參數資料
型號: 73M1922-DB
廠商: Maxim Integrated Products
文件頁數: 62/82頁
文件大?。?/td> 0K
描述: BOARD DEMO 73M1922 20-TSSOP
產品培訓模塊: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝: 1
主要目的: *
嵌入式:
已用 IC / 零件: *
主要屬性: *
次要屬性: *
已供物品: 板,CD
DS_1x22_017
73M1822/73M1922 Data Sheet
Rev. 1.6
65
11.5 Trans-Hybrid Cancellation
A Transmit Bit Stream (TBS) emulating a sinusoid of 1 kHz, full scale (code word of +/- 32,767) is applied to
SDIN and the residual signal is measured at SDOUT. Unless stated otherwise, test conditions are: ACZ=00
(600 Ω termination), THEN=1, ATEN=0, DAA=01, TXBST=0. TXM is externally fed back into the Line-Side
Device (73M1912) to effect cancellation of transmit signal.
Table 43: Trans-Hybrid Cancellation
Parameter
Test Condition
Min
Nom
Max
Units
Transmit hybrid
cancellation
Measure RxD in HIC
26
dB
Offset voltage
50% 1’s Density
25
50
mV
AC swing
1kHz sinusoid at Tip and Ring
0.85
0.95
1.05
Vpk
Idle noise
300 Hz – 4 kHz at Tip and Ring
-81
dBm
11.6 Direct Access Arrangement Control Functions
These Transmit Control Registers contain control information to set up the line side of the 73M1x22.
Included are DC-IV characteristics, off-hook control, etc.
Table 44: DAA Control Functions
Function
Mnemonic
Register
Location
Type
Description
OFH
0x12[7]
WO
Off-Hook Enable
This bit controls the state of the Hook signal.
0 = On-Hook. (Default)
1 = Off-Hook.
PLDM
0x13[3]
WO
Pulse Dialing Mode Enable
Alleviates the strict timing requirements for the Host having to control
ENDC and OFH during pulse dialing. With PLDM = 1, the Host only has
to toggle OFH to perform pulse dialing.
0 = Pulse Dialing Mode is disabled. (Default)
1 = Pulse Dialing Mode is enabled.
IDISPD
0x13[1:0]
WO
Discharge and Pulse Dialing
Controls the DC discharge current and how fast the loop turns off. Affects
pulse dialing waveform. Controls the amount of discharge current during
hook switch transitions.
0 = Minimum current. (Default)
1 = Maximum current.
It is recommended to set IDISPD to 1 prior to hook switching operations.
ENNOM
0x12[0]
WO
Enable Nominal Operation
0 = Speeds up the on and off hook transitions time by increasing the DC
loop bandwidth of the DC transconductance circuit in the 73M1x22. This
can be used for pulse dialing. In addition, ENNOM=0 prevents the reset
of all bits in Register 0x12. (Default)
1 = Enter Nominal Operation. Reduces the loop bandwidth of the DC
transconductance circuit. Allows reset of Register 0x12 caused by bits
UVDT, OVDT or OIDT.
相關PDF資料
PDF描述
CM453232-R12KL INDUCTOR 120NH 770MA SMD
73S1217F-EB-LITE BOARD EVAL 73S1217F CBL/DOC/CD
UPT2D221MHD6 CAP ALUM 220UF 200V 20% RADIAL
MAX5391NEVMINIQU+ EVAL KIT MAX5391
GSC08DRTN-S93 CONN EDGECARD 16POS DIP .100 SLD
相關代理商/技術參數
參數描述
73M1966B-DB 功能描述:網絡開發工具 73M1966B Demo Brd RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V
73M1966B-DB-C 功能描述:網絡開發工具 73M1966B Demo Brd w/GUI Cable RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V
73M1966B-EVM 功能描述:網絡開發工具 73M1966 Demo Brd & MotherBrd RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V
73M1966B-IM/F 制造商:Maxim Integrated Products 功能描述:
73M1966B-KEYCHN 功能描述:網絡開發工具 Keychain Eval Module RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V