- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C970 (Advanced Micro Devices, Inc.) PCnetTM-PCI Single-Chip Ethernet Controller for PCI Local Bus PDF資料下載
參數資料
| 型號： | AM79C970 |
| 廠商： | Advanced Micro Devices, Inc. |
| 英文描述： | PCnetTM-PCI Single-Chip Ethernet Controller for PCI Local Bus |
| 中文描述： | PCnetTM - PCI單芯片以太網控制器的PCI總線 |
| 文件頁數： | 125/168頁 |
| 文件大?。?/td> | 943K |
| 代理商： | AM79C970 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁當前第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁
AMD
P R E L I M I N A R Y
1-992
Am79C970
RMD0
Bit
Name
Description
31–0 RBADR
Receive Buffer address. This
field contains the address of the
receive buffer that is associated
with this descriptor.
RMD1
Bit
Name
Description
31
OWN
This bit indicates that the de-
scriptor entry is owned by the
host
(OWN=0)
PCnet-PCI controller (OWN=1).
The PCnet-PCI controller clears
the OWN bit after filling the buffer
pointed to by the descriptor entry.
The host sets the OWN bit after
emptying the buffer. Once the
PCnet-PCI controller or host has
relinquished ownership of a
buffer, it must not change any
field in the descriptor entry.
ERR is the OR of FRAM, OFLO,
CRC, or BUFF. ERR is set by the
PCnet-PCI
controller
cleared by the host.
FRAMING ERROR indicates
that the incoming frame con-
tained a non-integer multiple of
eight bits and there was an FCS
error. If there was no FCS error
on the incoming frame, then
FRAM will not be set even if there
was a non integer multiple of
eight bits in the frame. FRAM is
not valid in internal loopback
mode. FRAM is valid only when
ENP is set and OFLO is not.
FRAM is set by the PCnet-PCI
controller and cleared by the
host.
OVERFLOW error indicates that
the receiver has lost all or part of
the incoming frame, due to an in-
ability to store the frame in a
memory buffer before the inter-
nal FIFO overflowed. OFLO is
valid only when ENP is not set.
OFLO is set by the PCnet-PCI
controller and cleared by the
host.
CRC indicates that the receiver
has detected a CRC (FCS) error
on the incoming frame. CRC is
valid only when ENP is set and
OFLO is not. CRC is set by the
or
by
the
30
ERR
and
29
FRAM
28
OFLO
27
CRC
PCnet-PCI
cleared by the host.
BUFFER ERROR is set any time
the PCnet-PCI controller does
not own the next buffer while data
chaining a received frame. This
can occur in either of two ways:
1. The OWN bit of the next buffer
is ZERO.
controller
and
26
BUFF
2. FIFO overflow occurred before
the PCnet-PCI controller re-
ceived
the
STATUS
(RMD1[31:24]
descriptor).
If a Buffer Error occurs, an Over-
flow Error may also occur inter-
nally in the FIFO, but will not be
reported in the descriptor status
entry unless both BUFF and
OFLO errors occur at the same
time . BUFF is set by the PCnet-
PCI controller and cleared by the
host.
START OF PACKET indicates
that this is the first buffer used by
the PCnet-PCI controller for this
frame. It is used for data chaining
buffers. When SPRINTEN=0
(CSR3, bit 5), STP is set by the
PCnet-PCI
controller
cleared by the host. When
SPRINTEN=1 (CSR3, bit 5), STP
must be set by the host.
END OF PACKET indicates that
this is the last buffer used by the
PCnet-PCI controller for this
frame. It is used for data chaining
buffers. If both STP and ENP are
set, the frame fits into one buffer
and there is no data chaining.
ENP is set by the PCnet-PCI con-
troller and cleared by the host.
Reserved locations. These loca-
tions should be read and written
as ZEROs.
These four bits must be written
as ONES. They are written by the
host and unchanged by the
PCnet-PCI controller.
BUFFER BYTE COUNT is the
length of the buffer pointed to by
this descriptor, expressed as the
two’s complement of the length
of the buffer. This field is written
by the host and unchanged by
the PCnet-PCI controller.
byte
next
of
the
25
STP
and
24
ENP
23–16
RES
15–12 ONES
11–00 BCNT
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C971VCW | PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus |
| AM79C971 | PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus |
| AM79C971KCW | IC LOGIC 16211 24-BIT FET BUS SWITCH -40+85C TSSOP-56 35/TUBE |
| AM79C972BKCW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972BKIW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C970A | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
| AM79C970AKC | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
| AM79C970AKC\\W | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Advanced Micro Devices 功能描述: |
| AM79C970AKC\W | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。