Intel
82801BA ICH2 Datasheet
9-9
LPC Interface Bridge Registers (D31:F0)
9.1.17
SERIRQ_CNTL—Serial IRQ Control (LPC I/F—D31:F0)
Offset Address:
Default Value:
Lockable:
64h
10h
No
Attribute:
Size:
Power Well:
R/W
8-bit
Core
9.1.18
PIRQ[n]_ROUT—PIRQ[E,F,G,H] Routing Control
(LPC I/F—D31:F0)
Offset Address:
PIRQE–68h, PIRQF–69h,
PIRQG–6Ah, PIRQH–6Bh
80h
No
Attribute:
R/W
Default Value:
Lockable:
Size:
Power Well:
8-bit
Core
Bit
Description
7
Serial IRQ Enable (SIRQEN)
—R/W.
1 = Serial IRQs will be recognized. The SERIRQ pin will be configured as SERIRQ.
0 = The buffer is input only and internally SERIRQ will be a 1.
6
Serial IRQ Mode Select (SIRQMD)
—R/W. For systems using Quiet Mode, this bit should be set to 1
(Continuous Mode) for at least one frame after coming out of reset before switching back to Quiet
Mode. Failure to do so will result in the ICH2 not recognizing SERIRQ interrupts.
1 = The serial IRQ machine will be in continuous mode.
0 = The serial IRQ machine will be in quiet mode.
5:2
Serial IRQ Frame Size (SIRQSZ)
—R/W.
Fixed field that indicates the size of the SERIRQ frame. In
the ICH2, this field needs to be programmed to 21 frames (0100). This is an offset from a base of 17
which is the smallest data frame size.
1:0
Start Frame Pulse Width (SFPW)
—R/W.
This is the number of PCI clocks that the SERIRQ pin will
be driven low by the serial IRQ machine to signal a start frame. In continuous mode, the ICH2 will
drive the start frame for the number of clocks specified. In quiet mode, the ICH2 will drive the start
frame for the number of clocks specified minus one, as the first clock was driven by the peripheral.
00 = 4 clocks
01 = 6 clocks
10 = 8 clocks
11 = Reserved
Bit
Description
7
Interrupt Routing Enable (IRQEN)
—R/W. Note that BIOS must program this bit to “0” during POST
for any of the PIRQs that are being used. The value of this bit may subsequently be changed by the
OS when setting up for I/O APIC interrupt delivery mode.
0 = The corresponding PIRQ is routed to one of the ISA-compatible interrupts specified in bits[3:0].
1 = The PIRQ is not routed to the 8259.
6:4
Reserved.
3:0
IRQ Routing
—R/W.
(ISA compatible)
0000 = Reserved
0001 = Reserved
0010 = Reserved
0011 = IRQ3
0100 = IRQ4
0101 = IRQ5
0110 = IRQ6
0111 = IRQ7
1000 = Reserved
1001 = IRQ9
1010 = IRQ10
1011 = IRQ11
1100 = IRQ12
1101 = Reserved
1110 = IRQ14
1111 = IRQ15
Powered by ICminer.com Electronic-Library Service CopyRight 2003