- 您現在的位置：買賣IC網 > PDF目錄1908 > CP2200-GQ (Silicon Laboratories Inc)IC ETH CTRLR SNGL-CHIP 48TQFP PDF資料下載
參數資料
| 型號： | CP2200-GQ |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 42/108頁 |
| 文件大小： | 0K |
| 描述： | IC ETH CTRLR SNGL-CHIP 48TQFP |
| 標準包裝： | 250 |
| 控制器類型： | 以太網控制器，MAC/10Base-T |
| 接口： | 并行/串行 |
| 電源電壓： | 3.1 V ~ 3.6 V |
| 電流 - 電源： | 75mA |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-TQFP |
| 供應商設備封裝： | 48-TQFP（7x7） |
| 包裝： | 托盤 |
| 產品目錄頁面： | 627 (CN2011-ZH PDF) |
| 配用： | 336-1316-ND - KIT EVAL FOR CP2201 ETH CTRLR |
| 其它名稱： | 336-1312 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁當前第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁
CP2200/1
Rev. 1.0
39
9.2. Power-fail
When a power-down transition or power irregularity causes VDD to drop below VRST, the power supply monitor will
drive the /RST pin low and return the CP2200/1 to the reset state. When VDD returns to a level above VRST, the
CP2200/1 will be released from the reset state as shown in Figure 14.
The power supply monitor circuit (VDD Monitor) is enabled and selected as a reset source by hardware following
every power-on reset. To prevent the device from being held in reset when VDD drops below VRST, the VDD Monitor
may be deselected as a reset source (see RSTEN on page 42) and disabled (see VDMCN on page 39). It is
recommended to leave the VDD Monitor enabled and selected as a reset source at all times.
Register 11. VDMCN: VDD Monitor Control Register
9.3. Oscillator-Fail Reset
If the system clock derived from the oscillator fails for any reason after oscillator initialization is complete, the reset
circuitry will drive the /RST pin low and return the CP2200/1 to the reset state. The CP2200/1 will remain in the
reset state for approximately 1 ms then exit the reset state in the same manner as that for the power-on reset.
9.4. External Pin Reset
The external /RST pin provides a means for external circuitry to force the CP2200/1 into a reset state. Asserting the
/RST pin low will cause the CP2200/1 to enter the reset state. It is recommended to provide an external pull-up
and/or decoupling capacitor of the /RST pin to avoid erroneous noise-induced resets. The CP2200/1 will exit the
reset state approximately 4 s after a logic high is detected on /RST.
Bit 7:
VDMEN: VDD Monitor Enable
This bit can be used to disable or enable the VDD Monitor Circuit. Note: The VDD Monitor circuit is
enabled and selected as a reset source following every power-on reset. If the VDD Monitor is
disabled and then reenabled during device operation, it must be allowed to stabilize before it is
selected as a reset source. Selecting the VDD Monitor as a reset source before it has stabilized will
0: VDD Monitor Disabled.
1: VDD Monitor Enabled.
Bit6:
VDDSTAT: VDD Status
This bit indicates the current power supply status (VDD Monitor output).
0: VDD voltage is at or below the VDD Monitor threshold.
1: VDD voltage is above the VDD Monitor threshold.
Bits 5–0: RESERVED. Read = varies; Write = don’t care.
R/W
R
RRR
RR
Reset Value
VDMEN
VDDSTAT Reserved Reserved Reserved Reserved Reserved Reserved 00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
Address:
0x13
相關PDF資料 |
PDF描述 |
|---|---|
| CP80C86-2Z | IC CPU 16BIT 5V 8MHZ 40-PDIP |
| CP82C50A-5Z | IC ASYNC COMM ELEMENT UART 40DIP |
| CP82C89 | IC ARBITER BUS 5V 8MHZ 20-DIP |
| CPC1465D | IC DC TERMINATION 16-SOIC |
| CPC1465M | IC SHDSL/ISDN DC TERM 16MLP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CP2200-GQR | 功能描述:以太網 IC Ethernet Controller RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| CP2201 | 制造商:SILABS 制造商全稱:SILABS 功能描述:SINGLE-CHIP ETHERNET CONTROLLER |
| CP2201EK | 功能描述:以太網開發工具 ETHERNET EVAL KIT RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
| CP2201-GM | 功能描述:以太網 IC Ethernet Controller RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。