- 您現在的位置：買賣IC網 > PDF目錄383645 > MT9076 (Mitel Networks Corporation) T1/E1/J1 3.3V Single Chip Transceiver PDF資料下載
參數資料
| 型號： | MT9076 |
| 廠商： | Mitel Networks Corporation |
| 英文描述： | T1/E1/J1 3.3V Single Chip Transceiver |
| 中文描述： | T1/E1/J1收發3.3V的單芯片收發器 |
| 文件頁數： | 116/160頁 |
| 文件大小： | 416K |
| 代理商： | MT9076 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁當前第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁
MT9076
Preliminary Information
112
Bit
Name
Functional Description
7
1SEC
One Second Timer Status
. This bit changes state once every 0.5 second and is
synchronous with the 2SEC timer. This feature is not available when the device is operated in
freerun mode.
6
2SEC
Two Second Timer Status
. This bit changes state once every second and is synchronous
with the 1SEC timer.This feature is not available when the device is operated in freerun mode.
5
400T
400 msec. Timer Status
. This bit changes state when the 400 msec. CRC-4 multiframe
alignment timer expires.
4
8T
8 msec. Timer Status
. This bit changes state when the 8 msec. CRC-4 multiframe alignment
timer expires.
3
CALN
CRC-4 Alignment.
This bit changes state every millisecond. When CRC-4 multiframe
alignment has been achieved state changes of this bit are synchronous with the receive CRC-
4 synchronization signal.
2
KLVE
Keep Alive.
This bit is high when the AIS status bit has been high for at least 100msec. This
bit will be low when AIS goes low (I.431).
1
T1
Timer One
. This bit will be high upon loss of terminal frame synchronization persisting for 100
msec. This bit shall be low when T2 becomes high. Refer to I.431 Section 5.9.2.2.3.
0
T2
Timer Two.
This bit will be high when the MT9076 acquires terminal frame synchronization
persisting for 10 msec. This bit shall be low when non-normal operational frames are
received. I.431 Section 5.9.2.2.3.
Table 120 - Timer Status Word
(Page 3, Address 12H) (E1)
Bit
Name
Functional Description
7
RSLIP
Receive Slip
. A change of state (i.e., 1-to-0 or 0-to-1) indicates that a receive controlled
frame slip has occurred.
6
RSLPD
Receive Slip Direction
. If one, indicates that the last received frame slip resulted in a
repeated frame, i.e., system clock is faster than network clock. If zero, indicates that the
last received frame slip resulted in a lost frame, i.e., system clock is slower than network
clock. Updated on an RSLIP occurance basis.
5
RXFRM
Receive Frame Delay.
The most significant bit of the Receive Slip Buffer Phase Status
Word. If one, the delay through the receive elastic buffer is greater than one frame in
length; if zero, the delay through the receive elastic buffer is less than one frame in length.
4
AUXP
Auxiliary Pattern
. This bit will go high when a continuous 101010... bit stream (Auxiliary
Pattern) is received on the PCM 30 link for a period of at least 512 bits. If zero, auxiliary
pattern is not being received. This pattern will be decoded in the presence of a bit error
rate of as much as 10-3.
3
RxFT
Receiver Frame Toggle.
This bit toggles on the falling edge of RxTS4.
2-0
RxSBD2-0
Receive Sub Bit Delay
.
The three least significant bits of the Receive Slip Buffer Phase
Status Word. They indicate the clock, half clock and one eight clock cycle depth of the
phase status word sample point (bits 2, 1, o respectively).
Table 121 - Most Significant Phase Status Word
(Page 3, Address 13H) (E1)
相關PDF資料 |
PDF描述 |
|---|---|
| MT9076AB | T1/E1/J1 3.3V Single Chip Transceiver |
| MT9076 | T1/E1/J1 3.3V Single Chip Transceiver(T1/E1/J1 3.3V 單片收發器) |
| MT9079 | Advanced Controller for E1(先進的E1幀調節器和控制器) |
| MT9080B | SMX - Switch Matrix Module(用于消費類轉換應用的開關矩陣模塊) |
| MT90810 | Flexible MVIP(Multi-Vendor Integration Protocol) Interface Circuit(彈性MVIP接口電路) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT9076AB | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:T1/E1/J1 3.3V Single Chip Transceiver |
| MT9076AP | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:T1/E1/J1 3.3V Single Chip Transceiver |
| MT9076B | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:T1/E1/J1 3.3 V Single Chip Transceiver |
| MT9076BB | 制造商:Zarlink Semiconductor Inc 功能描述:FRAMER E1/J1/T1 3.3V 80LQFP - Trays |
| MT9076BB1 | 制造商:Zarlink Semiconductor Inc 功能描述:FRAMER E1/J1/T1 3.3V 80LQFP - Trays |
發布緊急采購，3分鐘左右您將得到回復。