- 您現在的位置：買賣IC網 > PDF目錄370021 > PSD813F3V 60V 100kRad Hi-Rel Single P-Channel TID Hardened MOSFET in a UB Surface Mount package; Similar to IRHLUB7970Z4 with optional Total Dose Rating of 300kRads PDF資料下載
參數資料
| 型號： | PSD813F3V |
| 英文描述： | 60V 100kRad Hi-Rel Single P-Channel TID Hardened MOSFET in a UB Surface Mount package; Similar to IRHLUB7970Z4 with optional Total Dose Rating of 300kRads |
| 中文描述： | Flash在系統編程（ISP）外設的8位微控制器 |
| 文件頁數： | 62/103頁 |
| 文件大?。?/td> | 1185K |
| 代理商： | PSD813F3V |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁當前第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁
PSD81XFX, PSD83XF2, PSD85XF2
62/103
SRAM Standby Mode (Battery Backup).
The
PSD8XXFX supports a battery backup mode in
which the contents of the SRAM are retained in the
event of a power loss. The SRAM has Voltage
Stand-by (V
STBY
, PC2) that can be connected to
an external battery. When V
CC
becomes lower
than V
STBY
then the PSD8XXFX automatically
connects to Voltage Stand-by (V
STBY
, PC2) as a
power source to the SRAM. The SRAM Standby
Current (I
STBY
) is typically 0.5 μA. The SRAM data
retention voltage is 2 V minimum. The Battery-on
Indicator (VBATON) can be routed to PC4. This
signal indicates when the V
CC
has dropped below
V
STBY
.
PSD Chip Select Input (CSI, PD2)
PD2 of Port D can be configured in PSDsoft Ex-
press as PSD Chip Select Input (CSI). When Low,
the signal selects and enables the internal Flash
memory, EEPROM, SRAM, and I/O blocks for
READ or WRITE operations involving the
PSD8XXFX. A High on PSD Chip Select Input
(CSI, PD2) disables the Flash memory, EEPROM,
and SRAM, and reduces the PSD8XXFX power
consumption. However, the PLD and I/O signals
remain operational when PSD Chip Select Input
(CSI, PD2) is High.
There may be a timing penalty when using PSD
Chip Select Input (CSI, PD2) depending on the
speed grade of the PSD8XXFX that you are using.
See the timing parameter t
SLQV
in Table 60 or Ta-
ble 61.
Input Clock
The PSD8XXFX provides the option to turn off
CLKIN (PD1) to the PLD to save AC power con-
sumption. CLKIN (PD1) is an input to the PLD
AND Array and the Output Macrocells (OMC).
During Power-down mode, or, if CLKIN (PD1) is
not being used as part of the PLD logic equation,
the clock should be disabled to save AC power.
CLKIN (PD1) is disconnected from the PLD AND
Array or the Macrocells block by setting bits 4 or 5
to a 1 in PMMR0.
Input Control Signals
The PSD8XXFX provides the option to turn off the
input control signals (CNTL0, CNTL1, CNTL2, Ad-
dress Strobe (ALE/AS, PD0) and DBE) to the PLD
to save AC power consumption. These control sig-
nals are inputs to the PLD AND Array. During
Power-down mode, or, if any of them are not being
used as part of the PLD logic equation, these con-
trol signals should be disabled to save AC power.
They are disconnected from the PLD AND Array
by setting bits 2, 3, 4, 5, and 6 to a 1 in PMMR2.
Table 32. APD Counter Operation
APD Enable Bit
ALE PD Polarity
ALE Level
APD Counter
0
X
X
Not Counting
1
X
Pulsing
Not Counting
1
1
1
Counting (Generates PDN after 15 Clocks)
1
0
0
Counting (Generates PDN after 15 Clocks)
相關PDF資料 |
PDF描述 |
|---|---|
| PSD813F4V | -200V 100kRad Hi-Rel Single P-Channel TID Hardened MOSFET in a SMD-2 package; A IRHNA597260 with Standard Packaging |
| PSD813F5V | -60V 100kRad Hi-Rel Single P-Channel TID Hardened MOSFET in a SMD-2 package; Similar to IRHNA9064 with optional Total Dose Rating of 300kRads |
| PSD86 | THREE PHASE RECTIFIER BRIDGE |
| PSF101 | WORLD MAGNETICS ULTRA SENSITIVEPRESSURESWITCHES |
| PSG61 | 4 KEY BI-BI CALL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PSD813F3V-12 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Flash In-System Programmable (ISP) Peripherals for 8-bit MCUs, 5V |
| PSD813F3V-12J | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Flash In-System Programmable ISP Peripherals For 8-bit MCUs |
| PSD813F3V-12JI | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Flash In-System Programmable ISP Peripherals For 8-bit MCUs |
| PSD813F3V-12JIT | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Flash In-System Programmable ISP Peripherals For 8-bit MCUs |
| PSD813F3V-12JT | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Flash In-System Programmable ISP Peripherals For 8-bit MCUs |
發布緊急采購，3分鐘左右您將得到回復。