參數資料
型號: 935167440557
廠商: NXP SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: 8-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQFP80
封裝: 14 X 20 MM, 2.70 MM HEIGHT, PLASTIC, SOT-318-1, QFP-80
文件頁數: 64/112頁
文件大?。?/td> 707K
代理商: 935167440557
1996 Jun 27
55
Philips Semiconductors
Product specication
8-bit microcontroller with on-chip CAN
P8xCE598
13.5.20.1 Synchronization Rules
The synchronization rules are as follows:
Only one synchronization within one bit time is used.
An edge is used for synchronization only if the value
detected at the previous sample point differs from the
bus value immediately after the edge.
Hard synchronization is performed whenever there is a
recessive-to-dominant edge during Bus-Idle
(see Section 13.6.6).
All other edges (recessive-to-dominant and optionally
dominant-to recessive edges if the Sync bit is set HIGH
(see Section 13.5.3) which are candidates for
resynchronization will be used with the following
exception:
– A transmitting CAN-controller will not perform a
resynchronization as a result of a
recessive-to-dominant edge with positive phase
error, if only these edges are used for
resynchronization. This ensures that the delay times
of the output driver and input comparator do not
cause a permanent increase in the bit time.
13.6
CAN 2.0A Protocol description
13.6.1
FRAME TYPES
The P8xCE598's CAN-controller supports the four
different CAN-protocol frame types for communication:
Data Frame, to transfer data
Remote Frame, request for data
Error Frame, globally signal a (locally) detected error
condition
Overload Frame, to extend delay time of subsequent
frames (an Overload Frame is not initiated by the
P8xCE598 CAN-Controller).
13.6.1.1
Bit representation
There are two logical bit representations used in the
CAN-protocol:
A recessive bit on the bus-line appears only if all
connected CAN-controllers send a recessive bit at that
moment.
Dominant bits always overwrite recessive bits i.e. the
resulting bit level on the bus-line is dominant.
13.6.2
DATA FRAME
A Data Frame carries data from a transmitting
CAN-controller to one or more receiving ones.
A Data Frame is composed of seven different bit-fields:
Start-Of-Frame
Arbitration Field
Control Field
Data Field (may have a length of zero)
CRC Field
Acknowledge Field
End-Of-Frame.
13.6.2.1
Start-Of-Frame bit
Signals the start of a Data Frame or Remote Frame.
It consists of a single dominant bit use for hard
synchronization of a CAN-controller in receive mode.
13.6.2.2
Arbitration Field
Consists of the message Identifier and the RTR bit. In the
case of simultaneous message transmissions by two or
more CAN-controllers the bus access conflict is solved by
bit-wise arbitration, which is active during the transmission
of the Arbitration Field.
13.6.2.3
Identier
This 11-bit field is used to provide information about the
message, as well as the bus access priority. It is
transmitted in the order ID.10 to ID.0 (LSB). The situation
that the seven most significant bits (ID.10 to ID.4) are all
recessive must not occur.
An Identifier does not define which particular
CAN-controller will receive the frame because a CAN
based communication network does not differentiate
between a point-to-point, multicast or broadcast
communication.
相關PDF資料
PDF描述
935167560557 8-BIT, 16 MHz, MICROCONTROLLER, PQFP80
935165760551 8-BIT, 16 MHz, MICROCONTROLLER, PQFP80
0673.400 Axial Lead and Cartridge Fuses - Glass Body
0673.500 Axial Lead and Cartridge Fuses - Glass Body
0673.600 Axial Lead and Cartridge Fuses - Glass Body
相關代理商/技術參數
參數描述
93516-PIX 制造商:FCI 功能描述:
93517-090001 制造商:FCI 功能描述:PCMCIA REV CARD FRAME 9P
93517-150000 制造商:FCI 功能描述:
93518097J 制造商:Fiskars Brands Inc 功能描述:Fiskars 45mm Rotary Blades - Pinking (Fits Models 195800/154570/19680/19583) (Fr
935181002005 功能描述:電容套件 HiTmpSilCap Kit 0402 1nF 10nF 33nF BD11V RoHS:否 制造商:Nichicon 電容范圍:10 uF to 680 uF 公差范圍: 電壓范圍:6.3 V to 25 V 產品:Aluminum Organic Polymer Capacitor Kit