- 您現在的位置：買賣IC網 > PDF目錄24776 > 935167440557 (NXP SEMICONDUCTORS) 8-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQFP80 PDF資料下載
參數資料
| 型號： | 935167440557 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQFP80 |
| 封裝： | 14 X 20 MM, 2.70 MM HEIGHT, PLASTIC, SOT-318-1, QFP-80 |
| 文件頁數： | 34/112頁 |
| 文件大?。?/td> | 707K |
| 代理商： | 935167440557 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁當前第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁
1996 Jun 27
28
Philips Semiconductors
Product specication
8-bit microcontroller with on-chip CAN
P8xCE598
12 SERIAL I/O PORT: SIO0 (UART)
The Serial Port SIO0 is a full duplex (UART) serial I/O port
i.e. it can transmit and receive simultaneously. This Serial
Port is also receive-buffered. It can commence reception
of a second byte before the previously received byte has
been read from the receive register. However, if the first
byte has still not been read by the time reception of the
second byte is complete, one of these (first or second)
bytes will be lost. The SIO0 receive and transmit registers
are both accessed via the S0BUF SFR. Writing to S0BUF
loads the transmit register, and reading S0BUF accesses
to a physically separate receive register. SIO0 can operate
in 4 modes:
Mode 0 Serial data is transmitted and received through
RXD. TXD outputs the shift clock. 8 data bits are
transmitted/received (LSB first). The baud rate is
fixed at 1
12 of the oscillator frequency.
Mode 1 10 bits are transmitted via TXD or received
through RXD: a start bit (0), 8 data bits (LSB first),
and a stop bit (1). On receive, the stop bit is put
into RB8 of the S0CON SFR. The baud rate is
variable.
Mode 2 11 bits are transmitted through TXD or received
through RXD: a start bit (0), 8 data bits (LSB first),
a programmable 9th data bit, and a stop bit (1).
On transmit, the 9th data bit (TB8 in S0CON) can
be assigned the value of 0 or 1. With nominal
software, TB8 can be the parity bit (P in PSW).
During a receive, the 9th data bit is stored in RB8
(S0CON), and the stop bit is ignored. The baud
rate is programmable to either 1
32 or 164 of the
oscillator frequency.
Mode 3 11 bits are transmitted through TXD or received
through RXD: a start bit (0), 8 data bits (LSB first),
a programmable 9th data bit, and a stop bit (1).
Mode 3 is the same as Mode 2 except for the
baud rate which is variable in Mode 3.
In all four modes, transmission is initiated by any
instruction that writes to the S0BUF SFR.
Reception is initiated in Mode 0 when RI = 0 and REN = 1.
In the other three modes, reception is initiated by the
incoming start bit provided that REN = 1.
Modes 2 and 3 are provided for multiprocessor
communications. In these modes, 9 data bits are received
with the 9th bit written to RB8 (S0CON). The 9th bit is
followed by the stop bit. The port can be programmed so
that with receiving the stop bit, the Serial Port interrupt will
be activated if, and only if RB8 = 1.
This feature is enabled by setting bit SM2 in S0CON. This
feature may be used in multiprocessor systems.
For more information about how to use the UART in
combination with the registers S0CON, PCON, IE, SBUF
and the Timer register, refer to the 8051-based
“8-bit Microcontrollers Data Handbook IC20”.
13 SERIAL I/O PORT: SIO1 (CAN)
SIO1 (CAN) provides the CAN (Controller Area Network)
serial-bus data communication interface. SIO1 (CAN)
replaces the SIO1 (I2C) serial interface as provided in the
microcontroller derivative P8xC552.
13.1
On-chip CAN-controller
CAN is the definition of a high performance
communication protocol for serial data communication.
The P8xCE598 on-chip CAN-controller is a full
implementation of the CAN 2.0A protocol. With the
P8xCE598 powerful local networks can be built, both for
automotive and general industrial environments. This
results in a much reduced wiring harness and enhanced
diagnostic and supervisory capabilities.
13.2
CAN Features
Multi-master architecture
Bus access priority determined by the message
identifier
2032 message identifier (211 standard frame CAN 2.0A)
Guaranteed latency time for high priority messages
Powerful error handling capability
Data length from 0 up to 8 bytes
Multicast and broadcast message facility
Non destructive bit-wise arbitration
Non-return-to-zero (NRZ) coding/decoding with
bit-stuffing
Programmable transfer rate (up to 1 Mbit/s)
Programmable output driver configuration
Suitable for use in a wide range of networks including
the SAE's network classes A, B and C
DMA providing high-speed on-chip data exchange
Bus failure management facility
12AVDD reference voltage.
相關PDF資料 |
PDF描述 |
|---|---|
| 935167560557 | 8-BIT, 16 MHz, MICROCONTROLLER, PQFP80 |
| 935165760551 | 8-BIT, 16 MHz, MICROCONTROLLER, PQFP80 |
| 0673.400 | Axial Lead and Cartridge Fuses - Glass Body |
| 0673.500 | Axial Lead and Cartridge Fuses - Glass Body |
| 0673.600 | Axial Lead and Cartridge Fuses - Glass Body |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 93516-PIX | 制造商:FCI 功能描述: |
| 93517-090001 | 制造商:FCI 功能描述:PCMCIA REV CARD FRAME 9P |
| 93517-150000 | 制造商:FCI 功能描述: |
| 93518097J | 制造商:Fiskars Brands Inc 功能描述:Fiskars 45mm Rotary Blades - Pinking (Fits Models 195800/154570/19680/19583) (Fr |
| 935181002005 | 功能描述:電容套件 HiTmpSilCap Kit 0402 1nF 10nF 33nF BD11V RoHS:否 制造商:Nichicon 電容范圍:10 uF to 680 uF 公差范圍: 電壓范圍:6.3 V to 25 V 產品:Aluminum Organic Polymer Capacitor Kit |
發布緊急采購，3分鐘左右您將得到回復。