Intel
82801BA ICH2 Datasheet
7-19
LAN Controller Registers (B1:D8:F0)
7.2.10
Power Management Driver (PMDR) Register
Offset Address:
Default Value:
1Bh
00h
Attribute:
Size:
R/WC
8 bits
The ICH2’s internal LAN Controller provides an indication in the PMDR that a wake-up event has
occurred.
7.2.11
General Control Register
Offset Address:
Default Value:
1Ch
00h
Attribute:
Size:
R/W
8 bits
Bit
Description
7
Link Status Change Indication—
R/WC.
1 = The link status change bit is set following a change in link status.
0 = Software clears this bit by writing a 1 to the bit location.
6
Magic Packet—
R/WC.
1 = This bit is set when a Magic Packet is received regardless of the Magic Packet wake-up disable
bit in the configuration command and the PME Enable bit in the Power Management Control/
Status Register.
0 = Software clears this bit by writing a 1 to the bit location.
5
Interesting Packet—
R/WC.
1 = This bit is set when an “interesting” packet is received. Interesting packets are defined by the
LAN Controller packet filters.
0 = Software clears this bit by writing a 1 to the bit location.
4:1
Reserved.
0
PME Status—
R/WC.
This bit is a reflection of the PME Status bit in the Power Management
Control/Status Register (PMCSR).
1 = Set upon a wake-up event, independent of the PME Enable bit.
0 = Software clears this bit by writing a 1 to the bit location. This also clears the PME Status bit in
the PMCSR and deasserts the PME signal.
Bit
Description
7:4
Reserved. These bits should be set to 0000b.
3
LAN Connect Software Reset—
R/W.
1 = Software can set this bit to force a reset condition on the LAN Connect interface.
0 = Cleared by software to begin normal LAN Connect operating mode. Software must not attempt
to access the LAN Connect interface for at least 1 ms after clearing this bit.
2
Reserved. This bit should be set to 0.
1
Deep Power-Down on Link Down Enable.
1 = Enable. The ICH2’s internal LAN Controller may enter a deep power-down state (sub 3 mA) in
the D2 and D3 power states while the link is down. In this state, the LAN Controller does not
keep link integrity. This state is not supported for point-to-point connection of two end stations.
0 = Disable
0
Reserved.
Powered by ICminer.com Electronic-Library Service CopyRight 2003