- 您現在的位置：買賣IC網 > PDF目錄360649 > 9880 (Intel Corp.) Advanced 10/100 Repeater with Intergrated Management PDF資料下載
參數資料
| 型號： | 9880 |
| 廠商： | Intel Corp. |
| 英文描述： | Advanced 10/100 Repeater with Intergrated Management |
| 中文描述： | 高級10/100中繼器與綜合管理 |
| 文件頁數： | 59/118頁 |
| 文件大?。?/td> | 1648K |
| 代理商： | 9880 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁當前第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁
Advanced 10/100 Repeater with Integrated Management
—
LXT9860/9880
Datasheet
Document #: 248987
Revision#: 003
Rev Date: 08/07/01
59
on the board listen in and record the ID. The device with ChipID = 00 then transmits Arbitration
Request messages on the SMI every 2-3 ms. The request messages from two boards may collide. If
this happens, a resolution scheme ensures that only one message is transmitted.
The network manager must respond to each request with a message that includes the 48-bit ID and
the HubID. All devices hear this message, but only those matching the 48-bit ID receive the HubID
as their own. Once a HubID is assigned to a hub, that hub ceases requesting a HubID. This process
continues until all hubs are assigned an ID. Should a hub power off and back on, the hub re-
requests an ID, which the manager provides. An address arbitration packet is selected over normal
requests.
3.10.3.3
Address Re-Arbitration
There are two mechanisms for address re-arbitration following a configuration change, such as a
hot-swap of a board:
Manual Re-arbitration. If the LXT98x0 detects a Low-to-High transition on RECONFIG, or if
RECONFIG is High at power-up, it sends out a
“
Configuration Change
”
message (Start Flag
with all 0s) on the bus. The network manager can use this message to detect that re-arbitration
is required.
Network Manager. The network manager can detect or re-start arbitration at any time by
sending the
“
Re-arbitrate
”
command.
3.10.4
Interrupt Functions
The LXT98x0 provides a single open-collector pin for external interrupt signalling. Several
different interrupt conditions may be reported. The Interrupt Status Register (see
Table 86
)
identifies the specific interrupt condition. The Interrupt Mask Register (see
Table 87 on page 115
)
allows specific interrupts to be masked. Interrupts may be cleared in two ways, depending on the
status of bit 11 in the repeater configuration register.
3.11
Serial PROM Interface
The serial PROM interface allows the vendor to load in optional information unique to each board.
Items such as serial number or manufacture date can be placed in the serial PROM which can also
be used in the address arbitration process. Each board must contain a unique set of information.
Additionally, only 1 serial PROM is required per board, they are not required per chip. The
LXT98x0 reads in the first 48 bits (three 16-bit words) from the PROM and stores them in a
register. This read occurs only on power-up. Only the LXT98x0 with a ChipID of 00 drives the
serial PROM control lines; all other LXT98x0s
“
listen
”
to the data and clock lines. The first bit into
the LXT98x0 from this interface corresponds to bit 47. The serial PROM shifts out the most
significant bit (15) of the word first (the PROM must be auto-incrementing).
相關PDF資料 |
PDF描述 |
|---|---|
| 9863 | Advanced 10/100 Umnmanaged Repeater |
| 9883 | Advanced 10/100 Umnmanaged Repeater |
| 989AS-470M | Fixed Inductors for Surface Mounting |
| 989BS-110M | Fixed Inductors for Surface Mounting |
| 989BS-1R3N | Fixed Inductors for Surface Mounting |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 9880 0041000 | 功能描述:同軸電纜 11H 50 OHM TRUNK CABLE RoHS:否 制造商:Murata RG 類型: 阻抗:50 Ohms 線規 - 美國線規（AWG）: 導體材料: 絞合: 長度:300 mm 外殼材料: 外徑: 屏蔽: |
| 9880 0041640 | 功能描述:同軸電纜 11H 50 OHM TRUNK CABLE RoHS:否 制造商:Murata RG 類型: 阻抗:50 Ohms 線規 - 美國線規（AWG）: 導體材料: 絞合: 長度:300 mm 外殼材料: 外徑: 屏蔽: |
| 9880 004500 | 功能描述:同軸電纜 12AWG 1C SHIELD 500ft SPOOL YELLOW RoHS:否 制造商:Murata RG 類型: 阻抗:50 Ohms 線規 - 美國線規（AWG）: 導體材料: 絞合: 長度:300 mm 外殼材料: 外徑: 屏蔽: |
| 98803 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| 988-050-030L121 | 功能描述:PIN CONN & BACKSHELL KIT 50POS RoHS:是 類別:連接器，互連式 >> D形，Centronics 系列:988 產品變化通告:52755 Series Obsolescence 19/May/2009 標準包裝:1 系列:52755 連接器類型:外罩觸點 連接器類型:插座 位置數:120 行數:2 安裝類型:面板安裝，通孔，直角 端子:焊接 法蘭特點:螺紋插件（M5） 類型:- 特點:板鎖，屏蔽 觸點表面涂層:金 觸點涂層厚度:30µin（0.76µm） 其它名稱:052755-1209052755-1209-E05275512090527551209-E52755-1209-E527551209527551209-EQ2711871SD-52755-001 |
發布緊急采購，3分鐘左右您將得到回復。