參數資料
型號： MJ80C31U-36:D
廠商： ATMEL CORP
元件分類： 微控制器/微處理器
英文描述： MICROCONTROLLER
文件頁數： 2/101頁
文件大小： 3398K
33
8168C-MCU Wireless-02/10
AT86RF212
5.1.2.4 PLL_ON – PLL State
Entering the PLL_ON state from TRX_OFF state enables the analog voltage regulator
(AVREG) first, unless the AVREG is already switched on (register 0x0C,
TRX_OFF_AVDD_EN). After the voltage regulator has been settled (see Table 5-2), the
PLL frequency synthesizer is enabled. When the PLL has been settled at the receive
frequency to a channel defined by register bits CHANNEL (register 0x08,
PHY_CC_CCA), CC_NUMBER (register 0x013, CC_CTRL_0), and CC_BAND (register
0x014, CC_CTRL_1), a successful PLL lock is indicated by issuing an interrupt IRQ_0
(PLL_LOCK).
After the RX_ON command is issued in PLL_ON state, register bits TRX_STATUS
(register 0x01, TRX_STATUS) immediately indicate the radio being in RX_ON state.
However, frame reception can only start, once the PLL has locked.
The PLL_ON state corresponds to the TX_ON state in IEEE 802.15.4.
5.1.2.5 RX_ON and BUSY_RX – RX Listen and Receive State
The AT86RF212 receive mode is internally separated into RX_ON state and BUSY_RX
state. There is no difference between these states with respect to the analog radio
transceiver circuitry, which is always turned on. In both states the receiver and the PLL
frequency synthesizer are enabled.
During RX_ON state, the receiver listens for incoming frames. After detecting a valid
synchronization header (SHR), the AT86RF212 automatically enters the BUSY_RX
state. The reception of a non-zero PHR field generates an IRQ_2 (RX_START) if
enabled.
During PSDU reception, the frame data are stored continuously in the Frame Buffer
until the last byte was received. The completion of the frame reception is indicated by
an interrupt IRQ_3 (TRX_END) and the radio transceiver returns to state RX_ON. At
the same time, the register bit RX_CRC_VALID (register 0x06, PHY_RSSI) is updated
with the result of the FCS check (see section 6.3).
Received frames are passed to the address match filter, refer to section 6.2. If the
content of the MAC addressing fields (refer to IEEE 802.15.4-2006, section 7.2.1) of a
frame matches to the expected addresses, which is further dependent on the
addressing mode, an address match interrupt IRQ_5 (AMI) is issued. The expected
address values are to be stored in registers 0x20 – 0x2B (Short address, PAN ID, and
IEEE address). Frame filtering is available in Basic and Extended Operating Mode,
refer to section 6.2.
Leaving state RX_ON is only possible by writing a state change command to register
bits TRX_CMD in register 0x02 (TRX_STATE).
5.1.2.6 RX_ON_NOCLK – RX Listen State without CLKM
If the radio transceiver is listening for an incoming frame and the microcontroller is not
running an application, the microcontroller may be powered down to decrease the total
system power consumption. This specific power-down scenario – for systems running in
clock synchronous mode (see section 4) – is supported by the AT86RF212 using the
state RX_ON_NOCLK.
This state can only be entered by setting pin 11 (SLP_TR) = H while the radio
transceiver is in RX_ON state. Pin 17 (CLKM) is disabled 35 clock cycles after the rising
edge at the SLP_TR pin, see Figure 4-16. This allows the microcontroller to complete
its power-down sequence.
相關PDF資料
PDF描述
R80C52XXX-12SHXXX 8-BIT, MROM, 12 MHz, MICROCONTROLLER, CQCC44
MQ80C32-12SBR 8-BIT, 12 MHz, MICROCONTROLLER, CQFP44
IF180C52XXX-36D 8-BIT, MROM, 36 MHz, MICROCONTROLLER, PQFP44
IV80C32XXX-36 8-BIT, 36 MHz, MICROCONTROLLER, PQFP44
IF180C52CXXX-20R 8-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP44
相關代理商/技術參數
參數描述
MJ-80C32E-30 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Rad. Tolerant 8-bit ROMless Microcontroller
MJ-80C32E-30-E 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:Rad. Tolerant 8-bit ROMless Microcontroller
MJ8100 制造商:ASI 功能描述:8100 N11E4C
MJ8100R 制造商:SEME-LAB 制造商全稱:Seme LAB 功能描述:Bipolar PNP Device in a Hermetically sealed TO39
MJ-82-1 制造商:SPC Multicomp 功能描述:SOCKET PCB DC POWER 制造商:SPC Multicomp 功能描述:SOCKET, PCB, DC POWER 制造商:SPC Multicomp 功能描述:SOCKET, PCB, DC POWER; Gender:Receptacle; Connector Mounting:PCB; Contact Termination:Through Hole Vertical; Connector Mounting Orientation:PCB; Connector Type:Standard Power Entry ;RoHS Compliant: Yes
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*