參數資料
型號: SI5315-EVB
廠商: Silicon Laboratories Inc
文件頁數: 33/54頁
文件大小: 0K
描述: BOARD EVAL SI5315 8KHZ-644.53MHZ
應用說明: SI5315/17 Crystal Selection AppNote
標準包裝: 1
主要目的: 計時,時鐘乘法器
嵌入式:
已用 IC / 零件: SI5315
主要屬性: 2 輸入,2 輸出
次要屬性: CML,CMOS,LVDS,LVPECL
已供物品: 板,CD,文檔
Si5315
Rev. 1.0
39
7.1. Crystal/Reference Clock Selection
The Si5315 requires either a low-jitter external oscillator or a low-cost fundamental mode crystal to be connected to
its XA/XB pins. This serves both as a jitter reference for jitter attenuation and as a reference oscillator for stability
during holdover. The frequency the reference is not directly related to either the input or the output clock
frequencies. The range of the reference frequency is from 37 to 41 MHz. For recommendations on the selection of
the reference frequency and a list of approved crystals, see the application note AN591 which can be downloaded
In holdover, the DSPLL remains locked to this external reference. Any changes in the frequency of this reference
when the DSPLL is in holdover will be tracked by the output of the device. Note that crystals can have temperature
sensitivities. Table 18 shows how the XTAL/CLOCK pin is used to select between a crystal and an external
oscillator.
Because the crystal is used as a jitter reference, rapid changes of the crystal temperature can temporarily disturb
the output phase and frequency. For example, it is recommended that the crystal not be placed close to a fan that
is being turned off and on. If a situation such as this is unavoidable, the crystal should be thermally isolated with an
insulating cover.
7.1.1. Reference Drift
During holdover, long-term and temperature related drift of the reference input result in a one-to-one drift of the
output frequency. That is, the stability of the any-frequency output is identical to the drift of the reference frequency.
This means that for the most demanding applications where the drift of a crystal is not acceptable, an external
temperature compensated or ovenized oscillator will be required. Drift is not an issue unless the part is in holdover.
Also, the initial accuracy of the reference oscillator (or crystal) is not relevant.
Table 18. XA/XB Reference Sources
XTAL/CLOCK
Type
M
37–41 MHz external clock
L
40 MHz crystal
相關PDF資料
PDF描述
CB5016-000 HEAT SHRINK TUBING
ESC08DRTN-S93 CONN EDGECARD 16POS DIP .100 SLD
ESC13DRYH-S13 CONN EDGECARD 26POS .100 EXTEND
ESC05DRES-S734 CONN EDGECARD 10POS .100 EYELET
VE-24L-EX CONVERTER MOD DC/DC 28V 75W
相關代理商/技術參數
參數描述
SI5315-H 制造商:KODENSHI 制造商全稱:KODENSHI KOREA CORP. 功能描述:Colorless transparency lens type
SI5315-H(B) 制造商:AUK 制造商全稱:AUK corp 功能描述:IRED
SI5315-H_1 制造商:AUK 制造商全稱:AUK corp 功能描述:IRED
SI5315-HB 制造商:AUK 制造商全稱:AUK corp 功能描述:IRED
SI5316 制造商:SILABS 制造商全稱:SILABS 功能描述:PRELIMINARY DATA SHEET PRECISION CLOCK JITTER ATTENUATOR