The MT90220 also supports a mixed mode where
the PCM Interfaces not assigned to an IMA Group
can be used in UNI mode.
The IMA implementation is divided into hardware
and software functions. The MT90220 implements
the hardware functions. The software functions are
implemented by the user. The hardware and
software functions are described below. Notice that a
number of MT90220 functions are included to assist
in the collection of statistical information. This
information supports the MIB implementation.
1.1
For the MT90220 to comply with the IMA
specification, the following functions must be
implemented by software:
the transmit and receive Link State Machines
(LSM)
the IMA Group State Machines (GSM)
the IMA Group Traffic State Machines (GTSM)
the Operations and Maintenance (OAM)
functions
Software Functions
1.1.1
The software implemented transmit and receive
LSMs are independent (i.e., each link has its own
LSM). LSMs rely on various events from the
Link State Machines
MT90220 interface, such as cell errors, excessive
delay between-links, etc.; or, from the T1 or E1
framer, such as Loss Of Signal (LOS), Loss Of
Frame (LOF), Remote Alarm Indication (RAI) etc.
On-chip registers are used to generate the ICP cells
that communicate the LSM states to the Far End
(FE).
1.1.2
The IMA GSMs and Group Traffic State Machines
(GTSM) must be implemented in software. One of
each state machine should be implemented for each
IMA Group.
IMA Group State Machines
On-chip registers are used to generate the ICP cells
that communicate the various states to the FE.
1.1.3
The addition, removal or restoration of a link is
controlled by software using the various control
registers in the MT90220 and in the T1 or E1
framers. Decisions are based on the MT90220 and
T1 or E1 framers status registers.
Link Addition, Removal or Restoration
1.1.4
The MT90220 provides numerous registers and
counters to implement a polling and/or interrupt
mechanism for tracking link and IMA Group status.
This traffic in and out information is used by the
Management Information Base (MIB) for each IMA
Group.
Interrupt
1.1.5
The microprocessor controls the operation of the T1
or E1 link by providing handshaking between the FE
and Near Ends (NE) including such functions as
signaling and loopback controls. Rate adjustment is
controlled by:
Signaling and Rate Adjustment
adding or removing one or more T1 or E1 links
providing feedback to the ATM network for adjust-
ing the ATM traffic.
1.1.6
Software implements most of the performance
monitoring.
The
MT90220
information for:
the Cell Delineation Block and IMA Frame State
Machine
the number of ICP violations
the total number of cells
the number of idle or discarded cells.
Performance Monitoring
provides
status
相關PDF資料 |
PDF描述 |
|---|---|
| MT90221 | Quad IMA/UNI PHY Device(四端口 IMA/UNI 物理層設備（四端口ATM IMA和UNI處理器）) |
| MT90401 | SONET/SDH System Synchronizer(SONET/SDH 系統同步裝置（由一個數字鎖相環組成）) |
| MT9040 | T1/E1 Synchronizer(T1/E1 系統同步裝置（由一個數字鎖相環組成）) |
| MT9041A | () |
| MT9041B | T1/E1 System Synchronizer(T1/E1系統同步裝置（由一個數字鎖相環組成）) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT90220AL | 制造商:Zarlink Semiconductor Inc 功能描述:I.C. |
| MT90220ALX01 | 制造商:Mitel Networks Corporation 功能描述: |
| MT90221 | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:Quad IMA/UNI PHY Device |
| MT90221AL | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:Quad IMA/UNI PHY Device |
| MT90222 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:4/8/16 Port IMA/TC PHY Device |
發布緊急采購，3分鐘左右您將得到回復。