參數資料
型號: ADV7330
廠商: Analog Devices, Inc.
英文描述: Multiformat 11-Bit Triple DAC Video Encoder
中文描述: 多格式11位DAC的視頻編碼器三
文件頁數: 44/76頁
文件大?。?/td> 1378K
代理商: ADV7330
REV. B
–44–
ADV7330
FREQUENCY (MHz)
M
0.5
0.6
0.7
0.8
0.9
1.0
1.1
1.2
1.3
1.4
1.5
FILTER A RESPONSE (Gain Ka)
FREQUENCY (MHz)
M
0.5
0.6
0.7
0.8
0.9
1.0
1.1
1.2
1.3
1.4
1.5
FILTER B RESPONSE (Gain Kb)
FREQUENCY (MHz)
M
1.0
1.1
1.2
1.3
1.4
1.5
1.6
0
2
4
6
8
10
12
INPUT
SIGNAL:
STEP
FREQUENCY RESPONSE IN SHARPNESS
FILTER MODE WITH Ka = 3 AND Kb = 7
SHARPNESS AND ADAPTIVE FILTER CONTROL BLOCK
Figure 34. Sharpness and Adaptive Filter Control Block
HD SHARPNESS FILTER CONTROL AND ADAPTIVE
FILTER CONTROL
[Subaddress 20h, 38h–3Dh]
There are three filter modes available on the ADV7330: sharp-
ness filter mode and two adaptive filter modes.
HD Sharpness Filter Mode
To enhance or attenuate the Y signal in the frequency ranges
shown in the figures below, the following register settings must
be used: HD sharpness filter must be enabled and HD adaptive
filter enable must be set to disabled.
To select one of the 256 individual responses, the according gain
values for each filter, which range from –8 to +7 , must be pro-
grammed into the HD sharpness filter gain register at Address 20h.
HD Adaptive Filter Mode
The HD adaptive filter threshold A, B, C registers, the HD
adaptive filter gain 1, 2, 3 registers, and the HD sharpness filter
gain register are used in Adaptive Filter mode. To activate the
adaptive filter control, HD sharpness filter must be enabled and
HD adaptive filter gain must be enabled.
The derivative of the incoming signal is compared to the three
programmable threshold values: HD adaptive filter threshold
A, B, C. The recommended threshold range is from 16–235,
although any value in the range of 0–255 can be used.
The edges can then be attenuated with the settings in HD adaptive
filter gain 1, 2, 3 registers and HD sharpness filter gain register.
According to the settings of the HD adaptive filter mode con-
trol, there are two Adaptive Filter modes available:
1. Mode A is used when adaptive filter mode is set to 0. In this
case, Filter B (LPF) will be used in the adaptive filter block.
Also, only the programmed values for Gain B in the HD
sharpness filter gain, HD adaptive filter gain 1, 2, 3 are
applied when needed. The Gain A values are fixed and cannot
be changed.
2. Mode B is used when adaptive filter gain is set to 1. In this
mode a cascade of Filter A and Filter B is used. Both settings
for Gain A and Gain B in the HD sharpness filter gain,
HD adaptive filter gain 1, 2, 3 become active when needed.
相關PDF資料
PDF描述
ADV7330KST Multiformat 11-Bit Triple DAC Video Encoder
ADXL321 Small and Thin 18 g Accelerometer
ADXL321EB Small and Thin 18 g Accelerometer
ADXL321JCP Small and Thin 18 g Accelerometer
ADXL321JCP-REEL Small and Thin 18 g Accelerometer
相關代理商/技術參數
參數描述
ADV73305502 制造商:LG Corporation 功能描述:FRAME ASSEMBLY
ADV73306701 制造商:LG Corporation 功能描述:Frame Assembly
ADV73306702 制造商:LG Corporation 功能描述:Frame Assembly
ADV73306703 制造商:LG Corporation 功能描述:Frame Assembly
ADV73306704 制造商:LG Corporation 功能描述:Frame Assembly