- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C960 (Advanced Micro Devices, Inc.) PCnetTM-ISA Single-Chip Ethernet Controller PDF資料下載
參數資料
| 型號： | AM79C960 |
| 廠商： | Advanced Micro Devices, Inc. |
| 英文描述： | PCnetTM-ISA Single-Chip Ethernet Controller |
| 中文描述： | PCnetTM -的ISA單芯片以太網控制器 |
| 文件頁數： | 18/127頁 |
| 文件大小： | 814K |
| 代理商： | AM79C960 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁
P R E L I M I N A R Y
AMD
1-360
Am79C960
BPCS
Boot PROM Chip Select
This signal is asserted when the Boot PROM is read. If
SA0-19 lines match a predefined address block and
SMEMR
is active and
REF
inactive, the
BPCS
signal will
be asserted. The outputs of the external Boot PROM
drive the PROM Data Bus. The PCnet-ISA controller
buffers the contents of the PROM data bus and drives
them on the lower eight bits of the System Data Bus.
Output
DXCVR
Disable Transceiver
This pin disables the transceiver. The DXCVR output is
configured in the initialization sequence. A HIGH level
indicates the Twisted Pair port is active and the AUI port
is inactive, or SLEEP mode has been entered. A LOW
level indicates the AUI port is active and the Twisted Pair
port is inactive.
Output
IOAM0-1
Input/Output Address Map
These inputs configure I/O address space for the
PCnet-ISA controller and memory address space for the
optional Remote Boot PROM with user selectable jump-
ers. The pins are pulled HIGH internally. The SA1-9
inputs are used for I/O address comparisons and the
SA
1
4-19 inputs are used for Boot PROM matching.
Input
IOAM1,0
I/O Base
Memory Base
0 0
300 Hex
C8000 Hex
0 1
320 Hex
CC000 Hex
1 0
340 Hex
D0000 Hex
1 1
360 Hex
D4000 Hex
LED0-3
LED Drivers
These pins sink 12 mA each for driving LEDs. Their
meaning is software configurable (see section ISA Bus
Configuration Registers) and they are active LOW.
Output
When EADI mode is selected, the pins named
LED1
,
LED2
, and
LED3
change in function while
LED0
contin-
ues to indicate 10BASE-T Link Status. The MAUSEL
input becomes the
EAR
input.
LED
EADI Function
1
SF/BD
2
SRD
3
SRDCLK
MAUSEL/
EAR
MAU Select/
External Address Reject
This pin selects the 10BASE-T MAU when HIGH and
the AUI interface when LOW if the XMAUSEL register
bit in ISACSR2 (ISA Configuration Register) is set. If the
XMAUSEL register bit is cleared, the MAUSEL pin is ig-
nored and the network interface is software selected.
This pin has a default value of HIGH if left unconnected.
Input
If EADI mode is selected, this pin becomes the
EAR
input. The incoming frame will be checked against the
internally active address detection mechanisms and the
result of this check will be OR’d with the value on the
EAR
pin. The
EAR
pin is defind as
REJECT
. See the
EADI section for details regarding the function and tim-
ing of this signal.
PRDB0-7
Private Data Bus
This is the data bus for the Boot PROM and the Address
PROM.
Input
SLEEP
Sleep
When
SLEEP
pin is asserted (active LOW), the PCnet-
ISA controller performs an internal system reset and
proceeds into a power savings mode. All outputs will be
placed in their normal reset condition. All PCnet-ISA
controller inputs will be ignored except for the
SLEEP
pin itself. Deassertion of
SLEEP
results in wake-up.
The system must delay the starting of the network con-
troller by 0.5 seconds to allow internal analog circuits to
stabilize.
Input
TE
Test Enable
This pin is for factory use only. It has a default value of
HIGH if left unconnected. It is recommended that this pin
always be connected to V
DD
.
Input
XTAL1
Crystal Connection
The internal clock generator uses a 20 MHz crystal that
is attached to pins XTAL1 and XTAL2. Alternatively, an
external 20 MHz CMOS-compatible clock signal can be
used to drive this pin. Refer to the section on External
Crystal Characteristics for more details.
Input
XTAL2
Crystal Connection
The internal clock generator uses a 20 MHz crystal that
is attached to pins XTAL1 and XTAL2. If an external
clock is used, this pin should be left unconnected.
Output
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C960KC | PCnetTM-ISA Single-Chip Ethernet Controller |
| AM79C960KCW | PCnetTM-ISA Single-Chip Ethernet Controller |
| AM79C961AKCW | PCnet ⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
| AM79C961AKC | PCnet ⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
| AM79C961A | PCnet ⑩-ISA II Jumperless, Full Duplex Single-Chip Ethernet Controller for ISA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C960KC | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnetTM-ISA Single-Chip Ethernet Controller |
| AM79C960KC/W | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LAN Node Controller |
| AM79C960KCW | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnetTM-ISA Single-Chip Ethernet Controller |
| AM79C961 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Am79C961 - PCnet-ISA+ Jumperless Single-Chip Ethernet Controller for ISA |
| AM79C961/AM79C961A | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Using the Am79C961/Am79C961A (PCnet-ISA+/PCnet-ISA II) Survival Guide? 134KB (PDF) |
發布緊急采購，3分鐘左右您將得到回復。