- 您現在的位置：買賣IC網 > PDF目錄383645 > MT9076 (Mitel Networks Corporation) T1/E1/J1 3.3V Single Chip Transceiver(T1/E1/J1 3.3V 單片收發器) PDF資料下載
參數資料
| 型號： | MT9076 |
| 廠商： | Mitel Networks Corporation |
| 英文描述： | T1/E1/J1 3.3V Single Chip Transceiver(T1/E1/J1 3.3V 單片收發器) |
| 中文描述： | T1/E1/J1收發3.3V的單芯片收發器（T1/E1/J1收發3.3單片收發器） |
| 文件頁數： | 46/162頁 |
| 文件大小： | 427K |
| 代理商： | MT9076 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁當前第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁
MT9076
Preliminary Information
42
Figure 13 - Read and Write Pointers in the Transmit Slip Buffers
The RSLIP and RSLPD status bits (page 3H, address 13H, bits 7 and 6 respectively) give indication of a
receive slip occurance and direction. A maskable interrupt RxSLPI (page 1H, address 1BH, bit 0 - set high to
mask) is also provided. RSLIP changes state in the event of a slip. If RSLPD=0, the slip buffer has overflowed
and a frame was lost; if RSLPD=1, a underflow condition occurred and a frame was repeated.
9.2
Slip Buffer in E1 mode
In E1 mode, in addition to the elastic buffer in the jitter attenuator(JA), another elastic buffer (two frames deep)
is present, attached between the receive side and the ST-BUS side of the MT9076. This elastic buffer is
configured as a slip buffer which absorbs wander and low frequency jitter in multi-trunk applications. The
received PCM 30 data is clocked into the slip buffer with the Exclk clock and is clocked out of the slip buffer with
the C4b clock. The Exclk extracted clock is generated from, and is therefore phase-locked with, the receive
PCM 30 data. In normal operation, the C4b clock will be phase-locked to the Exclk clock by a phase locked loop
(PLL). Therefore, in a single trunk system the receive data is in phase with the Exclk clock, the C4b clock is
phase-locked to the Exclk clock, and the read and write positions of the slip buffer will remain fixed with respect
to each other.
In a multi-trunk slave or loop-timed system (i.e., PABX application) a single trunk will be chosen as a network
synchronizer, which will function as described in the previous paragraph. The remaining trunks will use the
system timing derived from the synchronizer to clock data out of their slip buffers. Even though the PCM 30
signals from the network are synchronous to each other, due to multiplexing, transmission impairments and
route diversity, these signals may jitter or wander with respect to the synchronizing trunk signal. Therefore, the
Exclk clocks of non-synchronizer trunks may wander with respect to the Exclk clock of the synchronizer and the
system bus.
Network standards state that, within limits, trunk interfaces must be able to receive error-free data in the
presence of jitter and wander (refer to network requirements for jitter and wander tolerance). The MT9076 will
allow a maximum of 26 channels (208 UI, unit intervals) of wander and low frequency jitter before a frame slip
will occur.
Write
Pointer
221 uS
4 uS
188 uS
62 uS
129 uS
512 Bit
Elastic
Store
92 uS
92 uS
Wander Tolerance
Read Pointer
Read Pointer
Read Pointer
Read Pointer
0 uS
Frame 0
Frame 1
Frame 0
Frame 1
Frame 0
Frame 1
Write Vectors
Read Vectors
Minimum Delay
Read Vectors - Maximum Delay
96 uS
相關PDF資料 |
PDF描述 |
|---|---|
| MT9079 | Advanced Controller for E1(先進的E1幀調節器和控制器) |
| MT9080B | SMX - Switch Matrix Module(用于消費類轉換應用的開關矩陣模塊) |
| MT90810 | Flexible MVIP(Multi-Vendor Integration Protocol) Interface Circuit(彈性MVIP接口電路) |
| MT90812 | Integrated Digital Switch (IDX)(集成數字開關) |
| MT90840AK | Distributed Hyperchannel Switch |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT9076AB | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:T1/E1/J1 3.3V Single Chip Transceiver |
| MT9076AP | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:T1/E1/J1 3.3V Single Chip Transceiver |
| MT9076B | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:T1/E1/J1 3.3 V Single Chip Transceiver |
| MT9076BB | 制造商:Zarlink Semiconductor Inc 功能描述:FRAMER E1/J1/T1 3.3V 80LQFP - Trays |
| MT9076BB1 | 制造商:Zarlink Semiconductor Inc 功能描述:FRAMER E1/J1/T1 3.3V 80LQFP - Trays |
發布緊急采購，3分鐘左右您將得到回復。