參數資料
型號: μPD29F008AL-X
廠商: NEC Corp.
英文描述: 8 M-Bit CMOS Low Voltage Flash Memory(8M CMOS低壓閃存)
中文描述: 8 m位的CMOS低電壓快閃記憶體(800萬的CMOS低壓閃存)
文件頁數: 17/44頁
文件大?。?/td> 249K
代理商: ΜPD29F008AL-X
Preliminary Data Sheet
17
μ
PD29F008AL-X
Figure 4-3. Sector / Chip Erase Timing Chart
Note
SA is the sector address of the sector to be erased. For chip erase, input 555H.
4.7 Erase Suspend / Resume
This command suspends automatic erase. During erase suspend, sectors for which erase is not performed can be
written to.
Suspend can be performed for sector erase (including the timeout period), but it cannot be performed for chip erase
and automatic program. Suspend can be performed for all sectors for which erase is being performed.
Following command sequence write, 20
μ
s are required until automatic erase is suspended.
While automatic erase is suspended, any sector for which erase is not being performed can be read and
programmed.
Whether automatic erase is suspended can be determined with the hardware sequence flags (I/O7, I/O6, I/O2 pins).
See sections
5.1 I/O7 (Data Polling)
,
5.2 I/O6 (Toggle Bit)
, and
5.3 I/O2 (Toggle Bit II)
.
To resume erase after it has been suspended, write the command (30H) again during erase suspend.
4.8 Unlock Bypass
This device provides an unlock bypass mode to shorten the write time.
Normally, 2 unlock cycles are required during program. In contrast, with the unlock bypass mode, it is possible to
perform program without unlock cycles.
In the unlock bypass mode, all commands except unlock bypass program and unlock bypass reset are ignored.
4.8.1 Unlock Bypass Set
This command sets the device to the unlock bypass mode.
4.8.2 Unlock Bypass Program
This command is used to perform program in the unlock bypass mode.
4.8.3 Unlock Bypass Reset
This command is used to quit the unlock bypass mode.
When this command is executed, the device returns to the read mode.
Address (Input)
/CE (Input)
/OE (Input)
/WE (Input)
I/O (Input)
V
CC
t
DS
t
DH
t
CH
t
CS
t
WPH
555H
t
WC
t
AS
t
AH
t
WP
55H
AAH
80H
AAH
55H
(10H for chip erase)
30H
2AAH
555H
555H
2AAH
SA
Note
t
GHWL
t
VCS
相關PDF資料
PDF描述
μPD29F008L 8 M-Bit CMOS 3.0 V-Only Flash Memory(8M CMOS 3V工作電壓的閃存)
μPD30100 64-bit RISC Microprosessor(64位 RISC 微處理器)
μPD30101 64-Bit Microprocessor(64位微處理器)
μPD30102 64-/32-BIT Microprocessor(64/32位微處理器)
μPD30121 64-Bit MIPS RISC Microprocessor(64 位RISC 微處理器)
相關代理商/技術參數
參數描述
PD2M 制造商:ANADIGICS 制造商全稱:ANADIGICS, Inc 功能描述:2mm InGaAs Photodiode
PD2M-0XX 制造商:ANADIGICS 制造商全稱:ANADIGICS, Inc 功能描述:2mm InGaAs Photodiode
PD2M-1XX 制造商:ANADIGICS 制造商全稱:ANADIGICS, Inc 功能描述:2mm InGaAs Photodiode
PD2-O4118L1804 制造商:NANOTEC 功能描述:MOTOR PLUG & DRIVE 42MM 0.5NM 制造商:NANOTEC 功能描述:MOTOR, PLUG & DRIVE, 42MM, 0.5NM
PD2-O4118S1404 制造商:NANOTEC 功能描述:MOTOR PLUG & DRIVE 42MM 0.3NM 制造商:NANOTEC 功能描述:MOTOR, PLUG & DRIVE, 42MM, 0.3NM 制造商:NANOTEC 功能描述:MOTOR, PLUG & DRIVE, 42MM, 0.3NM; Torque Max:0.2N-m; Current Rating:1.4A; No. of Phases:Two; SVHC:No SVHC (19-Dec-2012); External Height:42.3mm; Supply Voltage Max:24V; Supply Voltage Min:12V ;RoHS Compliant: Yes