- 您現在的位置：買賣IC網 > PDF目錄25640 > S1C63158D0A010P 4-BIT, FLASH, 4 MHz, MICROCONTROLLER, UUC53 PDF資料下載
參數資料
| 型號： | S1C63158D0A010P |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 4-BIT, FLASH, 4 MHz, MICROCONTROLLER, UUC53 |
| 封裝： | DIE-53 |
| 文件頁數： | 20/159頁 |
| 文件大?。?/td> | 1200K |
| 代理商： | S1C63158D0A010P |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁
108
EPSON
S1C63808 TECHNICAL MANUAL
CHAPTER 4: PERIPHERAL CIRCUITS AND OPERATION (Integer Multiplier)
DRH0–DRH7: Destination register high-order 8 bits (FF84H, FF85H)
Used to set high-order 8 bits of dividends.
Set the low-order 4 bits of data to DRH0–DRH3 and the high-order 4 bits to DRH4–DRH7.
At the start of a multiplication (by writing "0" to FF86HD0), the contents in this register are ignored.
After 10 CPU cycles (5 bus cycles) of multiplication process has finished, the high-order 8 bits of the
product are loaded in this register.
In a division process, data written to this register is loaded to the arithmetic circuit when an operation
starts (by writing "1" to FF86HD0), and then a division is performed in 10 CPU clock cycles (5 bus
cycles). After the operation has finished, the remainder is loaded to this register. However, if an overflow
occurs in a division process, the remainder is not loaded and the high-order 8 bits of the dividend remains.
At initial reset, this register is undefined.
NF: Negative flag (FF86HD3)
Indicates whether the operation result is a positive value or a negative value.
When "1" is read: Negative value (MSB of the results is "1")
When "0" is read: Positive value (MSB of the results is "0")
Writing: Invalid
NF is a read-only bit, so writing operation is invalid.
At initial reset, this flag is set to "0".
VF: Overflow flag (FF86HD2)
Indicates whether an overflow has occurred or not in a division process.
When "1" is read: Overflow occurred
When "0" is read: Overflow has not occurred
Writing: Invalid
When a multiplication process has finished, this flag is always set to "0".
VF is a read-only bit, so writing operation is invalid.
At initial reset, this flag is set to "0".
ZF: Zero flag (FF86HD1)
Indicates whether the operation result is zero or not.
When "1" is read: Zero
When "0" is read: Not zero
Writing: Invalid
ZF is a read-only bit, so writing operation is invalid.
At initial reset, this flag is set to "0".
CALMD: Calculation mode selection register/operation status (FF86HD0)
Selects multiplication or division mode and starts operation.
When "1" is written: Selects/starts division
When "0" is written: Selects/starts multiplication
When "1" is read: Under operating
When "0" is read: Operation has finished
Writing to this register starts the specified operation. After that, this register is set to "1" and returns to "0"
when the multiplication or division process has finished.
At initial reset, this register is reset to "0".
4.12.6 Programming note
An operation process takes 10 CPU clock cycles (5 bus cycles) after writing to the calculation mode
selection register CALMD until the operation result is set to the destination register DRH/DRL and the
operation flags. While this operation is in process, do not read/write from/to the destination register
DRH/DRL and do not read NF/VF/ZF.
相關PDF資料 |
PDF描述 |
|---|---|
| S1C7XXXF00E199 | 16-BIT, 90 MHz, RISC MICROCONTROLLER, PQFP |
| S2041 | PHOTO TRANSISTOR DETECTOR |
| S3P44R10 | TRIGGER OUTPUT SOLID STATE RELAY, 4000 V ISOLATION-MAX |
| S3S12P128J0VQK | 16-BIT, MROM, 1.05 MHz, MICROCONTROLLER, PQFP80 |
| MC9S12P128J0CFTR | 16-BIT, FLASH, 1.05 MHz, MICROCONTROLLER, QCC48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S1C63408 | 制造商:EPSON 制造商全稱:EPSON 功能描述:4-bit Single Chip Microcomputer |
| S1C63557D04Q000 | 制造商:Seiko Instruments Inc (SII) 功能描述:EPSON MCU 4BIT |
| S1C63567 | 制造商:EPSON 制造商全稱:EPSON 功能描述:4-bit Single Chip Microcomputer |
| S1C63616 | 制造商:EPSON 制造商全稱:EPSON 功能描述:4-bit Single Chip Microcomputer |
| S1C63632 | 制造商:EPSON 制造商全稱:EPSON 功能描述:4-bit Single Chip Microcomputer |
發布緊急采購，3分鐘左右您將得到回復。