- 您現在的位置：買賣IC網 > PDF目錄376462 > XRT75VL00IV (EXAR CORP) E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR PDF資料下載
參數資料
| 型號： | XRT75VL00IV |
| 廠商： | EXAR CORP |
| 元件分類： | 數字傳輸電路 |
| 英文描述： | E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR |
| 中文描述： | DATACOM, PCM TRANSCEIVER, PQFP52 |
| 封裝： | 10 X 10 MM, TQFP-52 |
| 文件頁數： | 11/50頁 |
| 文件大小： | 268K |
| 代理商： | XRT75VL00IV |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁
XRT75VL00
REV. 1.0.3
E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
9
OPERATING MODE SELECT
P
IN
#
S
IGNAL
N
AME
T
YPE
D
ESCRIPTION
21
HOST/(HW)
I
HOST/Hardware Mode Select:
Tie this pin “High” to configure
the XRT75VL00 in HOST mode. Tie this “Low” to
configure in Hardware mode.
When the XRT75VL00 is configured in HOST mode, the states of many discrete
input pins are ignored.
N
OTE
:
This pin is internally pulled up.
20
E3
I
E3 Mode Select Input
A "High" on this pin configures to operate in the E3 mode.
A "Low" on this pin configures to operate in either STS-1 or DS3 mode depend-
ing on the setting on pin 19.
N
OTES
:
1.
This pin is internally pulled down
2.
This pin is ignored and may be tied to GND if the XRT75VL00 is
configured to operate in HOST mode.
19
STS-1/DS3
I
STS-1/DS3 Select Input
A “High” on this pin configures to operate in STS-1 mode.
A “Low” on this pin configures to operate in DS3 mode.
This pin is ignored if the E3 pin is set to “High”.
N
OTES
:
1.
This pin is internally pulled down
2.
This pin is ignored and may be tied to GND if the XRT75VL00 is
configured to operate in HOST mode.
22
SR/DR
I
Single-Rail/Dual-Rail Select:
Setting this “High” configures both the Transmitter and Receiver to operate in
Single-rail mode and also enables the B3ZS/HDB3 Encoder and Decoder. In
Single-rail mode, Transmit input at TNData should be grounded.
Setting this “Low” configures both the Transmitter and Receiver to operate in
Dual-rail mode and disables the B3ZS/HDB3 Encoder and Decoder.
N
OTE
:
This pin is internally pulled down.
CONTROL AND ALARM INTERFACE
42
MRING
I
Monitor Ring Input
The bipolar line output signal from TRING is connected to this pin via a 270
resistor to check for line driver failure.
N
OTE
:
This pin is internally pulled down.
41
MTIP
I
Monitor Tip Input
The bipolar line output signal from TTIP is connected to this pin via a 270-ohm
resistor to check for line driver failure.
N
OTE
:
This pin is internally pulled down.
40
DMO
O
Drive Monitor Output
If MTIP and MRING has no transition pulse for 128 ± 32 TxClk cycles, DMO
goes “High” to indictae the driver failure. DMO output stays “High” until the next
AMI signal is detected.
相關PDF資料 |
PDF描述 |
|---|---|
| XRT79L71 | 1 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC |
| XRT79L71IB | 1 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC |
| XRT79L72 | 2 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC |
| XRT79L72IB | 2 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC |
| XRT79L73 | 3 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT75VL00IV-F | 功能描述:外圍驅動器與原件 - PCI 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT75VL00IVTR | 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| XRT75VL00IVTR-F | 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| XRT79L71 | 制造商:EXAR 制造商全稱:EXAR 功能描述:1-CHANNEL DS3/E3 ATM UNI/PPP/CLEAR-CHANNEL FRAMER IC - |
| XRT79L71_07 | 制造商:EXAR 制造商全稱:EXAR 功能描述:1-CHANNEL DS3/E3 ATM UNI/PPP/CLEAR-CHANNEL FRAMER IC - HARDWARE |
發布緊急采購，3分鐘左右您將得到回復。