參數資料
型號: MT80C51T-36D
廠商: TEMIC SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 36 MHz, MICROCONTROLLER, PQFP44
文件頁數: 134/189頁
文件大小: 4133K
代理商: MT80C51T-36D
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁當前第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁
66
ATtiny4/5/9/10 [DATASHEET]
8127F–AVR–02/2013
Figure 11-10. Phase Correct PWM Mode, Timing Diagram
The Timer/Counter Overflow Flag (TOV0) is set each time the counter reaches BOTTOM. When either OCR0A or
ICR0 is used for defining the TOP value, the OC0A or ICF0 flag is set accordingly at the same timer clock cycle as
the OCR0x Registers are updated with the double buffer value (at TOP). The interrupt flags can be used to gener-
ate an interrupt each time the counter reaches the TOP or BOTTOM value.
When changing the TOP value the program must ensure that the new TOP value is higher or equal to the value of
all of the Compare Registers. If the TOP value is lower than any of the Compare Registers, a compare match will
never occur between the TCNT0 and the OCR0x. Note that when using fixed TOP values, the unused bits are
masked to zero when any of the OCR0x Registers are written. As the third period shown in Figure 11-10 on page
66 illustrates, changing the TOP actively while the Timer/Counter is running in the phase correct mode can result in
an unsymmetrical output. The reason for this can be found in the time of update of the OCR0x Register. Since the
OCR0x update occurs at TOP, the PWM period starts and ends at TOP. This implies that the length of the falling
slope is determined by the previous TOP value, while the length of the rising slope is determined by the new TOP
value. When these two values differ the two slopes of the period will differ in length. The difference in length gives
the unsymmetrical result on the output.
It is recommended to use the phase and frequency correct mode instead of the phase correct mode when chang-
ing the TOP value while the Timer/Counter is running. When using a static TOP value there are practically no
differences between the two modes of operation.
In phase correct PWM mode, the compare units allow generation of PWM waveforms on the OC0x pins. Setting
the COM0x1:0 bits to two will produce a non-inverted PWM and an inverted PWM output can be generated by set-
ting the COM0x1:0 to three (See Table 11-4 on page 73). The actual OC0x value will only be visible on the port pin
if the data direction for the port pin is set as output (DDR_OC0x). The PWM waveform is generated by setting (or
clearing) the OC0x Register at the compare match between OCR0x and TCNT0 when the counter increments, and
clearing (or setting) the OC0x Register at compare match between OCR0x and TCNT0 when the counter decre-
ments. The PWM frequency for the output when using phase correct PWM can be calculated by the following
equation:
OCRnx/TOP Update and
OCnA Interrupt Flag Set
or ICFn Interrupt Flag Set
(Interrupt on TOP)
1
2
3
4
TOVn Interrupt Flag Set
(Interrupt on Bottom)
TCNTn
Period
OCnx
(COMnx1:0 = 2)
(COMnx1:0 = 3)
f
OCnxPCPWM
f
clk_I/O
2N TOP
-----------------------------
=
相關PDF資料
PDF描述
MS80C31-12R 8-BIT, 12 MHz, MICROCONTROLLER, PQCC44
MT80C51C-12D 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP44
MS80C31-20R 8-BIT, 20 MHz, MICROCONTROLLER, PQCC44
MV80C51T-16D 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP44
MP80C31-30D 8-BIT, 30 MHz, MICROCONTROLLER, PDIP40
相關代理商/技術參數
參數描述
MT80GB 制造商:Datak Corporation 功能描述:
MT80JSF1G72NDY-1G1F1A2 制造商:Micron Technology Inc 功能描述:8GB 1GX72 DDR3 SDRAM MODULE PBF DIMM 1.5V REGISTERED - Trays
MT80KSF1G72NDY-1G4F1A3 制造商:Micron Technology Inc 功能描述:8GB 1GX72 DDR3 SDRAM MODULE PBF DIMM 1.35V FULLY BUFFERED - Trays
MT810 制造商:MARKTECH 制造商全稱:Marktech Corporate 功能描述:STANDARD T-1 3/4 LED LAMPS
MT-8100 制造商:Eclipse Tools 功能描述: