- 您現在的位置：買賣IC網 > PDF目錄371134 > MPC755BRX300LE (MOTOROLA INC) RISC Microprocessor Hardware Specifications PDF資料下載
參數資料
| 型號： | MPC755BRX300LE |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | RISC Microprocessor Hardware Specifications |
| 中文描述： | 32-BIT, 300 MHz, RISC PROCESSOR, CBGA360 |
| 封裝： | 25 X 25 MM, CERAMIC, BGA-360 |
| 文件頁數： | 39/56頁 |
| 文件大?。?/td> | 1652K |
| 代理商： | MPC755BRX300LE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁當前第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁
MPC755 RISC Microprocessor Hardware Specifications, Rev. 6.1
Freescale Semiconductor
39
System Design Information
Figure 21
shows the PLL power supply filter circuit.
Figure 21. PLL Power Supply Filter Circuit
8.3
Decoupling Recommendations
Due to the MPC755 dynamic power management feature, large address and data buses, and high operating
frequencies, the MPC755 can generate transient power surges and high frequency noise in its power supply,
especially while driving large capacitive loads. This noise must be prevented from reaching other components in the
MPC755 system, and the MPC755 itself requires a clean, tightly regulated source of power. Therefore, it is
recommended that the system designer place at least one decoupling capacitor at each V
DD
, OV
DD
, and L2OV
DD
pin of the MPC755. It is also recommended that these decoupling capacitors receive their power from separate V
DD
,
(L2)OV
DD
, and GND power planes in the PCB, utilizing short traces to minimize inductance.
These capacitors should have a value of 0.01 or 0.1 μF. Only ceramic SMT (surface mount technology) capacitors
should be used to minimize lead inductance, preferably 0508 or 0603 orientations where connections are made along
the length of the part.
In addition, it is recommended that there be several bulk storage capacitors distributed around the PCB, feeding the
V
DD
, L2OV
DD
, and OV
DD
planes, to enable quick recharging of the smaller chip capacitors. These bulk capacitors
should have a low ESR (equivalent series resistance) rating to ensure the quick response time necessary. They should
also be connected to the power and ground planes through two vias to minimize inductance. Suggested bulk
capacitors:100–330 μF (AVX TPS tantalum or Sanyo OSCON).
8.4
Connection Recommendations
To ensure reliable operation, it is highly recommended to connect unused inputs to an appropriate signal level
through a resistor. Unused active low inputs should be tied to OV
DD
. Unused active high inputs should be connected
to GND. All NC (no connect) signals must remain unconnected.
Power and ground connections must be made to all external V
DD
, OV
DD
, L2OV
DD
, and GND pins of the MPC755.
Note that power must be supplied to L2OV
DD
even if the L2 interface of the MPC755 will not be used; it is
recommended to connect L2OV
DD
to OV
DD
and L2VSEL to BVSEL if the L2 interface is unused. (This
requirement does not apply to the MPC745 since it has neither an L2 interface nor L2OV
DD
pins.)
8.5
Output Buffer DC Impedance
The MPC755 60x and L2 I/O drivers are characterized over process, voltage, and temperature. To measure Z
0
, an
external resistor is connected from the chip pad to (L2)OV
DD
or GND. Then, the value of each resistor is varied
until the pad voltage is (L2)OV
DD
/2 (see
Figure 22
).
The output impedance is the average of two components, the resistances of the pull-up and pull-down devices. When
data is held low, SW2 is closed (SW1 is open), and R
N
is trimmed until the voltage at the pad equals (L2)OV
DD
/2.
V
DD
AV
DD
(or L2AV
DD
)
10
2.2 μF
2.2 μF
GND
Low ESL Surface Mount Capacitors
相關PDF資料 |
PDF描述 |
|---|---|
| MPC755BPX300LE | RISC Microprocessor Hardware Specifications |
| MPC8240EC | Integrated Processor Hardware Specifications |
| MPC8240 | 32-Bit Microprocessor(32位微處理器) |
| MPC8260ACZU | MPC826xA (HiP4) Family Hardware Specifications |
| MPC8260CZU | MPC826xA (HiP4) Family Hardware Specifications |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPC755BRX350LE | 功能描述:微處理器 - MPU 360CBGA,RV2.8,HIP4DP RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC755BRX350TE | 功能描述:微處理器 - MPU 360CBGA,RV2.8,HIP4DP RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC755BVT300LE | 功能描述:微處理器 - MPU RV2.8106C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC755BVT350LE | 功能描述:微處理器 - MPU RV2.8,106C RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
| MPC755CPX350LE | 功能描述:微處理器 - MPU 360PBGA,RV2.8,6W RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324 |
發布緊急采購，3分鐘左右您將得到回復。