參數資料
型號： ISP1362
廠商： NXP Semiconductors N.V.
英文描述： Single-chip Universal Serial Bus On-The-Go controller
中文描述： 單芯片通用串行總線和On - The - Go控制器
文件頁數： 89/150頁
文件大?。?/td> 647K
代理商： ISP1362
Philips Semiconductors
ISP1362
Single-chip USB OTG controller
Product data
Rev. 03
—
06 January 2004
89 of 150
9397 750 12337
Koninklijke Philips Electronics N.V. 2004. All rights reserved.
9
LSDA
On read
—
LowSpeedDeviceAttached:
This bit indicates the
speed of the device attached to this port. When set, a low-speed
device is attached to this port. When cleared, a full-speed device is
attached to this port. This
fi
eld is valid only when
CurrentConnectStatus (CCS) is set.
0
—
full-speed device attached
1
—
low-speed device attached
On write
—
ClearPortPower:
The HCD clears the PortPowerStatus
(PPS) bit by writing logic 1 to this bit. Writing logic 0 has no effect.
On read
—
PortPowerStatus:
This bit re
fl
ects the port power
status, regardless of the type of power switching implemented.
This bit is cleared if an overcurrent condition is detected. The HCD
sets this bit by writing SetPortPower or SetGlobalPower. The HCD
clears this bit by writing ClearPortPower or ClearGlobalPower.
PowerSwitchingMode (PCM) and PortPowerControlMask[NDP]
(PPCM[NDP]) determine which power control switches are
enabled. In the global switching mode (PowerSwitchingMode = 0),
only the Set/ClearGlobalPower command controls this bit. In the
per-port power switching (PowerSwitchingMode = 1), if the
PortPowerControlMask[NDP] (PPCM[NDP]) bit for the port is set,
only Set/ClearPortPower commands are enabled. If the mask is
not set, only Set/ClearGlobalPower commands are enabled. When
port power is disabled, CurrentConnectStatus (CCS),
PortEnableStatus (PES), PortSuspendStatus (PSS) and
PortResetStatus (PRS) should be reset.
8
PPS
0
—
port power is OFF
1
—
port power is ON
On write
—
SetPortPower:
The HCD writes logic 1 to set the
PortPowerStatus (PPS) bit. Writing logic 0 has no effect.
Remark:
This bit always reads logic 1 if power switching is not
supported.
reserved
7 to 5
-
Table 62:
Bit
HcRhPortStatus[1:2] register: bit description
…
continued
Symbol
Description
相關PDF資料
PDF描述
ISP1362BD Single-chip Universal Serial Bus On-The-Go controller
ISP1362EE Single-chip Universal Serial Bus On-The-Go controller
ISP1501 Hi-Speed Universal Serial Bus peripheral transceiver
ISP1520 Hi-Speed Universal Serial Bus hub controller
ISP1520BD Hi-Speed Universal Serial Bus hub controller
相關代理商/技術參數
參數描述
ISP1362BD 功能描述:USB 接口集成電路 USB OTG CONTROLLER RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1362BD,118 功能描述:USB 接口集成電路 USB OTG CONTROLLER RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1362BD,151 功能描述:USB 接口集成電路 USB OTG CONTROLLER RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1362BD,157 功能描述:USB 接口集成電路 USB OTG CONTROLLER RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20
ISP1362BD157 制造商:NXP Semiconductors 功能描述:IC CONTROLLER USB-OTG 64LQFP 制造商:ST-Ericsson 功能描述:IC CONTROLLER USB OTG 64-LQFP
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*