參數資料
型號: AMIS49587GEVK
廠商: ON Semiconductor
文件頁數: 55/55頁
文件大?。?/td> 0K
描述: KIT EVALUATION AMIS49587
標準包裝: 1
主要目的: 接口,電源線路收發(fā)器
嵌入式:
已用 IC / 零件: AMIS49587
已供物品: 2 個板,線纜,CD,文檔
其它名稱: AMIS49587GEVKOS
AMIS49587
http://onsemi.com
9
TDO, TDI, TCK, TMS, and TRSTB
All these pins are part of the JTAG bus interface. The JTAG interface is used during production test of the IC and will not be
described here. Input pins (TDI, TCK, TMS, and TRSTB) contain internal pulldown resistance. TDO is an output. When not
used, the JTAG interface pins may be left floating.
TX_DATA/PRE_SLOT
TX_DATA/PRE_SLOT is the output for either the transmitting data (TX_DATA) or a synchronization signal with the
timeslots (PRE_SLOT). More information can be found in paragraph Local Port.
XIN
XIN is the analog input pin of the oscillator. It is connected to the interval oscillator inverter gain stage. The clock signal can
be created either internally with the external crystal and two capacitors or by connecting an external clock signal to XIN. For
the internal generation case, the two external capacitors and crystal are placed as shown in Figure 6. For the external clock
connection, the signal is connected to XIN and XOUT is left unused.
XTAL _IN
XTAL_ OUT
C X
V SSA
C X
R X
24 MHz
Figure 6. Placement of the Capacitors and Crystal with Clock Signal Generated Internally
The crystal is a classical parallel resonance crystal of 24 MHz. The values of the capacitors CX are given by the manufacturer
of the crystal. A typical value is 30 pF. The crystal has to fulfill impedance characteristics specified in the AMIS49587 data
sheet. As an oscillator is sensitive and precise, it is advised to put the crystal as close as possible on the board and to ground
the case.
XOUT
XOUT is the analog output pin of the oscillator. When the clock signal is provided from an external generator, this output must
be floating. When working with a crystal, this pin cannot be used directly as clock output because no additional loading is
allowed on the pin (limited voltage swing).
TXD
TXD is the digital output of the asynchronous serial communication (SCI) unit. Only halfduplex transmission is supported.
It is used to realize the communication between the AMIS49587 and the application microcontroller. The TXD is an open
drain IO (5 V safe). External pullup resistances (typically 10 k
W) are necessary to generate the 5 V level. See Figure 5 for
the circuit schematic.
RXD
This is the digital input of the asynchronous SCI unit.
Only halfduplex transmission is supported. This pin supports a 5 V level. It is used to realize the communication between the
AMIS49587 and the application microcontroller. RXD is a 5 V safe input.
T_REQ
T_REQ is the transmission request input of the Serial Communication Interface. When pulled low its initiate a local
communication from the application micro controller to AMIS49587. T_REQ is a 5 V safe input.
BR1, BR0
BR0 and BR1 are digital input pins. They are used to select the baud rate (bits/second) of the Serial Communication Interface
unit. The rate is defined according to Table 28: BR1, BR0 Baud Rates. The values are taken into account after a reset, hardware
or software. Modification of the baud rate during function is not possible. BR0 and BR1 are 5 V safe.
相關PDF資料
PDF描述
VI-J51-EY-S CONVERTER MOD DC/DC 12V 50W
383LX473M025A062 CAP ALUM 47000UF 25V 20% SNAP
M3DDK-3418R IDC CABLE - MKR34K/MC34M/MKR34K
CMH322522-27NML INDUCTOR WIREWOUND .027UH 1210
VI-J50-EZ-F4 CONVERTER MOD DC/DC 5V 25W
相關代理商/技術參數
參數描述
AMIS-50050 制造商:ON Semiconductor 功能描述:SPREAD SPECTRUM BASEBAND CNTRLR - Trays 制造商:ON Semiconductor 功能描述:SPREAD SPECTRUM BASEBAND CNTRLR - Tape and Reel
AMIS-50051 制造商:ON Semiconductor 功能描述:DMOD 32LQFP / - Trays 制造商:ON Semiconductor 功能描述:DMOD - Tape and Reel
AMIS-52000 制造商:AMI 制造商全稱:AMI 功能描述:Single-Chip Radio Transceiver
AMIS-52050 制造商:ON Semiconductor 功能描述:WIRELESS LOW POWER TRANSCEIVER - 433MHZ (300-700MHZ), SSOP - Rail/Tube 制造商:ON Semiconductor 功能描述:WIRELESS LOW POWER TRANSCEIVER - 433MHZ (300-700MHZ), SSOP - Tape and Reel
AMIS-52100 制造商:AMI 制造商全稱:AMI 功能描述:Transceiver with Clock and Data Recovery