參數資料
型號： 91C94
廠商： SMSC Corporation
英文描述： ISA/PCMCIA SINGLE CHIP ETHERNET CONTROLLER WITH RAM
中文描述： 的ISA / PCMCIA的單芯片以太網控制器與RAM
文件頁數： 104/120頁
文件大?。?/td> 447K
代理商： 91C94
84
Only when 16 retries are reached, the CSMA/CD
block will clear the TXENA bit, and CPU
intervention is required. The DMA will not
automatically restart data transfer in this case,
nor will it transmit the next enqueued packet
until TXENA is set by the CPU. The DMA will
move the packet number in question from the
TX FIFO into the TX completion FIFO.
NETWORK INTERFACE
The LAN91C94 includes both an AUI interface
for thick and thin coax applications and a
10BASE-T interface for twisted pair applications.
Functions common to both are:
1.
Manchester
encoder/decoder
to
convert
NRZ data to Manchester encoded data and
back.
2.
A
32
ms
jabber
timer
to
prevent
inadvertently
long
transmissions.
When
'jabbing' occurs, the transmitter is disabled,
automatic loopback is disabled (in 10BASE-
T mode), and a collision indication is given
to the controller.
The interface 'unjabs'
when the transmitter has been idle for a
minimum of 256 ms.
3.
A phase-lock loop to recover data and clock
from the Manchester data stream with up to
plus or minus 18ns of jitter.
4.
Diagnostic loopback capability.
5.
LED drivers for collision, transmission,
reception, and jabber.
10BASE-T
The 10BASE-T interface conforms to the twisted
pair MAU addendum to the 802.3 specification.
On the transmission side, it converts the NRZ
data from the controller to Manchester data and
provides the appropriate signal level for driving
the
media.
Signal
are
predistorted
before
transmission to minimize ISI. The collision
detection circuitry monitors the simultaneous
occurrence of received signals and transmitted
data
on
the
media.
During transmission,
data is automatically looped back to the receiver
except during collision periods, in which case
the input to the receiver is network data. During
collisions, should the receive input go idle prior
to the transmitter going idle, input to the receiver
switches back to the transmitter within 9 bit
times. Following transmission, the transmitter
performs a SQE test. This test exercises the
collision detection circuitry within the 10BASE-T
interface.
The receiver monitors the media at all times. It
recovers the clock and data and passes it along
to the controller. In the absence of any receive
activity, the transmitter is looped back to the
receiver. In addition, the receiver performs
automatic polarity correction.
The 10BASE-T
interface performs link integrity tests per section
14.2.1.7 of 802.3, using the following values:
1. Link_loss_timer: 64 ms
2. Link_test_min_timer: 4 ms
3. Link_count: 2
4. Link_test_max_timer: 64 ms
The state of the link is reflected in the EPHSR.
AUI
The LAN91C94 also provides a standard 6 wire
AUI interface to a coax transceiver.
PHYSICAL INTERFACE
The internal physical interface (PHY) consists of
an encoder/decoder (ENDEC) and an internal
10BASE-T
transceiver.
The
ENDEC
also
provides a standard 6-pin AUI interface to an
external coax transceiver for 10BASE-T and
10BASE-5 applications.
The signals between
MAC and the PHY can be routed to pins by
asserting
the
nXENDEC
pin
low.
This
feature allows the interface to an external
ENDEC and transceiver.
The PHY functions
can
be
divided
into
transmit
and
receive
functions.
相關PDF資料
PDF描述
92_TNC-50-0-4/111_NE BOARD TERMINATED, FEMALE, TNC CONNECTOR, SURFACE MOUNT, JACK
92_TNC-50-0-4/111_NM BOARD TERMINATED, FEMALE, TNC CONNECTOR, SURFACE MOUNT, JACK
92082-314 14 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT
92082-316 16 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT
92082-318 18 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT
相關代理商/技術參數
參數描述
91CCC3 制造商:Wirepro 功能描述:Connector Accessories Cap and Chain For Receptacle
91-CCC3 制造商:CDM ELECTRONIC FORMERLY WPI 功能描述:connector accessory,circular microphone,cap and chain for receptacle
91-CCC-3 制造商:Amphenol Corporation 功能描述: 制造商:TE Connectivity 功能描述:
91CR10 制造商:TT Electronics / BI Technologies 功能描述:Res Cermet Trimmer 10 Ohm 20% 1/2W 1(Elec)/1(Mech)Turn (9.53 X 9.78 X 7.11mm) Pin Thru-Hole Box
91CR100 功能描述:微調電阻 - 通孔 3/8inch 100 Thumbwheel RoHS:否 制造商:Vishay/Sfernice 產品:Trimmer Resistors - Multi Turn 產品類型:Multiturn 轉數:14 錐度:Linear 電阻:10 kOhms 電壓額定值:250 V 端接類型:Pin 功率額定值:250 mW (1/4 W) 容差:10 % 溫度系數:100 PPM / C
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*