- 您現在的位置：買賣IC網 > PDF目錄294733 > 91C94 (SMSC Corporation) ISA/PCMCIA SINGLE CHIP ETHERNET CONTROLLER WITH RAM PDF資料下載
參數資料
| 型號： | 91C94 |
| 廠商： | SMSC Corporation |
| 英文描述： | ISA/PCMCIA SINGLE CHIP ETHERNET CONTROLLER WITH RAM |
| 中文描述： | 的ISA / PCMCIA的單芯片以太網控制器與RAM |
| 文件頁數： | 108/120頁 |
| 文件大?。?/td> | 447K |
| 代理商： | 91C94 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁當前第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁
88
On EEPROM write operations (after setting the
STORE bit) the values of the CONFIGURATION
REGISTER and BASE REGISTER are written in
the EEPROM locations defined by the IOS2-0
pins.
The three least significant bits of the CONTROL
REGISTER (EEPROM SELECT, RELOAD and
STORE) are used to control the EEPROM. Their
values are not stored nor loaded from the
EEPROM.
b)
GENERAL
PURPOSE
REGISTER
-
EEPROM SELECT bit = 1
On EEPROM read operations (after setting
RELOAD high) the EEPROM word address
defined by the POINTER REGISTER 6 least
significant bits is read into the GENERAL
PURPOSE REGISTER.
On EEPROM write operations (after setting the
STORE bit) the value of the
GENERAL
PURPOSE
REGISTER
is
written
at
the
EEPROM
word
address
defined
by
the
POINTER REGISTER 6 least significant bits.
RELOAD and STORE are set by the user to
initiate read and write operations respectively.
Polling the value until read low is used to
determine completion.
When an EEPROM
access is in progress the STORE and RELOAD
bits of CTR will readback as both bits high. No
other bits of the LAN91C94 can be read or
written until the EEPROM operation completes
and both bits are clear. This mechanism is also
valid for reset initiated reloads.
Note: If no
EEPROM is connected to the LAN91C94, for
example for some embedded applications, the
ENEEP
pin
should
be
grounded
and
no
accesses to the EEPROM will be attempted.
Configuration, Base, and Individual Address
assume their default values upon hardware
reset
and
the
CPU
is
responsible
for
programming them for their final value.
DIAGNOSTIC LEDs
The following LED drive signals are available for
diagnostic and installation aid purposes:
nTXLED - Activated by transmit activity.
nBSELED - Board select LED. Activated when
the board space is accessed, namely on
accesses to the LAN91C94 register space or the
ROM area decoded by the LAN91C94. The
signal is stretched to 125 msec.
nRXLED - Activated by receive activity.
nLINKLED - Reflects the link integrity status.
ARBITRATION CONSIDERATIONS
The arbiter exploits the sequential nature of the
CPU accesses to provide a very fast access
time.
Memory bandwidth considerations will
have an effect on the CPU cycle time but no
effect on access time.
For normal 8 MHz, 10 MHz and 12.5 MHz ISA
buses as well as EISA normal cycles the
LAN91C94 can be accessed without negating
ready.
When write operations occur, the data is written
into a FIFO.
The CPU cycle can complete
immediately, and the buffered data will be
written
into
memory
later.
The
memory
arbitration request is generated as a function of
that FIFO being not empty. The nature of the
cycle requested (byte/word) is determined by the
lsb of the pointer and the number of bytes in the
FIFO.
When read operations occur, words are pre-
fetched upon pointer loading in order to have at
least a word ready in the FIFO to be read. New
pre-fetch cycles are requested as a function of
the number of bytes in the FIFO.
相關PDF資料 |
PDF描述 |
|---|---|
| 92_TNC-50-0-4/111_NE | BOARD TERMINATED, FEMALE, TNC CONNECTOR, SURFACE MOUNT, JACK |
| 92_TNC-50-0-4/111_NM | BOARD TERMINATED, FEMALE, TNC CONNECTOR, SURFACE MOUNT, JACK |
| 92082-314 | 14 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT |
| 92082-316 | 16 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT |
| 92082-318 | 18 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 91CCC3 | 制造商:Wirepro 功能描述:Connector Accessories Cap and Chain For Receptacle |
| 91-CCC3 | 制造商:CDM ELECTRONIC FORMERLY WPI 功能描述:connector accessory,circular microphone,cap and chain for receptacle |
| 91-CCC-3 | 制造商:Amphenol Corporation 功能描述: 制造商:TE Connectivity 功能描述: |
| 91CR10 | 制造商:TT Electronics / BI Technologies 功能描述:Res Cermet Trimmer 10 Ohm 20% 1/2W 1(Elec)/1(Mech)Turn (9.53 X 9.78 X 7.11mm) Pin Thru-Hole Box |
| 91CR100 | 功能描述:微調電阻 - 通孔 3/8inch 100 Thumbwheel RoHS:否 制造商:Vishay/Sfernice 產品:Trimmer Resistors - Multi Turn 產品類型:Multiturn 轉數:14 錐度:Linear 電阻:10 kOhms 電壓額定值:250 V 端接類型:Pin 功率額定值:250 mW (1/4 W) 容差:10 % 溫度系數:100 PPM / C |
發布緊急采購，3分鐘左右您將得到回復。