- 您現在的位置：買賣IC網 > PDF目錄373540 > T9000 ISDN Network Termination Node (NTN) Device PDF資料下載
參數資料
| 型號： | T9000 |
| 英文描述： | ISDN Network Termination Node (NTN) Device |
| 中文描述： | ISDN網絡終端節點（新界北）設備 |
| 文件頁數： | 54/126頁 |
| 文件大小： | 2127K |
| 代理商： | T9000 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁當前第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁
54
Lucent Technologies Inc.
Preliminary Data Sheet
November 2000
ISDN Network Termination Node (NTN) Device
T9000
9 HDLC with FIFO Module
(continued)
9.3 HDLC Receiver
Downstream D channel is always transferred to the
HDLC receiver. The HDLC receiver removes flags,
does zero bit deletion, and calculates the FCS for the
downstream D-channel information. Deframed data is
converted from serial to parallel (byte delimited) and
passed to the microcontroller through the receiver
FIFO HRX register.
9.3.1 HDLC Receiver Initialization
On powerup, the HDLC receiver is initialized automati-
cally. After powerup, whenever there is any change to
the HRCF[DROPCRC], HRCF[RXMODE],
HRCF[BAE], or HSM0[BAP(7:0)] configuration bits, the
bit HRCF[RX_INIT] must be set to 1 to reinitialize the
HDLC receiver. Once the initialization is completed, the
HRCF[RX_INIT] bit automatically returns to 0.
During initialization, register bit HRCF[DROPCRC] is
sampled. If it is one (the default), the FCS will be
dropped (not stored in the receiver FIFO). If
HRCF[DROPCRC] = 0, the complete deframed packet,
including its FCS, will be stored in the receiver FIFO.
If the device is programmed for address matching, then
prior to storing a packet in the receiver FIFO, its
address is checked against a set of patterns (see Sec-
tion 9.4, Address Recognition). Only packets with an
address field matching one of the programmed
address values are transferred to the receiver FIFO, all
others are rejected. At the end of a frame, a status byte
is transferred to the HDLC receiver FIFO that provides
information about the following events: frame-overrun,
frame-complete, frame-error, and frame-abort.
Figure 10 shows the structure of the status byte. Each
bit is set to one when the corresponding condition is
active.
Bit 7 (OVR).
The overrun bit indicates that the frame
has been closed by a receive FIFO overrun condition
(see section 9.3.1.1 Overrun Condition ).
Bit 6 (EOF).
The end of frame bit indicates that the
packet has been properly terminated with a closing
flag.
Bit 5 (FERR).
The FCS error bit indicates that the
results of comparing the incoming FCS with internally
calculated FCS on the received data (according to the
ITU CRC-16 polynomial) did not match.
Bit 4 (FABRT).
The frame abort bit indicates that the
frame has been closed with an abort pattern
(01111111).
Bits 2—0 (CBIT).
The check error bit provides an extra
error check. In most HDLC based protocols, the packet
length is an exact multiple number of bytes. When this
is the case, CBIT = 111. Otherwise, CBIT
≠
111.
The above definitions for the status bits imply that cor-
rectly received frames will have 47h as the status byte.
Bit 3 is reserved and is set to 0.
Figure 10. HDLC Receiver Status Word
Multiple packets may be stored in the receiver FIFO at
a given time. The HRDA[NBNSW] register bits indicate
the number of bytes until the next status word in the
FIFO. If there are no status words in the FIFO, it indi-
cates the number of bytes of an unfinished packet cur-
rently stored into the FIFO.
Packets less than 2 bytes in length (4 bytes if
HRCF[DROPCRC] = 1) are automatically rejected.
7
6
5
4
3
—
2:0
CBIT
OVR
EOF
FERR
FABRT
相關PDF資料 |
PDF描述 |
|---|---|
| T9021 | TELECOMMUNICATIONS PRODUCTS |
| T9030 | TELECOMMUNICATIONS PRODUCTS |
| T90FJR | Dual Common Interface Hardware Controller- CIMax |
| T919N | PHASE CONTROL THYRISTORS |
| T9790U | CMOS 1 CHIP LSI FOR LCD ELECTRONIC CALCULATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| T9001 | 功能描述:罩類、盒類及殼類產品 15x14x3-1/2(3.13cf) 1 Compartment RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| T9006 | 功能描述:罩類、盒類及殼類產品 15 x 14 x 3-1/2 (2.96cf) RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| T9007 | 功能描述:罩類、盒類及殼類產品 13 1/8 x 13 1/8 x 3" 6 COMPARTMENTS RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
| T9008 | 制造商:Nortools International Ltd 功能描述:HSS METRIC DIE SET,M3-M12 |
| T900BK | 功能描述:罩類、盒類及殼類產品 of Box Dividers Clear RoHS:否 制造商:Bud Industries 產品:Boxes 外部深度:6.35 mm 外部寬度:6.35 mm 外部高度:2.56 mm NEMA 額定值: IP 等級: 材料:Acrylonitrile Butadiene Styrene (ABS) 顏色:Red |
發布緊急采購，3分鐘左右您將得到回復。