- 您現(xiàn)在的位置：買賣IC網 > PDF目錄373891 > AD6635BB (ANALOG DEVICES INC) 4-Channel, 80 MSPS WCDMA Receive Signal Processor (RSP) PDF資料下載
參數資料
| 型號： | AD6635BB |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 無繩電話/電話 |
| 英文描述： | 4-Channel, 80 MSPS WCDMA Receive Signal Processor (RSP) |
| 中文描述： | TELECOM, CELLULAR, BASEBAND CIRCUIT, PBGA324 |
| 封裝： | 19 X 19 MM, PLASTIC, BGA-324 |
| 文件頁數： | 32/60頁 |
| 文件大?。?/td> | 799K |
| 代理商： | AD6635BB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
REV. 0
–32–
AD6635
INTERPOLATING HALF-BAND FILTERS
The AD6635 has four interpolating half-band FIR filters that
immediately precede the four digital AGCs and immediately
follow the RCF channel outputs. Each interpolating half-band
takes I and Q data from the preceding RCF and outputs I and
Q data to the AGC. The half-band filters and AGC operate
independently of each other, so the AGC can be bypassed, in
which case the output of the half-band filter is sent directly to
the output data port. The half-band filters also operate indepen-
dently of each other––any one can be enabled or disabled using
the Half-Band Control registers.
Half-band filters also perform the function of interleaving data
from various RCF channel outputs prior to the actual function
of interpolation. This interleaving of data is allowed even when
the actual function of the half-band filter is bypassed. This
feature allows for the usage of multiple channels (implementing
a polyphase filter) on the AD6635 to process a single carrier.
Either RCF phase decimation or a start holdoff counter for the
channels is used to appropriately phase the channels. For example,
if two channels of AD6635 are used to process one cdma2000
carrier, RCF filters for both channels should be 180
∞
out of
phase. This can be done using RCF phase decimation or an
appropriate start holdoff counter followed by appropriate NCO
phase offsets.
Half-band filter A can listen to either Channels 0 to 3, Channels
0 and 1, or only Channel 0. Half-band filter B can listen to
Channels 2 and 3 or to only Channel 2. Each half-band filter
interleaves the channels specified in its control register. The
interleaved data so combined is interpolated by 2. The inter-
leaving function can be used independently of the interpolating
function, in which case the half-band filter is bypassed using the
Half-Band Control registers. When the half-band filter is bypassed,
the interleaving function is still performed. For one channel
running at twice the chip rate, the half-band can be used to
output channel data at 4
￥
the chip rate.
In Figure 31, the frequency response of the interpolating half-band
FIR filter is shown in the graph with respect to the chip rate.
FREQUENCY IN MULTIPLES OF CHIP RATE
0
0
1.0
2.0
3.0
3.5
4.0
A
d
–20
–40
–60
–70
–80
0.5
1.5
2.5
–10
–30
–50
f
SAMP
f
CHIP
Figure 31. Interpolating Half-Band Filter
Frequency Response
The SNR of the interpolating half-band filter is approximately
149.6 dB. The highest error spurs due to fixed-point arithmetic
are around –172.9 dB. The coefficients of the 13-tap interpolat-
ing half-band FIR filter are given in the Table VII.
Table VII. Half-Band Coefficients
0
14
0
–66
0
309
512
309
0
–66
0
14
0
AUTOMATIC GAIN CONTROL
The AD6635 is equipped with four independent automatic gain
control (AGC) loops for direct interface with a RAKE receiver.
Each AGC circuit has 96 dB of range. It is important that the
decimating filters of the AD6635 preceding the AGC reject
undesired signals so that each AGC loop is operating on only
the carrier of interest, and carriers at other frequencies do not
affect the ranging of the loop.
The AGC compresses the 23-bit complex output from the inter-
polating half-band filter into a programmable word size of 4–8,
10, 12, or 16 bits. Since the small signals from the lower bits are
pushed into higher bits by adding gain, the clipping of the lower
bits does not compromise the SNR of the signal of interest. The
AGC maintains a constant mean power on the output despite
the level of the signal of interest, allowing operation in environ-
ments where the dynamic range of the signal exceeds the
dynamic range of the output resolution.
The AGC and the interpolation filters are not tied together, and
any one or both of them can be selected without the other. The
AGC section can be bypassed if desired by setting Bit 0 of the
AGC control word. When bypassed, the I/Q data is passed to
the output port after clipping to 16-bit I/Q data.
There are three sources of error introduced by the AGC func-
tion: underflow, overflow, and modulation. Underflow is caused
by truncation of bits below the output range. Overflow is caused
by clipping errors when the output signal exceeds the output
range. Modulation error occurs when the output gain varies
during the reception of a data.
The desired signal level should be set based on the probability
density function of the signal so that the errors due to underflow
and overflow are balanced. The gain and damping values of the
loop filter should be set so that the AGC is fast enough to track
long term amplitude variations of the signal that might cause exces-
sive underflow or overflow, but slow enough to avoid excessive loss
of amplitude information due to the modulation of the signal.
相關PDF資料 |
PDF描述 |
|---|---|
| AD6636 | 150 MSPS Wideband Digital Down-Converter (DDC) |
| AD6636BBCZ1 | 150 MSPS Wideband Digital Down-Converter (DDC) |
| AD6636BC | 150 MSPS Wideband Digital Down-Converter (DDC) |
| AD6636CBCZ1 | 150 MSPS Wideband Digital Down-Converter (DDC) |
| AD6636PCB | 150 MSPS Wideband Digital Down-Converter (DDC) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD6635BB/PCB | 制造商:Analog Devices 功能描述:Evaluation Kit For 4-Channel, 80MSPS WCDMA Receive Signal Processor |
| AD6635BBZ | 制造商:Analog Devices 功能描述:Receive Signal Processor 324-Pin BGA |
| AD6636 | 制造商:AD 制造商全稱:Analog Devices 功能描述:150 MSPS Wideband Digital Down-Converter (DDC) |
| AD6636BBC | 制造商:Analog Devices 功能描述:Digital Down Converter 256-Pin CSP-BGA |
| AD6636BBCZ | 功能描述:IC DIGITAL DWNCONV 6CH 256CSPBGA RoHS:是 類別:RF/IF 和 RFID >> RF 混頻器 系列:AD6636 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:100 系列:- RF 型:W-CDMA 頻率:2.11GHz ~ 2.17GHz 混頻器數目:1 增益:17dB 噪音數據:2.2dB 次要屬性:- 電流 - 電源:11.7mA 電源電壓:2.7 V ~ 3.3 V 包裝:托盤 封裝/外殼:12-VFQFN 裸露焊盤 供應商設備封裝:12-QFN-EP（3x3） |
發(fā)布緊急采購，3分鐘左右您將得到回復。