- 您現在的位置：買賣IC網 > PDF目錄366891 > CR16HCT5VJE9Y Microcontroller PDF資料下載
參數資料
| 型號： | CR16HCT5VJE9Y |
| 英文描述： | Microcontroller |
| 中文描述： | 微控制器 |
| 文件頁數： | 59/157頁 |
| 文件大?。?/td> | 1256K |
| 代理商： | CR16HCT5VJE9Y |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁當前第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁
59
www.national.com
16.1.1
Each timer subsystem may be configured to generate two
fully independent PWM waveforms on the respective TIOx
pins. In this mode, the counter COUNTx is split and operates
as two independent 8-bit counters. Each counter increments
at the rate determined by the clock prescaler.
Each of the two 8-bit counters may be started and stopped
separately via the associated TxRUN bits. Once either of the
two 8-bit timers is running the clock prescaler starts counting.
Once the clock prescaler counter value matches the value of
the associated CxPRSC register field, COUNTx is incre-
mented.
Dual 8-bit PWM Mode
The period of the PWM output waveform is determined by
the value of the PERCAPx register. The TIOx output starts at
the default value as pro-grammed via the IOxCTL.PxPOL bit.
Once the counter value reaches the value of the period reg-
ister PERCAPx, the counter is reset to 00
16
upon the next
counter increment. Upon the following increment from 00
16
to 01
16
, the TIOx output will change to the opposite of the de-
fault value.
The duty cycle of the PWM output waveform is controlled by
the DTYCAPx register value. Once the counter value reach-
es the value of the duty cycle register DTYCAPx, the PWM
output TIOx changes back to its default value upon the next
counter increment. Figure 19 illustrates this concept.
The period time is determined by the following formula:
PWMperiod = (PERCAPx + 1) * (CxPRSC + 1) * T
CLK
The duty cycle in percent is calculated as follows:
DutyCycle[%] = (DTYCAPx / (PERCAPx+1)) *100
If the duty cycle register (DTYCAPx) holds a value which is
greater then the value held in the period register (PERCAPx)
the TIOx output will remain at the opposite of its default value
which corresponds to a duty cycle of 100%. If the duty cycle
register (DTYCAPx) register holds a value of 00
16
, the TIOx
output will remain at the default value which corresponds to
a duty cycle of 0%. In that case the value contained in the
PERCAPx register is irrelevant. This scheme allows the duty
cycle to be programmed in a range from 0% to 100%.
In order to allow fully synchronized updates of the period and
duty cycle compare values, the PERCAPx and DTYCAPx
registers are double buffered when operating in PWM mode.
Therefore if the user writes to either the period or duty cycle
register while either of the two PWM channels is enabled, the
new value will not take effect until the counter value matches
the previous period value or the timer is stopped.
Reading the PERCAPx or DTYCAPx register will always re-
turn the most recent value written to it.
The counter registers can be written if both 8-bit counters are
stopped. This allows the user to preset the counters before
starting and therefore generate PWM output waveforms with
a phase shift relative to one another. If the counter is written
with a value other then 00
16
it will start incrementing from that
value while TIOx remains at its default value until the first
00
16
to 01
16
transition of the counter value occurs. If the
counter is preset to values which are smaller or equal then
the value held in the period register (PERCAPx) the counter
will count up until a match between the counter value and the
PERCAPx register value occurs. The counter will then be re-
set to 00
16
and continue counting up. Alternatively the
counter may be written with a value which is greater then the
00
COUNTx
PERCAPx
DTYCAPx
TIOx (PxPOL=0)
TIOx (PxPOL=1)
TxRUN=1
01
00
01
02
03
04
05
06
07
08
09
0A
02
03
04
05
06
07
08
09
0A
Figure 19.
VTU PWM generation
相關PDF資料 |
PDF描述 |
|---|---|
| CR16HCT9 | |
| CR16HCT9VJE7 | Microcontroller |
| CR16HCT9VJE7Y | Microcontroller |
| CR16HCT9VJE8 | Microcontroller |
| CR16HCT9VJE8Y | Microcontroller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CR16HCT5VJEXY | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:CR16MCT9/CR16MCT5/CR16HCT9/CR16HCT5 16-Bit Reprogrammable/ROM Microcontroller |
| CR16HCT9 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:CR16MCT9/CR16MCT5/CR16HCT9/CR16HCT5 16-Bit Reprogrammable/ROM Microcontroller |
| CR16HCT9VJE7 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
| CR16HCT9VJE7Y | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
| CR16HCT9VJE8 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。