- 您現在的位置：買賣IC網 > PDF目錄383644 > MT90500 (Mitel Networks Corporation) Multi-Channel ATM AAL1 SAR(多通道 ATM AAL1分段及重組設備（基于通訊總線的系統與ATM網絡的接口）) PDF資料下載
參數資料
| 型號： | MT90500 |
| 廠商： | Mitel Networks Corporation |
| 英文描述： | Multi-Channel ATM AAL1 SAR(多通道 ATM AAL1分段及重組設備（基于通訊總線的系統與ATM網絡的接口）) |
| 中文描述： | 多通道自動柜員機AAL1特區（多通道自動柜員機AAL1分段及重組設備（基于通訊總線的系統與空中交通管理網絡的接口）） |
| 文件頁數： | 106/159頁 |
| 文件大?。?/td> | 514K |
| 代理商： | MT90500 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁當前第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁
MT90500
106
Table 61 - Master Clock Generation Control Register
Address: 6090 (Hex)
Label: MCGCR
Reset Value: 00C0 (Hex)
Label
Bit Position
Type
Description
REFSEL
1:0
R/W
REF8KCLK (8 kHz Reference Clock) Selection. See Figure 3 on page 29.
00 -> MCLK/(DIVCLK + 2) or CLKx2/(DIVCLK + 2) (See register 6092h.)
01 -> RXVCLK (recovered ATM VC/SW clock. See register 60A8h.)
10 -> SEC8K input pin
11 -> EX_8KA input pin.
DIVCLK_SRC
2
R/W
Selects input clock for programmable divider (See register 6092h.)
0 -> MCLK
1 -> CLKx2
EX_8KA_SQ
3
R/W
Select squared version of EX_8KA for output.
0 -> Pass EX_8KA signal without changes,
1 -> Convert EX_8KA input to square wave.
This bit, when HIGH, selects the squared version of EX_8KA for routing to the
REF8KCLK, and the SEK8K multiplexers. The squaring logic converts the EX_8KA input
into a square wave (approximately 50% duty-cycle). This can convert a pulse 8 kHz signal
into an 8 kHz square wave, for example. The rising edge of EX_8KA input is passed,
without added jitter, to the REF8KCLK or SEC8K output as a falling edge (i.e. the signal is
inverted); the rising edge at the REF8KCLK output will be 50% duty cycle with jitter equal
to a cycle of MCLK. MCLK must be at least 10 times faster, and at most 16000 times
faster, than EX_8KA. See Figure 3, “TDM Clock Selection and Generation Logic,” on
page 29.
SEC8K_SQ
4
R/W
Enable SEC8K squaring logic.
0 -> Pass SEC8K signal without changes,
1 -> Convert SEC8K input to square wave.
The squaring logic, when enabled, converts the SEC8K input into a square wave
(approximately 50% duty-cycle) before passing it to the REF8KCLK multiplexer. This can
convert a pulse 8 kHz signal into an 8 kHz square wave, for example. When REFSEL =
“10” the rising edge of SEC8K input is passed, without added jitter, to the REF8KCLK
output as a rising edge; the falling edge at the REF8KCLK output will be 50% duty cycle
with jitter equal to a cycle of MCLK. MCLK must be at least 10 times faster, and at most
16000 times faster, than SEC8K.
BEPLL
5
R/W
Clock Generator Multiplexer Selection: selects
CLK16
input clock for the TDM Clock
Generator.
0 -> MCLK
1 -> PLLCLK input.
DIV1...8
7:6
R/W
Clock Generator Division Factor. (“11” at reset)
00 -> 8
01 -> 1
10 -> 2
11 -> 4
Note:
These bits provide the factor by which either MCLK or PLLCLK (as determined by
BEPLL) is divided to provide a 16.384 MHz clock at the Main TDM Bus Clock Generation
Logic.
PHLEN
8
R/W
Clock Generator Phase Lock Enable. When this bit is ‘1’, and TDMFS (in the TDM Bus
Type Register at 6010h) is “00”, the internal FSYNC signal generator will be slaved to the
external FSYNC signal.
This bit allows the MT90500 to be used as a Clock Master Alternate in SCSA mode (i.e.
CLKALT = ‘1’ and CLKMASTER = ‘0’ in TDM Bus Type Register at 6010h). In this case,
the stand-by clock master circuit (using CLK16, the local 16.384 MHz clock derived from
PLLCLK or MCLK) tracks the external FSYNC signal so that when it is selected as a clock
master after a clock failure, the new FSYNC will be almost in phase with the previous one.
The phase-tracking is automatically disabled when the CLKFAIL input pin is
asserted.
SEC8KEN
9
R/W
When ‘1’, the MT90500 drives the SEC8K external signal. When ‘0’, the SEC8K pin is an
input.
SEC8KSEL
10
R/W
SEC8K Clock Source Selection
0 -> EX_8KA
1 -> Internally generated 8 kHz reference (
FS_INT
)
相關PDF資料 |
PDF描述 |
|---|---|
| MT90500 | Multi-Channel ATM AAL1 SAR |
| MT90500AL | Multi-Channel ATM AAL1 SAR |
| MT90502 | Multi-Channel AAL2 SAR(多通道 ATM AAL2分段及重組設備（基于通訊總線的系統與ATM網絡的接口）) |
| MT90732AP | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
| MT90732 | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT90500AL | 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:Multi-Channel ATM AAL1 SAR |
| MT90500AL-ENG1 | 制造商:Mitel Networks Corporation 功能描述: |
| MT90502 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Multi-Channel AAL2 SAR |
| MT90502_06 | 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:Multi-Channel AAL2 SAR |
| MT90502AG | 制造商:Rochester Electronics LLC 功能描述: 制造商:Zarlink Semiconductor Inc 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。