參數資料
型號： SC16IS741IPW
廠商： NXP SEMICONDUCTORS
元件分類： 微控制器/微處理器
英文描述： Single UART with I2C-bus-SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support
中文描述： 1 CHANNEL(S), 5M bps, I2C BUS CONTROLLER, PDSO16
封裝： 4.40 MM, PLASTIC, MO-153, SOT403-1, TSSOP-16
文件頁數： 29/52頁
文件大?。?/td> 382K
代理商： SC16IS741IPW
SC16IS741_1
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 01 — 29 April 2010
29 of 52
NXP Semiconductors
SC16IS741
Single UART with I
2
C-bus/SPI interface, 64-byte FIFOs, IrDA SIR
8.15 Receiver FIFO Level register (RXLVL)
This register is a read-only register, it reports the fill level of the receive FIFO. That is, the
number of characters in the RX FIFO.
Table 26.
Bit
7
6:0
8.16 Extra Features Control Register (EFCR)
Table 27.
Bit
7
Receiver FIFO Level register bits description
Symbol
Description
-
not used; set to zeros
RXLVL[6:0]
number of characters stored in RX FIFO, from 0 (0x00) to 64 (0x40)
Extra Features Control Register bits description
Symbol
Description
IRDA MODE
IrDA mode
0 = IrDA SIR,
3
16
pulse ratio, data rate up to 115.2 kbit/s
-
reserved
RTSINVER
invert RTS signal in RS-485 mode
0: RTS = 0 during transmission and RTS = 1 during reception
1: RTS = 1 during transmission and RTS = 0 during reception
RTSCON
enable the transmitter to control the RTS pin
0 = transmitter does not control RTS pin
1 = transmitter controls RTS pin
6
5
4
3
2
-
TXDISABLE
reserved
Disable transmitter. UART does not send serial data out on the
transmit pin, but the transmit FIFO will continue to receive data from
host until full. Any data in the TSR will be sent out before the
transmitter goes into disable state.
0: transmitter is enabled
1: transmitter is disabled
Disable receiver. UART will stop receiving data immediately once this
bit set to a 1, and any data in the TSR will be sent to the receive FIFO.
User is advised not to set this bit during receiving.
0: receiver is enabled
1: receiver is disabled
Enable 9-bit or Multidrop mode (RS-485).
0: normal RS-232 mode
1: enables RS-485 mode
1
RXDISABLE
0
9-BIT MODE
相關PDF資料
PDF描述
SC16IS752IBS Dual UART with I2C-bus-SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support
SC16IS752IPW Dual UART with I2C-bus-SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support
SC16IS762IBS Dual UART with I2C-bus-SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support
SC16IS762IPW Dual UART with I2C-bus-SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support
SC5R5153Z 2.7V/2.0F Primary or back-up power supply for video, audio
相關代理商/技術參數
參數描述
SC16IS741IPW,112 功能描述:UART 接口集成電路 IC UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16IS741IPW,118 功能描述:UART 接口集成電路 SINGLE UART W/ 12C-BUS/SPI INTERFC RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16IS741IPW,128 功能描述:UART 接口集成電路 IC UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16IS74Q900 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single UART with I2C-bus/SPI interface, 64 bytes of transmit and receive FIFOs
SC16IS750 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single UART with I2C-bus/SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*