- 您現在的位置：買賣IC網 > PDF目錄296194 > HMT351V7BFR8C-H9 (HYNIX SEMICONDUCTOR INC) DDR DRAM MODULE, DMA240 PDF資料下載
參數資料
| 型號： | HMT351V7BFR8C-H9 |
| 廠商： | HYNIX SEMICONDUCTOR INC |
| 元件分類： | DRAM |
| 英文描述： | DDR DRAM MODULE, DMA240 |
| 封裝： | ROHS COMPLIANT, DIMM-240 |
| 文件頁數： | 59/61頁 |
| 文件大?。?/td> | 1050K |
| 代理商： | HMT351V7BFR8C-H9 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁當前第59頁第60頁第61頁
Rev. 0.1 / Feb. 2010
7
DQS[17:0]
I/O
Positive
Edge
Positive line of the differential data strobe for input and output data.
DQS[17:0]
I/O
Negative
Edge
Negative line of the differential data strobe for input and output data.
TDQS[17:9]
OUT
TDQS/TDQS is applicable for X8 DRAMs only. When enabled via Mode Register A11=1 in
MR1,DRAM will enable the same termination resistance function on TDQS/TDQS that is
applied to DQS/DQS. When disabled via mode register A11=0 in MR1, DM/TDQS will
provide the data mask function and TDQS is not used. X4/X16 DRAMs must disable the
TDQS function via mode register A11=0 in MR1
SA[2:0]
IN
—
These signals are tied at the system planar to either VSS or VDDSPD to configure the
serial SPD EEPROM address range.
SDA
I/O
—
This bidirectional pin is used to transfer data into or out of the SPD EEPROM. A resistor
must be connected from the SDA bus line to VDDSPD on the system planar to act as a
pullup.
SCL
IN
—
This signal is used to clock data into and out of the SPD EEPROM. A resistor may be con-
nected from the SCL bus time to VDDSPD on the system planar to act as a pullup.
EVENT
OUT
(open
drain)
Active Low
This signal indicates that a thermal event has been detected in the thermal sensing
device.The system should guarantee the electrical level requirement is met for the
EVENT pin on TS/SPD part.
No pull-up resister is provided on DIMM.
VDDSPD
Supply
Serial EEPROM positive power supply wired to a separate power pin at the connector
which supports from 3.0 Volt to 3.6 Volt (nominal 3.3V) operation.
RESET
IN
The RESET pin is connected to the RESET pin on the register and to the RESET pin on
the DRAM.
Par_In
IN
Parity bit for the Address and Control bus. (“1 “: Odd, “0 “: Even)
Err_Out
OUT
(open
drain)
Parity error detected on the Address and Control bus. A resistor may be connected from
Err_Out bus line to VDD on the system planar to act as a pull up.
TEST
Used by memory bus analysis tools (unused (NC) on memory DIMMs)
Symbol
Type
Polarity
Function
相關PDF資料 |
PDF描述 |
|---|---|
| HN4400 | NPN EXPITAXIAL SILICON TRANSISTOR |
| HN5400 | PNP Silicon Expitaxial Planar Transistor for general purpose, high voltage amplifier applications |
| HN5401 | PNP Silicon Expitaxial Planar Transistor for general purpose, high voltage amplifier applications |
| HN546 | NPN Silicon Epitaxial Planar Transistor |
| HN547 | NPN Silicon Epitaxial Planar Transistor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HMT351V7BMR4C-G7 | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:240pin DDR3 SDRAM VLP Registered DIMM |
| HMT351V7BMR4C-H9 | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:240pin DDR3 SDRAM VLP Registered DIMM |
| HMT351V7BMR8C-G7 | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:240pin DDR3 SDRAM VLP Registered DIMM |
| HMT351V7BMR8C-H9 | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:240pin DDR3 SDRAM VLP Registered DIMM |
| HMT351V7CFR4A | 制造商:HYNIX 制造商全稱:Hynix Semiconductor 功能描述:DDR3L SDRAM VLP Registered DIMM Based on 2Gb C-die |
發布緊急采購，3分鐘左右您將得到回復。