
CHAPTER 7 16-BIT TIMER/EVENT COUNTERS 00 TO 05
User
’
s Manual U15862EJ3V0UD
311
0
Output disabled
Output enabled
OSPT0m
Note 1
0
1
Control of output trigger for one-shot pulse by software
TOC0n
OSPT0m
Note 1
OSPE0m
Note 1
TOC0n4
LVS0n
LVR0n
TOC0n1
TOE0n
Successive pulse output
One-shot pulse output
Note 2
OSPE0m
Note 1
0
1
Control of one-shot pulse output operation
Inversion operation disabled
Inversion operation enabled
TOC0n4
0
1
Control of timer output F/F upon match of CR0n1 register and TM0n register
Inversion operation disabled
Inversion operation enabled
TOC0n1
0
1
Control of timer output F/F upon match of CR0n0 register and TM0n register
Output disabled (output is fixed to 0 level)
Output enabled
TOE0n
0
1
Control of output of 16-bit timer/event counter 0n
Unchanged
Reset timer output F/F (0)
Set timer output F/F (1)
Setting prohibited
LVS0n
0
0
1
1
Setting of status of timer output F/F of 16-bit timer/event counter 0n
LVR0n
0
1
0
1
After reset: 00H R/W Address: FFFFF609H, FFFFF619H, FFFFF629H
FFFFF639H, FFFFF649H, FFFFF659H
(n = 0 to 5
m = 0, 1, 4, 5
k = 4, 5)
7
6
5
4
3
2
1
0
Notes 1.
When using TM02 and TM03, be sure to set bits 5 and 6 to 0. When using TM00 and TM01,
since the valid edges of the TI000 and TI010 pins cannot be used, set the TMC0n bit of the
TMC00 and TMC01 registers to 0.
2.
The one-shot pulse output operates normally in the free-running mode and the mode in which
clear & start occurs on the valid edge of TI0k0. In the mode in which clear & start occurs on
match between the TM0m register and the CR0m0 register, one-shot pulse output is not
performed because no overflow occurs.
Cautions 1. Be sure to stop the timer operation before setting other than the TOC0n4 bit.
2. The LVS0n and LVR0n bits are 0 when read after data has been set to them.
3. The OSPT0m bit is 0 when read because it is automatically cleared after data has
been set.
4. Do not set (to 1) the OSPT0m bit other than for one-shot pulse output.
5. When performing successive writes to the OSPT0m bit, place an interval between
writes of two or more operating clocks.