參數資料
型號： DSP56303VL100B1
廠商： Freescale Semiconductor
文件頁數： 30/108頁
文件大小： 0K
描述： IC DSP 24BIT 100MHZ 196-BGA
標準包裝： 630
系列： DSP563xx
類型： 定點
接口： 主機接口，SSI，SCI
時鐘速率： 100MHz
非易失內存： ROM（576 B）
芯片上RAM： 24kB
電壓 - 輸入/輸出： 3.30V
電壓 - 核心： 3.30V
工作溫度： -40°C ~ 100°C
安裝類型： 表面貼裝
封裝/外殼： 196-LBGA
供應商設備封裝： 196-MAPBGA（15x15）
包裝： 托盤
DSP56303 Technical Data, Rev. 11
2-8
Freescale Semiconductor
Specifications
Notes:
1.
When fast interrupts are used and IRQA, IRQB, IRQC, and IRQD are defined as level-sensitive, timings 19 through 21 apply to
prevent multiple interrupt service. To avoid these timing restrictions, the deasserted Edge-triggered mode is recommended
when fast interrupts are used. Long interrupts are recommended for Level-sensitive mode.
2.
This timing depends on several settings:
For PLL disable, using internal oscillator (PLL Control Register (PCTL) Bit 16 = 0) and oscillator disabled during Stop (PCTL
Bit 17 = 0), a stabilization delay is required to assure that the oscillator is stable before programs are executed. Resetting the
Stop delay (Operating Mode Register Bit 6 = 0) provides the proper delay. While Operating Mode Register Bit 6 = 1 can be set,
it is not recommended, and these specifications do not guarantee timings for that case.
For PLL disable, using internal oscillator (PCTL Bit 16 = 0) and oscillator enabled during Stop (PCTL Bit 17=1), no
stabilization delay is required and recovery is minimal (Operating Mode Register Bit 6 setting is ignored).
For PLL disable, using external clock (PCTL Bit 16 = 1), no stabilization delay is required and recovery time is defined by the
PCTL Bit 17 and Operating Mode Register Bit 6 settings.
For PLL enable, if PCTL Bit 17 is 0, the PLL is shutdown during Stop. Recovering from Stop requires the PLL to get locked.
The PLL lock procedure duration, PLL Lock Cycles (PLC), may be in the range of 0 to 1000 cycles. This procedure occurs in
parallel with the stop delay counter, and stop recovery ends when the last of these two events occurs. The stop delay counter
completes count or PLL lock procedure completion.
PLC value for PLL disable is 0.
The maximum value for ETC is 4096 (maximum MF) divided by the desired internal frequency (that is, for 66 MHz it is 4096/66
MHz = 62
s). During the stabilization period, TC, TH, and TL is not constant, and their width may vary, so timing may vary as
well.
3.
Periodically sampled and not 100 percent tested.
4.
Value depends on clock source:
For an external clock generator, RESET duration is measured while RESET is asserted, VCC is valid, and the EXTAL input is
active and valid.
For an internal oscillator, RESET duration is measured while RESET is asserted and VCC is valid. The specified timing
reflects the crystal oscillator stabilization time after power-up. This number is affected both by the specifications of the crystal
and other components connected to the oscillator and reflects worst case conditions.
When the VCC is valid, but the other “required RESET duration” conditions (as specified above) have not been yet met, the
device circuitry is in an uninitialized state that can result in significant power consumption and heat-up. Designs should
minimize this state to the shortest possible duration.
5.
If PLL does not lose lock.
6.
VCC = 3.3 V ± 0.3 V; TJ = –40°C to +100°C, CL = 50 pF.
7.
WS = number of wait states (measured in clock cycles, number of TC).
8.
Use the expression to compute a maximum value.
Figure 2-3.
Reset Timing
Table 2-7.
Reset, Stop, Mode Select, and Interrupt Timing6 (Continued)
No.
Characteristics
Expression
100 MHz
Unit
Min
Max
VIH
RESET
Reset Value
First Fetch
All Pins
A[0–17]
8
9
10
相關PDF資料
PDF描述
DSP56311VF150B1 IC DSP 24BIT 150MHZ 196-BGA
DSP56321VF200R2 IC DSP 24BIT 200MHZ 196-BGA
DSP56852VFE IC DSP 16BIT 120MHZ 81-MAPBGA
DSP56854FGE IC DSP 16BIT 120MHZ 128-LQFP
DSP56855BUE IC DSP 16BIT 120MHZ 100-LQFP
相關代理商/技術參數
參數描述
DSP56304GC66 制造商:未知廠家 制造商全稱:未知廠家 功能描述:24-Bit Digital Signal Processor
DSP56304GC80 制造商:未知廠家 制造商全稱:未知廠家 功能描述:24-Bit Digital Signal Processor
DSP56304PV66 制造商:未知廠家 制造商全稱:未知廠家 功能描述:24-Bit Digital Signal Processor
DSP56304PV80 制造商:未知廠家 制造商全稱:未知廠家 功能描述:24-Bit Digital Signal Processor
DSP56305DS 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DSP56305 Single Chip Channel Codec Digital Signal Processor Data Sheet
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*