HYB18T256400/800/160AF
256Mb DDR2 SDRAM
INFINEON Technologies
Page 63 Rev. 1.02 May 2004
4. Operating Conditions
4.1 Absolute Maximum Ratings
4.2 DRAM Component Operating Temperature Range
Symbol
Parameter
Rating
Units
Notes
VDD
Voltage on VDD pin relative to VSS
-1.0 to + 2.3
V
1
VDDQ
Voltage on VDDQ pin relative to VSS
-0.5 to + 2.3
V
1
VDDL
Voltage on VDDL pin relative to VSS
-0.5 to + 2.3
V
1
VIN, VOUT Voltage on any pin relative to VSS
-0.5 to + 2.3
V
1
TSTG
Storage Temperature
-55 to + 100
°
C
1, 2
1. Stresses greater than those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a
stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational
sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reli-
ability.
2. Storage Temperature is the case surface temperature on the center/top side of the DRAM. For the measurement conditions,
please refer to JESD51-2 standard.
Symbol
Parameter
Rating
Units
Notes
TOPER
Operating Temperature
0 to 95
o
C
1 ~ 4
1. Operating Temperature is the case surface temperature on the center / top side of the DRAM. For measurement conditions,
please refer to the JEDEC document JESD51-2.
2. The operating temperature range are the temperatures where all DRAM specification will be supported. During operation, the
DRAM case temperature must be maintained between 0 - 95
o
C under all other specification parameters.
3. Some application may require to operate the DRAM up to 95
o
C case temperature. In this case above 85
o
C case temperature the
Auto-Refresh command interval has to be reduced to tREFI = 3.9 μs.
4. Self-Refresh period is hard-coded in the chip and therefore it is imperative that the system ensures the DRAM is below 85
o
C case
temperature before initiating self-refresh operation.