參數資料
型號: COP8CCR9KMT8
廠商: National Semiconductor
文件頁數: 56/111頁
文件大?。?/td> 0K
描述: IC MCU EEPROM 8BIT 32K 56-TSSOP
標準包裝: 34
系列: COP8™ 8C
核心處理器: COP8
芯體尺寸: 8-位
速度: 20MHz
連通性: Microwire/Plus(SPI),UART/USART
外圍設備: 欠壓檢測/復位,POR,PWM,WDT
輸入/輸出數: 49
程序存儲器容量: 32KB(32K x 8)
程序存儲器類型: 閃存
RAM 容量: 1K x 8
電壓 - 電源 (Vcc/Vdd): 2.7 V ~ 5.5 V
數據轉換器: A/D 16x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 56-TFSOP(0.240",6.10mm 寬)
包裝: 管件
其它名稱: *COP8CCR9KMT8
SNOS535I – OCTOBER 2000 – REVISED MARCH 2013
Figure 5-13. Diagram of Power Save Modes
5.12.1 POWER SAVE MODE CONTROL REGISTER
The ITMR control register allows for navigation between the three different modes of operation. It is also
used for the Idle Timer. The register bit assignments are shown below. This register is cleared to 40 (hex)
by Reset as shown below.
LSON
HSON
DCEN
CCK
RSVD
ITSEL2
ITSEL1
ITSEL0
SEL
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
LSON:
This bit is used to turn-on the low-speed oscillator. When LSON = 0, the low speed oscillator
is off. When LSON = 1, the low speed oscillator is on. There is a startup time associated with
this oscillator. See the Control Registers section.
HSON:
This bit is used to turn-on the high speed oscillator. When HSON = 0, the high speed
oscillator is off. When HSON = 1, the high speed oscillator is on. There is a startup time
associated with this oscillator. See the startup time table in the Control Registers section.
DCEN:
This bit selects the clock source for the Idle Timer. If this bit = 0, then the high speed clock is
the clock source for the Idle Timer. If this bit = 1, then the low speed clock is the clock
source for the Idle Timer. The low speed oscillator must be started and stabilized before
setting this bit to a 1.
CCKSEL:
This bit selects whether the high speed clock or low speed clock is gated to the
microcontroller core. When this bit = 0, the Core clock will be the high speed clock. When
this bit = 1, then the Core clock will be the low speed clock. Before switching this bit to either
state, the appropriate clock should be turned on and stabilized.
DCEN
CCKSEL
0
High Speed Mode. Core and Idle Timer Clock = High Speed
1
0
Dual Clock Mode. Core clock = High Speed; Idle Timer = Low Speed
1
Low Speed Mode. Core and Idle Timer Clock = Low Speed
0
1
Invalid. If this is detected, the Low Speed Mode will be forced.
RSVD:
This bit is reserved and must be 0.
Bits 2–0:
These are bits used to control the Idle Timer. See TIMER T0 (IDLE TIMER) for the
Copyright 2000–2013, Texas Instruments Incorporated
Functional Description
49
Product Folder Links: COP8CBR9 COP8CCR9 COP8CDR9
相關PDF資料
PDF描述
COP8SAA716M8/NOPB IC MCU OTP 8BIT 1K 16-SOIC
CP2101-GMR IC CTRLR BRIDGE USB-UART 28MLP
CP2103-GMR IC CTRLR BRIDGE USB-UART 28MLP
CP2104-F03-GM IC SGL USB-TO-UART BRIDGE 24QFN
CP2105-F01-GM IC SGL USB-DL UART BRIDGE 24QFN
相關代理商/技術參數
參數描述
COP8CCR9LVA7 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
COP8CCR9LVA7/63 制造商:Texas Instruments 功能描述:
COP8CCR9LVA7/63SN 功能描述:閃存 RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel
COP8CCR9LVA7/NOPB 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
COP8CCR9LVA763SN 制造商:National Semiconductor 功能描述:MCU 8-bit COP8 CISC 32KB Flash 5V 68-Pin PLCC