- 您現在的位置：買賣IC網 > PDF目錄1908 > COP8CCR9KMT8 (National Semiconductor)IC MCU EEPROM 8BIT 32K 56-TSSOP PDF資料下載
參數資料
| 型號： | COP8CCR9KMT8 |
| 廠商： | National Semiconductor |
| 文件頁數： | 28/111頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MCU EEPROM 8BIT 32K 56-TSSOP |
| 標準包裝： | 34 |
| 系列： | COP8™ 8C |
| 核心處理器： | COP8 |
| 芯體尺寸： | 8-位 |
| 速度： | 20MHz |
| 連通性： | Microwire/Plus（SPI），UART/USART |
| 外圍設備： | 欠壓檢測/復位，POR，PWM，WDT |
| 輸入/輸出數： | 49 |
| 程序存儲器容量： | 32KB（32K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 1K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2.7 V ~ 5.5 V |
| 數據轉換器： | A/D 16x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 56-TFSOP（0.240"，6.10mm 寬） |
| 包裝： | 管件 |
| 其它名稱： | *COP8CCR9KMT8 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁
SNOS535I – OCTOBER 2000 – REVISED MARCH 2013
The data memory consists of 1024 bytes of RAM. Sixteen bytes of RAM are mapped as “registers” at
addresses 0F0 to 0FF Hex. These registers can be loaded immediately, and also decremented and tested
with the DRSZ (decrement register and skip if zero) instruction. The memory pointer registers X, SP, B
and S are memory mapped into this space at address locations 0FC to 0FF Hex respectively, with the
other registers being available for general usage.
The instruction set permits any bit in memory to be set, reset or tested. All I/O and registers (except A and
PC) are memory mapped; therefore, I/O bits and register bits can be directly and individually set, reset
and tested. The accumulator (A) bits can also be directly and individually tested.
Note: RAM contents are undefined upon power-up.
5.4
DATA MEMORY SEGMENT RAM EXTENSION
Data memory address 0FF is used as a memory mapped location for the Data Segment Address Register
(S).
The data store memory is either addressed directly by a single byte address within the instruction, or
indirectly relative to the reference of the B, X, or SP pointers (each contains a single-byte address). This
single-byte address allows an addressing range of 256 locations from 00 to FF hex. The upper bit of this
single-byte address divides the data store memory into two separate sections as outlined previously. With
the exception of the RAM register memory from address locations 00F0 to 00FF, all RAM memory is
memory mapped with the upper bit of the single-byte address being equal to zero. This allows the upper
bit of the single-byte address to determine whether or not the base address range (from 0000 to 00FF) is
extended. If this upper bit equals one (representing address range 0080 to 00FF), then address extension
does not take place. Alternatively, if this upper bit equals zero, then the data segment extension register S
is used to extend the base address range (from 0000 to 007F) from XX00 to XX7F, where XX represents
the 8 bits from the S register. Thus the 128-byte data segment extensions are located from addresses
0100 to 017F for data segment 1, 0200 to 027F for data segment 2, etc., up to FF00 to FF7F for data
segment 255. The base address range from 0000 to 007F represents data segment 0.
Figure 5-1 illustrates how the S register data memory extension is used in extending the lower half of the
base address range (00 to 7F hex) into 256 data segments of 128 bytes each, with a total addressing
range of 32 kbytes from XX00 to XX7F. This organization allows a total of 256 data segments of 128 bytes
each with an additional upper base segment of 128 bytes. Furthermore, all addressing modes are
available for all data segments. The S register must be changed under program control to move from one
data segment (128 bytes) to another. However, the upper base segment (containing the 16 memory
registers, I/O registers, control registers, etc.) is always available regardless of the contents of the S
register, since the upper base segment (address range 0080 to 00FF) is independent of data segment
extension.
The instructions that utilize the stack pointer (SP) always reference the stack as part of the base segment
(Segment 0), regardless of the contents of the S register. The S register is not changed by these
instructions. Consequently, the stack (used with subroutine linkage and interrupts) is always located in the
base segment. The stack pointer will be initialized to point at data memory location 006F as a result of
reset.
The 128 bytes of RAM contained in the base segment are split between the lower and upper base
segments. The first 112 bytes of RAM are resident from address 0000 to 006F in the lower base segment,
while the remaining 16 bytes of RAM represent the 16 data memory registers located at addresses 00F0
to 00FF of the upper base segment. No RAM is located at the upper sixteen addresses (0070 to 007F) of
the lower base segment.
Additional RAM beyond these initial 128 bytes, however, will always be memory mapped in groups of 128
bytes (or less) at the data segment address extensions (XX00 to XX7F) of the lower base segment. The
additional 892 bytes of RAM in this device are memory mapped at address locations 0100 to 017F
through 0700 to 077F hex.
Copyright 2000–2013, Texas Instruments Incorporated
Functional Description
23
相關PDF資料 |
PDF描述 |
|---|---|
| COP8SAA716M8/NOPB | IC MCU OTP 8BIT 1K 16-SOIC |
| CP2101-GMR | IC CTRLR BRIDGE USB-UART 28MLP |
| CP2103-GMR | IC CTRLR BRIDGE USB-UART 28MLP |
| CP2104-F03-GM | IC SGL USB-TO-UART BRIDGE 24QFN |
| CP2105-F01-GM | IC SGL USB-DL UART BRIDGE 24QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| COP8CCR9LVA7 | 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| COP8CCR9LVA7/63 | 制造商:Texas Instruments 功能描述: |
| COP8CCR9LVA7/63SN | 功能描述:閃存 RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| COP8CCR9LVA7/NOPB | 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| COP8CCR9LVA763SN | 制造商:National Semiconductor 功能描述:MCU 8-bit COP8 CISC 32KB Flash 5V 68-Pin PLCC |
發布緊急采購，3分鐘左右您將得到回復。