參數資料
型號: EWIXP460AC
廠商: INTEL CORP
元件分類: 微控制器/微處理器
英文描述: 400 MHz, RISC PROCESSOR, PBGA544
封裝: LEAD FREE, PLASTIC, BGA-544
文件頁數: 82/163頁
文件大?。?/td> 1123K
代理商: EWIXP460AC
Functional Overview
Intel IXP45X and Intel IXP46X Product Line of Network Processors Datasheet
May 2005
Document Number: 306261-002
25
In order to limit double-bit errors from occurring, periodically reading the entire usable memory
array will allow the hardware unit within the memory controller to correct any single-bit, ECC
errors that may have occurred prior to these errors becoming double-bit ECC errors. Using this
method is system-dependent.
It is important to note as well, that when sub-word writes (byte writes or half-word writes) to a
32-bit memory with ECC enabled, the memory controller will implement read-modify writes.
Implementing read-modify writes is important to understand when understanding performance
implications when writing software.
To understand a read-modify write, understanding that a byte to be written falls within a 32-bit
word which is addressed on a word-aligned boundary. When a byte write is requested, the memory
controller will read the 32-bit word which encompasses the byte that is to be written. The memory
controller will then modify the specified byte, calculate a new ECC, and then write the entire 32-bit
word back into the memory location it was read from.
The value written back into the memory location will contain the 32-bit word with the modified
byte and the new ECC value.
The MCU supports two banks of DDR SDRAM. The MCU has support for unbuffered DDRI 266
only.
Table 4 illustrates the supported DDR SDRAM configurations for the IXP45X/IXP46X network
processors. The 128/256/512-Mbit, 1-Gbit DDRI SDRAM devices comprise four internal leaves.
The MCU controls the leaf selects within 128/256/512-Mbit, 1-Gbit DDRI SDRAM by toggling
DDRI_BA[0] and DDRI_BA[1].
The two DDR SDRAM chip enables (DDRI_CS[1:0]#) support a DDRI SDRAM memory
subsystem consisting of two banks. The base address for the two contiguous banks are
programmed in the DDR SDRAM Base Register (SDBR) and must be aligned to a 32-Mbyte
boundary. The size of each DDR SDRAM bank is programmed with the DDR SDRAM boundary
registers (SBR0 and SBR1).
Table 4.
Supported DDRI Memory Configurations (Sheet 1 of 2)
DDRI SDRAM
Technology
DDRI SDRAM
Arrangement
# Banks
Address Size
Leaf Select
Total
Memory
Size1
Page
Size2
Row
Col
DDRI_BA[1]
DDRI_BA[0]
128 Mbit
16M x 8
1
12
10
I_AD[26]
I_AD[25]
64 Mbyte
4K
2
128 Mbyte
4K
8M x 16
1
12
9
I_AD[25]
I_AD[24]
32 Mbyte
2K
2
64 Mbyte
2K
256 Mbit
32M x 8
1
13
10
I_AD[27]
I_AD[26]
128 Mbyte
4K
2
256 Mbyte
4K
16M x 16
1
13
9
I_AD[26]
I_AD[25]
64 Mbyte
2K
2
128 Mbyte
2K
NOTES:
1. Table indicates 32-bit-wide memory subsystem sizes
2. Table indicates 32-bit-wide memory page sizes
相關PDF資料
PDF描述
EWIXP455ABT 266 MHz, RISC PROCESSOR, PBGA544
EX5-R-PL 16 CONTACT(S), MALE, COMBINATION LINE CONNECTOR, SOLDER
EXH2E106HR PLASTIC FILM CAPACITORS
EXH2E205HR PLASTIC FILM CAPACITORS
EXH2E255HR PLASTIC FILM CAPACITORS
相關代理商/技術參數
參數描述
EWIXP460BAD 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Intel 功能描述:
EWJKXA066A15 制造商:Panasonic Industrial Company 功能描述:CONTROL
EWK105BJ224MP-F 制造商:TAIYO YUDEN 功能描述:Cut Tape 制造商:Taiyo Yuden 功能描述:Ceramic capacitor LWDC 0402 220nF 制造商:Taiyo Yuden 功能描述:Cap Ceramic 0.22uF 16V X5R 20% SMD 0204 85 制造商:Taiyo Yuden 功能描述:Cap Ceramic 0.22uF 16V X5R 20% SMD 0204 85°C Paper T/R
EWK105BJ224MPHF 功能描述:CAP CER 0.22UF 16V X5R 0204 制造商:taiyo yuden 系列:LWDC?,LW 包裝:剪切帶(CT) 零件狀態:在售 電容:0.22μF 容差:±20% 電壓 - 額定:16V 溫度系數:X5R 工作溫度:-55°C ~ 85°C 特性:低 ESL 型(倒置結構) 等級:AEC-Q200 應用:汽車,旁通,去耦 故障率:- 安裝類型:表面貼裝,MLCC 封裝/外殼:0204(0610 公制) 大小/尺寸:0.020" 長 x 0.039" 寬(0.52mm x 1.00mm) 高度 - 安裝(最大值):- 厚度(最大值):0.014"(0.35mm) 引線間距:- 引線形式:- 標準包裝:1
EWK105C6104MPHF 功能描述:CAP CER 0.10UF 16V X6S 0204 制造商:taiyo yuden 系列:LWDC?,LW 包裝:剪切帶(CT) 零件狀態:在售 電容:0.1μF 容差:±20% 電壓 - 額定:16V 溫度系數:X6S 工作溫度:-55°C ~ 105°C 特性:低 ESL 型(倒置結構) 等級:AEC-Q200 應用:汽車,旁通,去耦 故障率:- 安裝類型:表面貼裝,MLCC 封裝/外殼:0204(0610 公制) 大小/尺寸:0.020" 長 x 0.039" 寬(0.52mm x 1.00mm) 高度 - 安裝(最大值):- 厚度(最大值):0.014"(0.35mm) 引線間距:- 引線形式:- 標準包裝:1