Revision 1.1
31
www.national.com
G
Signal Definitions
(Continued)
2.2
Several balls are read at power-up that set up the state of
the SC1100. These balls are typically multiplexed with
other functions that are outputs after the power-up
sequence is complete. The SC1100 must read the state of
the balls at power-up and the internal PU or PD resistors
do not guarantee the correct state will be read. Therefore, it
is required that an external PU or PD resistor with a value
STRAP OPTIONS
of 1.5 K
be placed on the balls listed in Table 2-4. The
value of the resistor is important to ensure that the proper
state is read during the power-up sequence. If the ball is
not read correctly at power-up, the SC1100 may default to
a state that causes it to function improperly, possibly result-
ing in application failure.
Table 2-4. Strap Options
Strap Option
Muxed With
Ball #
Nominal
Internal
PU or PD
External PU/PD Strap Settings
Register References
Strap = 0 (PD)
Strap = 1 (PU)
CLKSEL0
RD#
D23
PD
100
PD
100
PD
100
PD
100
See Section 2.4.1 on page 36 for CLK-
SEL strap options.
GCB+I/O Offset 1Eh[9:8] (RO):
Value programmed at reset by
CLKSEL[1:0].
GCB+I/O Offset 10h[3:0] (RO):
Value programmed at reset by
CLKSEL[3:0].
GCB+I/O Offset 1Eh[3:0] (R/W, but
write not recommended): Value pro-
grammed at reset by CLKSEL[3:0].
Note:
Values for GCB+I/O Offset
10h[3:0] and 1Eh[3:0] are not the
same.
GCB+I/O Offset 34h[3] (RO): Reads
back strap setting.
GCB+I/O Offset 34h[14] (R/W):
Used to allow the ROMCS# width to
be changed under program control.
GCB+I/O Offset 34h[30] (MCR[30])
(RO): Reads back strap setting.
Note:
For normal operation, strap
this signal low using a 1.5 K
resistor.
This strap signal, when pulled high,
sets bit F0BAR1+I/O Offset 10h[15],
LPC ROM Addressing Enable.
CLKSEL1
GNT1#
AD25
CLKSEL2
SDATA_OUT
AD22
CLKSEL3
SYNC
AE22
BOOT16
ROMCS#
C23
PD
100
Enable boot from
8-bit ROM
Enable boot from
16-bit ROM
FPCI_MON
PCICLKO
AB25
PD
100
Disable Fast-PCI,
INTR_O, and
SMI_O monitor-
ing signals.
Enable Fast-PCI,
INTR_O, and
SMI_O monitor-
ing signals. (Use-
ful during debug.)
LPC_ROM
GNT0#
AB26
PD
100
Disable LPC
ROM boot
Enable boot from
LPC ROM device
Note:
Accuracy of internal PU/PD resistors: 80K to 250K.
Location of the GCB (General Configuration Block) cannot be determined by software. See the
SC1100 Information Appliance On
a Chip device errata
document.