- 您現(xiàn)在的位置：買賣IC網 > PDF目錄373785 > ZL50018GAC (ZARLINK SEMICONDUCTOR INC) 2 K Digital Switch with Enhanced Stratum 3 DPLL PDF資料下載
參數資料
| 型號： | ZL50018GAC |
| 廠商： | ZARLINK SEMICONDUCTOR INC |
| 元件分類： | 路由/交換 |
| 英文描述： | 2 K Digital Switch with Enhanced Stratum 3 DPLL |
| 中文描述： | TELECOM, DIGITAL TIME SWITCH, PBGA256 |
| 封裝： | 17 X 17 MM, 1.61 MM HEIGHT, PLASTIC, MS-034, BGA-256 |
| 文件頁數： | 33/136頁 |
| 文件大?。?/td> | 1448K |
| 代理商： | ZL50018GAC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁
ZL50018
Data Sheet
33
Zarlink Semiconductor Inc.
7.5 External High Impedance Control Advancement
The external high impedance signals can be programmed to better match the timing required by the external
buffers. By default, the output timing of the STOHZ signals follows the programmed channel delay and bit offset of
their corresponding ST-BUS/GCI-Bus output streams. In addition, for all high impedance streams operating at any
data rate except 16.384 Mbps, the user can advance the STOHZ signals a further 0, 1/4, 1/2, 3/4 or 4/4 bits by
programming STOHZ[n]A 2 - 0 (bit 11 - 9) in the Stream Output Control Register. When the stream is operating at
16.384 Mbps, the additional STOHZ advancement can be set to 0, 1/2 or 4/4 bits by programming the same
register.
Figure 18 - Channel Switching External High Impedance Control Timing
8.0 Data Delay Through the Switching Paths
The switching of information from the input serial streams to the output serial streams results in a throughput delay.
The device can be programmed to perform timeslot interchange functions with different throughput delay
capabilities on a per-channel basis. For voice applications, select variable throughput delay to ensure minimum
delay between input and output data. In wideband data applications, select constant delay to maintain the frame
integrity of the information through the switch. The delay through the device varies according to the type of
throughput delay selected by the V/C (bit 14) in the Connection Memory Low when CMM = 0.
8.1 Variable Delay Mode
Variable delay mode causes the output channel to be transmitted as soon as possible. This is a useful mode for
voice applications where the minimum throughput delay is more important than frame integrity. The delay through
the switch can vary from 7 channels to 1 frame + 7 channels. To set the device into variable delay mode, VAREN
(bit 4) in the Control Register (CR) must be set before V/C (bit 14) in the Connection Memory Low when CMM = 0.
If the VAREN bit is not set and the device is programmed for variable delay mode, the information read on the
output stream will not be valid.
In variable delay mode, the delay depends on the combination of the source and destination channels of the input
and output streams.
CH0
CH1
CH2
CH3
Last-2 Last-1 Last
CH0
Last
HiZ
FPi
STio[n]
STOHZ[n]
(Default = No Advancement)
STOHZ[n]
(with Advancement)
STOHZ Advancement (Programmable in 4 steps of 1/4 bit
for 2.048 Mbps, 4.096 Mbps and 8.192 Mbps
Programmable in 2 steps of 1/2 bit for 16.384 Mbps)
NOTE: n = 0 to 15
NOTE: Last = Last Channel of 31, 63, 127 and 255 for 2.048 Mbps, 4.096 Mbps. 8.192 Mbps and 16.384 Mbps modes respectively.
Output Frame Boundary
相關PDF資料 |
PDF描述 |
|---|---|
| ZL50018QCC | 2 K Digital Switch with Enhanced Stratum 3 DPLL |
| ZL50019 | Enhanced 2 K Digital Switch with Stratum 4E DPLL |
| ZL50019GAC | Enhanced 2 K Digital Switch with Stratum 4E DPLL |
| ZL50019QCC | Enhanced 2 K Digital Switch with Stratum 4E DPLL |
| ZL50022 | Enhanced 4 K Digital Switch with Stratum 4E DPLL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ZL50018GAG2 | 制造商:Microsemi Corporation 功能描述:SWIT FABRIC 2K X 2K 1.8V/3.3V 256BGA - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TDM SWITCH 2K-CH ENH 256PBGA 制造商:Microsemi Corporation 功能描述:IC TDM SWITCH 2K-CH ENH 256PBGA |
| ZL50018QCC | 制造商:Microsemi Corporation 功能描述:SWIT FABRIC 2K X 2K 1.8V/3.3V 256LQFP - Trays |
| ZL50018QCG1 | 制造商:Microsemi Corporation 功能描述:PB FREE 2K+ RATE CONVERSION AND S3 DPLL - Trays 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TDM SWITCH 2K-CH ENH 256LQFP |
| ZL50019 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Enhanced 2 K Digital Switch with Stratum 4E DPLL |
| ZL50019_06 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Enhanced 2 K Digital Switch with Stratum 4E DPLL |
發(fā)布緊急采購，3分鐘左右您將得到回復。