- 您現在的位置：買賣IC網 > PDF目錄376462 > XRT75VL00IV (EXAR CORP) E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR PDF資料下載
參數資料
| 型號： | XRT75VL00IV |
| 廠商： | EXAR CORP |
| 元件分類： | 數字傳輸電路 |
| 英文描述： | E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR |
| 中文描述： | DATACOM, PCM TRANSCEIVER, PQFP52 |
| 封裝： | 10 X 10 MM, TQFP-52 |
| 文件頁數： | 12/50頁 |
| 文件大?。?/td> | 268K |
| 代理商： | XRT75VL00IV |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁
XRT75VL00
E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
REV. 1.0.3
10
30
RLOS
O
Receive Loss of Signal Output Indicator
This output pin toggles "High" if Receiver has detected a Loss of Signal Condi-
tion in the incoming line signal.
The criteria for declaring/clearing an LOS Condition depends upon whether it is
operating in the E3 or STS-1/DS3 Mode and is described in Section 2.04.
29
RLOL
O
Receive Loss of Lock Output Indicator:
This output pin toggles "High" if the XRT75VL00 has detected a Loss of Lock
Condition. LOL (Loss of Lock) condition is declared if the recovered clock fre-
quency deviates from the Reference Clock frequency (available at ExClk input
pin) by more than 0.5%.
33
Rext
****
External Bias control Resistor of 3.3 K
±1%.
Should be connected to RefAGND via 3.3 K
resistor.
15
TEST
I
Test Mode:
Connect this pin “High” to configure the XRT75VL00 in test mode.
N
OTE
:
This pin is internally pulled Down.
16
ICT
I
In-Circuit Test Input
:
Setting this pin "Low" causes all digital and analog outputs to go into a high-
impedance state to allow for in-circuit testing. For normal operation, set this pin
"High".
N
OTE
:
This pin is internally pulled “High".
2
TAOS
I
Transmit All Ones Select
A “High" on this pin causes the Transmitter Section to generate and transmit a
continuous AMI all “1’s” pattern onto the line. The frequency of this “1’s” pattern
is determined by TxClk.
N
OTES
:
1.
This input pin is ignored if the XRT75VL00 is operating in the HOST
Mode and should be tied to GND.
2.
Analog Loopback and Remote Loopback have priority over request.
3.
This pin is internally pulled down.
28
LOSMUT/
INT
I/O
MUTE-upon-LOS Enable Input or Interrupt Ouput:
In Hardware Mode, setting this pin “High” configures the XRT75VL00 to Mute
the recovered data on the RPOS and RNEG whenever an LOS condition is
declared. RPOS and RNEG outputs are pulled “Low”.
N
OTE
:
If the XRT75VL00 is configured in HOST mode, this pin functions as
INT pin (please refer to the pin description for the Microprocessor
Interface).
CONTROL AND ALARM INTERFACE
相關PDF資料 |
PDF描述 |
|---|---|
| XRT79L71 | 1 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC |
| XRT79L71IB | 1 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC |
| XRT79L72 | 2 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC |
| XRT79L72IB | 2 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC |
| XRT79L73 | 3 - CHANNEL DS3/E3 ATM UNI/PPP COMBO IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT75VL00IV-F | 功能描述:外圍驅動器與原件 - PCI 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT75VL00IVTR | 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| XRT75VL00IVTR-F | 功能描述:時鐘合成器/抖動清除器 3.3V 1 CH E3/DS3/STS W/JITTER ATTEN RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| XRT79L71 | 制造商:EXAR 制造商全稱:EXAR 功能描述:1-CHANNEL DS3/E3 ATM UNI/PPP/CLEAR-CHANNEL FRAMER IC - |
| XRT79L71_07 | 制造商:EXAR 制造商全稱:EXAR 功能描述:1-CHANNEL DS3/E3 ATM UNI/PPP/CLEAR-CHANNEL FRAMER IC - HARDWARE |
發布緊急采購，3分鐘左右您將得到回復。