- 您現在的位置：買賣IC網 > PDF目錄378045 > PCI6515ZHK (Texas Instruments, Inc.) SINGLE SOCKET CARDBUS CONTROLLER WITH DEDICATED SMART CARD SOCKET PDF資料下載
參數資料
| 型號： | PCI6515ZHK |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | SINGLE SOCKET CARDBUS CONTROLLER WITH DEDICATED SMART CARD SOCKET |
| 中文描述： | 單插槽CardBus控制器，專用智能卡插槽 |
| 文件頁數： | 36/148頁 |
| 文件大?。?/td> | 760K |
| 代理商： | PCI6515ZHK |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁當前第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁
32
Tied for Open Drain
OE
Pad
VCCP
Figure 32. 3-State Bidirectional Buffer
3.3
Clamping Voltages
The clamping voltages are set to match whatever external environment the PCI6515 controller is interfaced with:
3.3 V or 5 V. The I/O sites can be pulled through a clamping diode to a voltage rail that protects the core from external
signals. The core power supply is 1.5 V and is independent of the clamping voltages. For example, PCI signaling can
be either 3.3 V or 5 V, and the PCI6515 controller must reliably accommodate both voltage levels. This is
accomplished by using a 3.3-V I/O buffer that is 5-V tolerant, with the applicable clamping voltage applied. If a system
designer desires a 5-V PCI bus, then V
CCP
can be connected to a 5-V power supply.
3.4
Peripheral Component Interconnect (PCI) Interface
The PCI6515 controller is fully compliant with the
PCI Local Bus Specification
. The PCI6515 controller provides all
required signals for PCI master or slave operation, and may operate in either a 5-V or 3.3-V signaling environment
by connecting the V
CCP
terminals to the desired voltage level. In addition to the mandatory PCI signals, the PCI6515
controller provides the optional interrupt signals INTA, INTB, INTC, and INTD.
3.4.1
Device Resets
During the power-up sequence, GRST and PRST must be asserted. GRST is deasserted a minimum of 2 ms after
V
CC
is stable. PRST is deasserted 100
μ
s after PCLK is stable or any time thereafter.
3.4.2
PCI Bus Lock (LOCK)
The bus-locking protocol defined in the
PCI Local Bus Specification
is not highly recommended, but is provided on
the PCI6515 controller as an additional compatibility feature. The PCI LOCK signal can be routed to the MFUNC4
terminal by setting the appropriate values in bits 1916 of the multifunction routing status register. See Section 4.35,
Multifunction Routing Status Register
,
for details. Note that the use of LOCK is only supported by PCI-to-CardBus
bridges in the downstream direction (away from the processor).
PCI LOCK indicates an atomic operation that may require multiple transactions to complete. When LOCK is asserted,
nonexclusive transactions can proceed to an address that is not currently locked. A grant to start a transaction on
the PCI bus does not assure control of LOCK; control of LOCK is obtained under its own protocol. It is possible for
different initiators to use the PCI bus while a single master retains ownership of LOCK. Note that the CardBus signal
for this protocol is CBLOCK to avoid confusion with the bus clock.
An agent may need to do an exclusive operation because a critical access to memory might be broken into several
transactions, but the master wants exclusive rights to a region of memory. The granularity of the lock is defined by
PCI to be 16 bytes, aligned. The LOCK protocol defined by the
PCI Local Bus Specification
allows a resource lock
without interfering with nonexclusive real-time data transfer, such as video.
The PCI bus arbiter may be designed to support only complete bus locks using the LOCK protocol. In this scenario,
the arbiter does not grant the bus to any other agent (other than the LOCK master) while LOCK is asserted. A
complete bus lock may have a significant impact on the performance of the video. The arbiter that supports complete
bus LOCK must grant the bus to the cache to perform a writeback due to a snoop to a modified line when a locked
operation is in progress.
The PCI6515 controller supports all LOCK protocols associated with PCI-to-PCI bridges, as also defined for
PCI-to-CardBus bridges. This includes disabling write posting while a locked operation is in progress, which can solve
相關PDF資料 |
PDF描述 |
|---|---|
| PCI7610LQFP | PC Card, UltraMedia, and Integrated 1394a-2000 OHCI Two-Port PHY/Link-Layer Controller |
| PCM1712U | Stereo Audio Digital-To-Analog Converter(立體聲音頻D\A轉換器) |
| PCM1715U | Dual Voltage Output CMOS Delta-Sigma Digital-To-Analog Converter With On-Chip Digital Filter(帶片內濾波的雙路電壓輸出CMOS ΔΣD\A轉換器) |
| PCM1726 | Stereo Audio Digital-To-Analog Converter 16 Bits, 96kHz Sampling(16位96kHz采樣率立體聲音頻D\A轉換器) |
| PCM3008T2K | LOW POWER AND LOW VOLTAGE 16-BIT, SINGLE-ENDED ANALOG INPUT/OUTPUT STEREO AUDIO CODEC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PCI6520 | 制造商:PLX 制造商全稱:PLX 功能描述:Transparent FastLane⑩ PCI-X -to- PCI-X Bridge |
| PCI6520-CB13BI | 功能描述:外圍驅動器與原件 - PCI PCIX to PCIX BRIDGE 64bit 133MHz RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| PCI6520-CB13BI G | 功能描述:外圍驅動器與原件 - PCI PCIX to PCIX Bridge 64Bit 133MHz RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| PCI6520-XX13BC | 制造商:PLX 制造商全稱:PLX 功能描述:Transparent FastLane⑩ PCI-X -to- PCI-X Bridge |
| PCI6540 | 制造商:PLX 制造商全稱:PLX 功能描述:Dual-Mode (Transparent & Non-Transparent) Universal FastLane⑩ PCI-X -to- PCI-X Bridge |
發布緊急采購，3分鐘左右您將得到回復。