參數資料
型號： AMIS49587GEVK
廠商： ON Semiconductor
文件頁數： 15/55頁
文件大?。?/td> 0K
描述： KIT EVALUATION AMIS49587
標準包裝： 1
主要目的： 接口，電源線路收發器
嵌入式： 否
已用 IC / 零件： AMIS49587
已供物品： 2 個板，線纜，CD，文檔
其它名稱： AMIS49587GEVKOS
AMIS49587
http://onsemi.com
22
6.2
TRANSMITTER PATH DESCRIPTION (SFSK
MODULATOR)
For the generation of the space and mark frequencies, the
direct digital synthesis (DDS) of the sine wave signals is
performed under the control of the microprocessor. After a
signal conditioning step, a digital to analog conversion is
performed. As for the receive path, a sigma delta modulation
technique is used. In the analog domain, the signal is low
pass filtered, in order to remove the high frequency
quantization noise, and passed to the automatic level
controller (ACL) block, where the level of the transmitted
signal can be adjusted. The determination of the signal level
is done through the sense circuitry.
Figure 17. Transmitter Block Diagram
Transmitter (SFSK Modulator)
ARM
Interface
&
Control
TX_OUT
Transmit Data
& Sine Synthesizer
D/A
LP
Filter
ALC
control
ALC_IN
TO RECEIVER
fMI
fMQ
fSI
fSQ
TX_EN
6.2.1 ARM Interface and Control
The interface with the ARM consists in a 8bit data
registers R_TX_DATA, 2 control registers R_TX_CTRL
and R_ALC_CTRL, a flag TX_RXB defining transmit and
receive and 2 16bit wide frequency step registers R_FM
and R_FS defining fM (mark frequency = data 1) and fS
(space frequency = data 0). All these registers are memory
mapped. Some of them are for internal use only and cannot
be accessed by the user.
The processing of the physical frame (preamble, MAC
address, CRC) is done by the ARM.
6.2.2 Sine Wave Generator
A sine wave is generated with a direct digital synthesizer
DDS. The synthesizer generates in transmission mode a sine
wave either for the space frequency (fS, data 0) or for the
mark frequency (fM, data1). In reception the synthesizer
generates the sine and cosine waves for the mixing process,
fSI, fSQ, fMI, fMQ (space and mark signals in phase and
quadrature). The space and mark frequencies are defined in
an individual step 16 bit wide register.
Table 24. FS AND FM STEP REGISTERS
ARM
Register
Hard
Reset
Soft
Reset
Description
R_FS[15:0]
0000h
Step register for the
space frequency fS
R_FM[15:0]
0000h
Step register for the
mark frequency fM
The space and mark frequency can be calculated as:
fS = R_FS[15:0]_dec x fDDS/218
fM = R_FM[15:0]_dec x fDDS/218
Or the content of both R_FS[15:0] and R_FM[15:0] are
defined as:
R_FS[15:0]_dec = Round(218 x fS/fDDS)
R_FM[15:0]_dec = Round(218 x fM/fDDS)
Where fDDS = 3 MHz is the direct digital synthesizer
clock frequency.
After a hard or soft reset or at the start of the transmission
(when TX_RXB goes from 0 to 1) the phase accumulator
相關PDF資料
PDF描述
VI-J51-EY-S CONVERTER MOD DC/DC 12V 50W
383LX473M025A062 CAP ALUM 47000UF 25V 20% SNAP
M3DDK-3418R IDC CABLE - MKR34K/MC34M/MKR34K
CMH322522-27NML INDUCTOR WIREWOUND .027UH 1210
VI-J50-EZ-F4 CONVERTER MOD DC/DC 5V 25W
相關代理商/技術參數
參數描述
AMIS-50050 制造商:ON Semiconductor 功能描述:SPREAD SPECTRUM BASEBAND CNTRLR - Trays 制造商:ON Semiconductor 功能描述:SPREAD SPECTRUM BASEBAND CNTRLR - Tape and Reel
AMIS-50051 制造商:ON Semiconductor 功能描述:DMOD 32LQFP / - Trays 制造商:ON Semiconductor 功能描述:DMOD - Tape and Reel
AMIS-52000 制造商:AMI 制造商全稱:AMI 功能描述:Single-Chip Radio Transceiver
AMIS-52050 制造商:ON Semiconductor 功能描述:WIRELESS LOW POWER TRANSCEIVER - 433MHZ (300-700MHZ), SSOP - Rail/Tube 制造商:ON Semiconductor 功能描述:WIRELESS LOW POWER TRANSCEIVER - 433MHZ (300-700MHZ), SSOP - Tape and Reel
AMIS-52100 制造商:AMI 制造商全稱:AMI 功能描述:Transceiver with Clock and Data Recovery
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*