參數資料
型號: 935262451518
廠商: NXP SEMICONDUCTORS
元件分類: 顏色信號轉換
英文描述: COLOR SIGNAL DECODER, PQFP100
封裝: 14 X 14 X 1.40 MM, PLASTIC, SOT-407, LQFP-100
文件頁數: 56/144頁
文件大小: 592K
代理商: 935262451518
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁當前第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁
2000 Mar 15
19
Philips Semiconductors
Preliminary specication
PAL/NTSC/SECAM video decoder with adaptive PAL/NTSC
comb lter, VBI-data slicer and high performance scaler
SAA7114H
8.1.3.1
Chrominance path
The 9-bit CVBS or chrominance input signal is fed to the
input of a quadrature demodulator, where it is multiplied by
two time-multiplexed subcarrier signals from the subcarrier
generation block 1 (0
° and 90° phase relationship to the
demodulator axis). The frequency is dependent on the
chosen colour standard.
The time-multiplexed output signals of the multipliers are
low-pass filtered (low-pass 1). Eight characteristics are
programmable via LCWB3 to LCWB0 to achieve the
desired bandwidth for the colour difference signals (PAL,
NTSC) or the 0
° and 90° FM signals (SECAM).
The chrominance low-pass 1 characteristic also influences
the grade of cross-luminance reduction during horizontal
colour transients (large chrominance bandwidth means
strong suppression of cross-luminance). If the Y-comb
filter is disabled by YCOMB = 0 the filter influences directly
the width of the chrominance notch within the luminance
path (large chrominance bandwidth means wide
chrominance notch resulting to lower luminance
bandwidth).
The low-pass filtered signals are fed to the adaptive comb
filter block. The chrominance components are separated
from the luminance via a two line vertical stage (four lines
for PAL standards) and a decision logic between the
filtered and the non-filtered output signals. This block is
bypassed for SECAM signals. The comb filter logic can be
enabled independently for the succeeding luminance and
chrominance processing by YCOMB (subaddress 09H,
bit 6) and/or CCOMB (subaddress 0EH, bit 0). It is always
bypassed during VBI or raw data lines programmable by
the LCRn registers (subaddresses 41H to 57H), see
Section 8.2.
The separated UV-components are further processed by a
second filter stage (low-pass 2) to modify the chrominance
bandwidth without influence to the luminance path. It’s
characteristic is controlled by CHBW (subaddress 10H,
bit 3). For the complete transfer characteristic of
low-passes 1 and 2 see Figs 10 and 11.
The SECAM processing (bypassed for QUAM standards)
contains the following blocks:
Baseband ‘bell’ filters to reconstruct the amplitude and
phase equalized 0
° and 90° FM signals
Phase demodulator and differentiator
(FM-demodulation)
De-emphasis filter to compensate the pre-emphasized
input signal, including frequency offset compensation
(DB or DR white carrier values are subtracted from the
signal, controlled by the SECAM switch signal).
The succeeding chrominance gain control block amplifies
or attenuates the UV-signal according to the required
ITU 601/656 levels. It is controlled by the output signal
from the amplitude detection circuit within the burst
processing block.
The burst processing block provides the feedback loop of
the chrominance PLL and contains:
Burst gate accumulator
Colour identification and killer
Comparison nominal/actual burst amplitude
(PAL/NTSC standards only)
Loop filter chrominance gain control
(PAL/NTSC standards only)
Loop filter chrominance PLL (only active for
PAL/NTSC standards)
PAL/SECAM sequence detection, H/2-switch
generation.
The increment generation circuit produces the Discrete
Time Oscillator (DTO) increment for both subcarrier
generation blocks. It contains a division by the increment
of the line-locked clock generator to create a stable
phase-locked sine signal under all conditions (e.g. for
non-standard signals).
The PAL delay line block eliminates crosstalk between the
chrominance channels in accordance with the
PAL standard requirements. For NTSC colour standards
the delay line can be used as an additional vertical filter.
If desired, it can be switched off by DCVF = 1. It is always
disabled during VBI or raw data lines programmable by the
LCRn registers (subaddresses 41H to 47H), see
Section 8.2. The embedded line delay is also used for
SECAM recombination (cross-over switches).
相關PDF資料
PDF描述
935262451557 COLOR SIGNAL DECODER, PQFP100
935262469557 SPECIALTY CONSUMER CIRCUIT, PQFP240
935263151557 SPECIALTY CONSUMER CIRCUIT, PQFP240
935263331557 SPECIALTY CONSUMER CIRCUIT, PQFP240
935263133112 26 W, 1 CHANNEL, AUDIO AMPLIFIER, PZIP17
相關代理商/技術參數
參數描述
935264217557 制造商:NXP Semiconductors 功能描述:SUB ONLY IC
935267356112 制造商:NXP Semiconductors 功能描述:IC TEA1507PN
935268081112 制造商:NXP Semiconductors 功能描述:SUB ONLY IC
935268721125 制造商:NXP Semiconductors 功能描述:Buffer/Line Driver 1-CH Non-Inverting 3-ST CMOS 5-Pin TSSOP T/R
935269304128 制造商:ST-Ericsson 功能描述:IC AUDIO CODEC W/TCH SCRN 48LQFP