![](http://datasheet.mmic.net.cn/30000/MQ83C154DXXX-25-883R_datasheet_2377229/MQ83C154DXXX-25-883R_475.png)
475
6384E–ATARM–05-Feb-10
AT91SAM9G20
Figure 32-14. Asynchronous Start Bit Detection
The receiver is activated and starts Preamble and Frame Delimiter detection, sampling the data
at one quarter and then three quarters. If a valid preamble pattern or start frame delimiter is
detected, the receiver continues decoding with the same synchronization. If the stream does not
match a valid pattern or a valid start frame delimiter, the receiver re-synchronizes on the next
valid edge.The minimum time threshold to estimate the bit value is three quarters of a bit time.
If a valid preamble (if used) followed with a valid start frame delimiter is detected, the incoming
stream is decoded into NRZ data and passed to USART for processing.
Figure 32-15 illustrates
Manchester pattern mismatch. When incoming data stream is passed to the USART, the
receiver is also able to detect Manchester code violation. A code violation is a lack of transition
in the middle of a bit cell. In this case, MANE flag in US_CSR register is raised. It is cleared by
writing the Control Register (US_CR) with the RSTSTA bit at 1. See
Figure 32-16 for an exam-
ple of Manchester error detection during data phase.
Figure 32-15. Preamble Pattern Mismatch
Figure 32-16. Manchester Error Flag
Manchester
encoded
data
Txd
1234
Sampling
Clock
(16 x)
Start
Detection
Manchester
encoded
data
Txd
SFD
DATA
Preamble Length is set to 8
Preamble Mismatch
invalid pattern
Preamble Mismatch
Manchester coding error
Manchester
encoded
data
Txd
SFD
Preamble Length
is set to 4
Elementary character bit time
Manchester
Coding Error
detected
sampling points
Preamble subpacket
and Start Frame Delimiter
were successfully
decoded
Entering USART character area