- 您現在的位置：買賣IC網 > PDF目錄98285 > TPS650732TRSLRQ1 (TEXAS INSTRUMENTS INC) POWER SUPPLY SUPPORT CKT, PQCC48 PDF資料下載
參數資料
| 型號： | TPS650732TRSLRQ1 |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 電源管理 |
| 英文描述： | POWER SUPPLY SUPPORT CKT, PQCC48 |
| 封裝： | 6 X 6 MM, 0.4 MM PITCH, GREEN, PLASTIC, QFN-48 |
| 文件頁數： | 64/90頁 |
| 文件大小： | 1375K |
| 代理商： | TPS650732TRSLRQ1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁當前第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁
www.ti.com
SLVSAP7 – JANUARY 2011
Other inductors, with lower or higher inductance values can be used. A higher inductance will cause a lower
inductor current ripple and therefore will provide higher efficiency. The boost converter will also stay in
continuous conduction mode over a wider load current range. The energy stored in an inductor is given by
E=1/2L × I2 where I is the peak inductor current. The maximum current in the inductor is limited by the internal
current limit of the device, so the maximum power is given by the minimum peak current limit (see electrical
specifications) times the inductance value. For highest output power, a large inductance value is needed. The
minimum inductor value possible is limited by the energy needed to supply the load. The limit for the minimum
inductor value is given during the on-time of the switch such that the current limit is not reached.
Example for the minimum inductor value:
Vin = 4.2 V, Vout = 19.7 V, Iout = 5 mA, Vsw =0.1 V
→ D = 79%
→ ton = 703 ns
During the on-time, the inductor current should not reach the current limit of 1.4 A.
With V… voltage across the inductor (V = Vin–Vsw)
→ L = V × dt/di = (4.2 V–0.1 V) × 703ns/1.4A = 2mH
Diode Selection
Due to the non-synchronous design of the boost converter, an external diode is needed. For best performance, a
Schottky diode with a voltage rating of 40V or above should be used. A diode such as the MBR0540 with an
average current rating of 0.5A is sufficient.
Output Capacitor Selection
A ceramic capacitor such as X5R or X7R type is required at the output. See Table 7 for reference.
Table 7. Tested Capacitor
TYPICAL VOLTAGE
LED
CAPACITOR
ACROSS OUTPUT
CAPACITOR TYPE
MANUFACTURER
CONFIGURATION
VALUE
SIZE
CAPACITOR
2x6LEDs or 1x6LEDs
21 V
4.7 mF / 50 V
1206
UMK316BJ475KL
Taiyo Yuden
1x10LEDs
35 V
4.7 mF / 50 V
1210
GRM32ER71H475KA
Murata
Input Capacitor Selection
A small ceramic input capacitor of 10 mF is needed at the input of the boost converter. If the inductor is directly
connected to the SYS output of , the capacitor can be shared. In this case the capacitance needs to be 22mF or
above. Only X5R or X7R ceramic capacitors should be used.
BATTERY CHARGER
Temperature Sensing
The battery charger integrated in has an over temperature protection for the Li-ion cell. The temperature is
sensed with a NTC located at the battery. Comparators in suspend charge at a temperature below 0°C and
above 45°C. The charger supports two different resistor values for the NTC. The default is internally programmed
to 10k. It is possible to change to a 100k NTC with the I2C interface.
Table 8. NTCs Supported
RESISTANCE AT 25°C
CURVE / B VALUE
RT2 NEEDED FOR
MANUFACTURER
LINEARIZATION
10k
Curve 2 / B=3477
75k
Several
100k
Curve 1 / B=3964
370k
Several
Copyright 2011, Texas Instruments Incorporated
67
相關PDF資料 |
PDF描述 |
|---|---|
| TPS65110RGEG3 | SWITCHED CAPACITOR REGULATOR, 520 kHz SWITCHING FREQ-MAX, PQCC24 |
| TPS65130RGER | 0.9 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PQCC24 |
| TPS65130RGET | 0.9 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PQCC24 |
| TPS65131RGETG4 | 2.2 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PQCC24 |
| TPS65130RGE | 0.9 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PQCC24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS65073EVM-430 | 功能描述:電源管理IC開發工具 TPS65073 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS65073RSLR | 功能描述:PMIC 解決方案 5Ch Pwr Mgmt IC RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| TPS65073RSLT | 功能描述:PMIC 解決方案 5Ch Pwr Mgmt IC RoHS:否 制造商:Texas Instruments 安裝風格:SMD/SMT 封裝 / 箱體:QFN-24 封裝:Reel |
| TPS650830EVM-095 | 功能描述:TPS650830 - Power Management, Special Purpose: Mobiles Evaluation Board 制造商:texas instruments 系列:- 零件狀態:有效 主要用途:電源管理，專用型： 手機 嵌入式:- 使用的 IC/零件:TPS650830 主要屬性:- 輔助屬性:圖形用戶接口，I2C 接口 所含物品:板 標準包裝:1 |
| TPS650830ZAJT | 功能描述:- Converter, Mobile PCs Voltage Regulator IC 8 Output 168-NFBGA (7x7) 制造商:texas instruments 系列:- 包裝:剪切帶（CT） 零件狀態:有效 應用:轉換器，移動式個人電腦 電壓 - 輸入:5.4 V ~ 24 V 輸出數:8 電壓 - 輸出:多重 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:168-TFBGA 供應商器件封裝:168-NFBGA（7x7） 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。