- 您現在的位置：買賣IC網 > PDF目錄45218 > MC68HC05C0FN (MOTOROLA INC) 8-BIT, 4 MHz, MICROCONTROLLER, PQCC44 PDF資料下載
參數資料
| 型號： | MC68HC05C0FN |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, 4 MHz, MICROCONTROLLER, PQCC44 |
| 封裝： | PLASTIC, LCC-44 |
| 文件頁數： | 28/96頁 |
| 文件大?。?/td> | 357K |
| 代理商： | MC68HC05C0FN |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁
Low-Power Modes
MOTOROLA
Page 25
MC68HC05C0 Specification Rev. 1.2
SECTION 6
LOW-POWER MODES
6.1
STOP
The STOP instruction places the MCU in its lowest power consumption mode. In STOP
mode, the internal oscillator is turned off, halting all internal processing, including both
timers (Multi-Function Timer with COP and 16-Bit Timer).
When the CPU enters STOP Mode the interrupt flags (TOF and RTIF) and the interrupt
enable bits (TOFE and RTIE) in the TCSR are cleared by internal hardware to remove any
pending timer interrupt requests and to disable any further timer interrupts. Execution of the
STOP instruction automatically clears the I-bit in the Condition Code Register and sets the
IRQE enable bit in the External Interrupt Control/Status Register so that the IRQ external
interrupt is enabled. All other registers, including the other bits in the TCSR, and memory
remain unaltered. All input/output lines remain unchanged. The processor can be brought
out of the STOP mode only by an external interrupt, KEY interrupt, or RESET.
6.1.1
STOP RECOVERY
A STOP recovery time of 1024 (Fast) or 4064 (Normal) is selectable in the Configuration
Register. The crystal or ceramic resonator must assume stable condition before the
selected stop recovery time elapses, under all possible operating conditions. This will
ensure correct general operation of the 68HC05C0 when STOP mode is exited. See
NOTE:
The contents of the Configuration Register are reset by any of the five
reset conditions. Therefore, if RESET is used to bring the part out of
STOP mode, the STOP recovery will always be 4064 cycles, even if the
fast (1024) recovery time was selected in the Configuration Register.
相關PDF資料 |
PDF描述 |
|---|---|
| MC68HC05C12AFN | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44 |
| MC68HSC05C12AB | 8-BIT, MROM, 4.1 MHz, MICROCONTROLLER, PDIP42 |
| MC68HSC05C12ACP | 8-BIT, MROM, 4.1 MHz, MICROCONTROLLER, PDIP40 |
| MC68HC05C12ACFN | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PQCC44 |
| MC68HSC05C12ACFB | 8-BIT, MROM, 4.1 MHz, MICROCONTROLLER, PQFP44 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HC05C12 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS |
| MC68HC05C12B | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS |
| MC68HC05C12CP | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS |
| MC68HC05C12P | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:HCMOS MICROCONTROLLER UNITS |
| MC68HC05C4 | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:8-Bit Microcomputers |
發布緊急采購，3分鐘左右您將得到回復。