參數資料
型號: C8051F015-TB
廠商: Silicon Laboratories Inc
文件頁數: 73/171頁
文件大?。?/td> 0K
描述: BOARD PROTOTYPING W/C8051F015
標準包裝: 1
C8051F000/1/2/5/6/7
C8051F010/1/2/5/6/7
21. JTAG (IEEE 1149.1)
Each MCU has an on-chip JTAG interface and logic to support boundary scan for production and in-system testing,
Flash read and write operations, and non-intrusive in-circuit debug. The JTAG interface is fully compliant with the
IEEE 1149.1 specification. Refer to this specification for detailed descriptions of the Test Interface and Boundary-
Scan Architecture. Access of the JTAG Instruction Register (IR) and Data Registers (DR) are as described in the
Test Access Port and Operation of the IEEE 1149.1 specification.
The JTAG interface is via four dedicated pins on the MCU, which are TCK, TMS, TDI, and TDO. These pins are
all 5V tolerant.
Through the 16-bit JTAG Instruction Register (IR), any of the eight instructions shown in Figure 21.1 can be
commanded. There are three Data Registers (DR’s) associated with JTAG Boundary-Scan, and four associated with
Flash read/write operations on the MCU.
Figure 21.1. IR: JTAG Instruction Register
Reset Value
0x0004
Bit15
Bit0
IR value
Instruction
Description
0x0000
EXTEST
Selects the Boundary Data Register for control and observability of all
device pins
0x0002
SAMPLE/
PRELOAD
Selects the Boundary Data Register for observability and presetting the
scan-path latches
0x0004
IDCODE
Selects device ID Register
0xFFFF
BYPASS
Selects Bypass Data Register
0x0082
Flash Control
Selects FLASHCON Register to control how the interface logic responds to
reads and writes to the FLASHDAT Register
0x0083
Flash Data
Selects FLASHDAT Register for reads and writes to the Flash memory
0x0084
Flash Address
Selects FLASHADR Register which holds the address of all Flash read,
write, and erase operations
0x0085
Flash Scale
Selects FLASHSCL Register which controls the prescaler used to generate
timing signals for Flash operations
Rev. 1.7
164
相關PDF資料
PDF描述
ISC1210ER8R2J INDUCTOR WW 8.2UH 5% 1210
ISC1210ER6R8J INDUCTOR WW 6.8UH 5% 1210
ISC1210ER5R6J INDUCTOR WW 5.6UH 5% 1210
GCM12DRMT CONN EDGECARD 24POS .156 WW
RP15-4815DF/N-HC CONV DC/DC 15W 36-75VIN +/-15V
相關代理商/技術參數
參數描述
C8051F016 功能描述:8位微控制器 -MCU 32KB 10ADC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F016-GQ 功能描述:8位微控制器 -MCU 32KB 10ADC 48P MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F016-GQR 功能描述:8位微控制器 -MCU 32KB 10ADC 48Pin MCU Tape and Reel RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F016R 功能描述:8位微控制器 -MCU C +-10Bit 48Pin RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
C8051F017 功能描述:8位微控制器 -MCU 32KB 10ADC RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT