參數資料
型號: IS43R16160A-6T
廠商: INTEGRATED SILICON SOLUTION INC
元件分類: DRAM
英文描述: 16Meg x 16 256-MBIT DDR SDRAM
中文描述: 16M X 16 DDR DRAM, 0.7 ns, PDSO66
封裝: PLASTIC, TSOP2-66
文件頁數: 37/56頁
文件大?。?/td> 792K
代理商: IS43R16160A-6T
Integrated Silicon Solution, Inc. — 1-800-379-4774
Rev. 00B
11/28/05
37
ISSI
IS43R16160A
NOTES: (continued)
23. The refresh period 64ms. This equates to an average refresh rate of 7.8μs.
24. The I/O capacitance per DQS and DQ byte/group will not differ by more than this maximum amount for any
given device.
25. The valid data window is derived by achieving other specifications -
t
HP (
t
CK/2),
t
DQSQ, and
t
QH
(
t
QH =
t
HP -
t
QHS). The data valid window derates directly proportional with the clock duty cycle and a practical data
valid window can be derived. The clock is allowed a maximum duty cycle variation of 45/55. Functionality is uncertain
when operating beyond a 45/55 ratio. The data valid window derating curves are provided below for duty cycles rang-
ing between 50/50 and 45/55.
26. Referenced to each output group: x16 = LDQS with DQ0-DQ7; and UDQS with DQ8-DQ15.
27. This limit is actually a nominal value and does not result in a fail value. CKE is HIGH during REFRESH command
period (
t
RFC [MIN]) else CKE is LOW (i.e., during standby).
28. To maintain a valid level, the transitioning edge of the input must:
a) Sustain a constant slew rate from the current AC level through to the target AC level, VIL(AC) or VIH(AC).
b) Reach at least the target AC level.
c) After the AC target level is reached, continue to maintain at least the target DC level, VIL(DC) or VIH(DC).
29. The Input capacitance per pin group will not differ by more than this maximum amount for any given device..
30. CK and CK input slew rate must be > 1V/ns.
31. DQ and DM input slew rates must not deviate from DQS by more than 10%. If the DQ/DM/DQS slew rate is less
than 0.5V/ns, timing must be derated: 50ps must be added to
t
DS and
t
DH for each 100mv/ns reduction in slew rate.
If slew rate exceeds 4V/ns, functionality is uncertain.
32. VDD must not vary more than 4% if CKE is not active while any bank is active.
相關PDF資料
PDF描述
IS43R16160A 16Meg x 16 256-MBIT DDR SDRAM
IS43R16320A 32Meg x 16 512-MBIT DDR SDRAM
IS43R16320A-6TL 32Meg x 16 512-MBIT DDR SDRAM
IS43R16800A-6 8Meg x 16 128-MBIT DDR SDRAM
IS43R16800A-6T 8Meg x 16 128-MBIT DDR SDRAM
相關代理商/技術參數
參數描述
IS43R16160B 制造商:ISSI 制造商全稱:Integrated Silicon Solution, Inc 功能描述:32Mx8, 16Mx16 256Mb DDR Synchronous DRAM
IS43R16160B-5BI 制造商:ISSI 制造商全稱:Integrated Silicon Solution, Inc 功能描述:32Mx8, 16Mx16 256Mb DDR Synchronous DRAM
IS43R16160B-5BL 功能描述:動態隨機存取存儲器 256M (16Mx16) 400MHz DDR 2.5v RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS43R16160B-5BLI 功能描述:動態隨機存取存儲器 256M (16Mx16) 400MHz DDR 2.5v RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube
IS43R16160B-5BLI-TR 功能描述:動態隨機存取存儲器 256M (16Mx16) 400MHz DDR 2.5v RoHS:否 制造商:ISSI 數據總線寬度:16 bit 組織:1 M x 16 封裝 / 箱體:SOJ-42 存儲容量:16 MB 最大時鐘頻率: 訪問時間:50 ns 電源電壓-最大:7 V 電源電壓-最小:- 1 V 最大工作電流:90 mA 最大工作溫度:+ 85 C 封裝:Tube